A method to measure the overall gain and point-spread function of an image-plate detector system (converter, phosphor, readout electronics) online from single-crystal diffraction patterns is derived. Only with a knowledge of these quantities can one estimate without bias the true standard deviations of the observed integrated intensities of Bragg reflections measured with such a detector. The gain corrected for the point-spread function should ideally be approximately 1.0 to avoid loss of data or precision due to the upper and lower limits of digitization of the diffraction patterns. The gain and the point-spread function are derived for several configurations of the three neutron Laue image-plate diffractometers, LADI, VIVALDI and LADI-III, at the Institut Laue–Langevin. The detective quantum efficiencies (DQE) of these instruments have been measured to be 0.16 (1), 0.57 (2) and 0.46 (3), respectively. It has also been found that the DQE is effectively constant for different times of exposure, despite the fading of the photostimulated luminescent signal during that time. While the results described in this paper concern neutron detection by image plates, the method is equally valid for other integrating detectors and radiations,e.g.CCD detectors and X-rays.
Advantages of a curved image plate for rapid laboratory-based x-ray total scattering measurements: Application to pair distribution function analysis