Determination of the complex permittivity of dielectric materials at microwave frequency using rectangular waveguide measurements and Newton-Raphson method

2006 ◽  
Vol 94 (3) ◽  
pp. 227-233 ◽  
Author(s):  
J. Terhzaz ◽  
H. Ammor ◽  
Á. Mediavilla Sánchez ◽  
M. Chaïbi ◽  
A. Mamouni
Keyword(s):  
Complex Permittivity ◽  
Rectangular Waveguide ◽  
Microwave Frequency ◽  
Dielectric Materials ◽  
Newton Raphson ◽  
Raphson Method

Determination of the Force Constants of Non-linear XY2 Molecules in the Gas-Phase by the GF Matrix Method

2004 ◽  
Vol 59 (9) ◽  
pp. 621-622 ◽  
Author(s):  
Fatih Ucun ◽  
Vesile Gūçlü
Keyword(s):  
Gas Phase ◽  
Condensed Phase ◽  
Matrix Method ◽  
Solid Phase ◽  
Force Constants ◽  
Matrix Solution ◽  
The Matrix ◽  
Newton Raphson ◽  
Raphson Method

The force constants of the internal coordinates of nonlinear XY2 molecules in the gas-phase were calculated by using the GF matrix method. The matrix solution was carried out by means a computer program built relative to the Newton-Raphson method and the calculations were listed in a table. The force constants of some molecules in the liquidand solid- phase were also found and compared with these ones, and it was seen that the force constants for more condensed phase are lower as in an agreement with having its lower frequency.

Determination of AGMA Geometry Factor J for Slotted External Spur Gears

1983 ◽  
Vol 105 (3) ◽  
pp. 305-311
Author(s):  
Y. P. Singh
Keyword(s):  
Direct Method ◽  
Mining Industry ◽  
Spur Gears ◽  
Input Output ◽  
Typical Application ◽  
Geometry Factor ◽  
Newton Raphson ◽  
A Direct Method ◽  
Raphson Method

This paper presents a direct method for determining the geometry factor J for slotted external spur gears. The location of maximum stressed point on the tooth profile where the stress parabola is tangent to the fillet curve has been determined by solving the resulting nonlinear equations using the sophisticated Newton-Raphson method. The semi-graphical procedure given in AGMA Standard [1] is not convenient for determining the geometry factory J of large gears used in grinding mill and kiln drives in the mining industry. Listing of the computer program and input-output point out for a typical application are presented.

Sign in / Sign up

Export Citation Format

Share Document