Modeling Capacity at Signalized Intersections with a Left-Turn Storage Bay Considering Signal Timing Plan

2019 ◽  
Vol 145 (2) ◽  
pp. 04018084
Author(s):  
Meiqi Liu ◽  
Liang Xu ◽  
Lixiao Shen ◽  
Sheng Jin
Keyword(s):  
Signalized Intersections ◽  
Signal Timing ◽  
Left Turn

Operational Effects of the Consolidated Intersection Design on Urban and Suburban Arterials

2018 ◽  
Vol 2672 (17) ◽  
pp. 96-107
Author(s):  
Daniel J. Cook
Keyword(s):  
Travel Time ◽  
Signalized Intersections ◽  
Signal Timing ◽  
Left Turn ◽  
Vehicle Delay ◽  
Cycle Lengths ◽  
Expected Benefits ◽  
Traffic Signal Timing ◽  
Critical Phases ◽  
Pedestrian Crossing

Along urban and suburban arterials, closely-spaced signalized intersections are commonly used to provide access to adjacent commercial developments. Often, these signalized intersections are designed to provide full access to developments on both sides of the arterial and permit through, left-turn, and right-turn movements from every intersection approach. Traffic signal timing is optimized to reduce vehicle delay or provide progression to vehicles on the arterial, or both. However, meeting both of these criteria can be cumbersome, if not impossible, under high-demand situations. This research proposes a new design that consolidates common movements at three consecutive signalized intersections into strategic fixed locations along the arterial. The consolidation of common movements allows the intersections to cycle between only two critical phases, which, in turn, promotes shorter cycle lengths, lower delay, and better progression. This research tested the consolidated intersection concept by modeling a real-world site in microsimulation software and obtaining values for delay and travel time for multiple vehicle paths along the corridor and adjacent commercial developments in both existing and proposed conditions. With the exception of unsignalized right turns at the periphery of the study area, all non-displaced routes showed a reduction in travel time and delay. Additional research is needed to understand how additional travel through the commercial developments adjacent to the arterial may effect travel time and delay. Other expected benefits of the proposed design include a major reduction in conflict points, shorter pedestrian crossing and wait times, and the opportunity to provide pedestrian refuge areas in the median.

Safety-Based Left-Turn Phasing Decisions for Signalized Intersections

2017 ◽  
Vol 2619 (1) ◽  
pp. 13-19 ◽  
Author(s):  
Kiriakos Amiridis ◽  
Nikiforos Stamatiadis ◽  
Adam Kirk
Keyword(s):  
Urban Areas ◽  
Primary Objective ◽  
Signalized Intersections ◽  
Safety Performance ◽  
Signal Timing ◽  
Left Turn ◽  
Crash Data ◽  
Intersection Safety ◽  
Traffic Volumes

The efficient and safe movement of traffic at signalized intersections is the primary objective of any signal-phasing and signal-timing plan. Accommodation of left turns is more critical because of the higher need for balancing operations and safety. The objective of this study was to develop models to estimate the safety effects of the use of left-turn phasing schemes. The models were based on data from 200 intersections in urban areas in Kentucky. For each intersection, approaches with a left-turn lane were isolated and considered with their opposing through approach to examine the left-turn–related crashes. This combination of movements was considered to be one of the most dangerous in intersection safety. Hourly traffic volumes and crash data were used in the modeling approach, along with the geometry of the intersection. The models allowed for the determination of the most effective type of left-turn signalization that was based on the specific characteristics of an intersection approach. The accompanying nomographs provide an improvement over existing methods and warrants and allow for a systematic and quick evaluation of the left-turn phase to be selected. The models used the most common variables that were already known during the design phase, and they could be used to determine whether a permitted or protected-only phase would suit the intersection when safety performance was considered.

Intersection Operation with Non-Traditional Dynamic Lane Scheme through Vehicle-to-Signal Connection

2019 ◽  
Vol 2673 (8) ◽  
pp. 322-332
Author(s):  
Sida Luo ◽  
Yu (Marco) Nie ◽  
Lin Zhu
Keyword(s):  
Integer Program ◽  
Signalized Intersections ◽  
Mixed Integer ◽  
Mixed Integer Program ◽  
Time Signal ◽  
Signal Timing ◽  
Left Turn ◽  
Intersection Operation ◽  
Lane Utilization ◽  
Near Future

This paper proposes an information-based dynamic lane (IDYL) scheme for signalized intersections with exclusive left-turn phases. Similar to the tandem design, the proposed scheme aims to increase the capacity of an isolated intersection by sorting incoming vehicles based on their turning movements. Its novelty is to guide vehicles of different movements into pre-designated dynamic lanes without stopping them via pre-signal. The assumption is that vehicles themselves or their drivers have access to, and can act on, real-time signal timing information through vehicle-to-signal connection to select the correct lane to enter as they approach the intersection. A mixed integer program is proposed to optimize jointly the lane configuration, timing plan, and dynamic lane utilization for an intersection. Results from numerical and simulation experiments show that IDYL can increase the reserve capacity by more than 25% when implemented on all legs of a standard four-leg intersection, and reduce the delay by around 15% when implemented on two opposing legs. The results from this study could help traffic engineers to operate signalized intersections with dynamic lanes when vehicle-to-signal connection becomes widely available in the near future.

scholarly journals Signal Control Method for through and Left-Turn Shared Lane by Setting Left-Turn Waiting Area at Signalized Intersections

2021 ◽  
Vol 13 (23) ◽  
pp. 13154
Author(s):  
Xiancai Jiang ◽  
Li Yao ◽  
Yao Jin ◽  
Runting Wu
Keyword(s):  
Control Method ◽  
Signalized Intersections ◽  
Signal Control ◽  
Signal Timing ◽  
Left Turn ◽  
Traffic Conflicts ◽  
Vehicle To Infrastructure ◽  
Waiting Area ◽  
Integrated Performance ◽  
Cooperation System

This paper proposes a signal control method for the through and left-turn shared lanes at signalized intersections to solve traffic conflicts between left-turn vehicles and opposing through vehicles by setting left-turn waiting area (LWA). Delays and stops are weighted to form an integrated performance index (PI) in a vehicle-to-infrastructure cooperation system. The PI models pertaining to all vehicles are established based on the LWA intersection. In addition, an optimized method of signal timing parameters is constructed by minimizing the average PI. VISSIM simulation shows that the average PI decreases by 6.51% compared with the original layout and signal timing plan of the intersection, since the increased delay of the side-road left-turn vehicles is insufficient to offset the reduced delay of the side-road through vehicles after the improvement. The sensitivity analysis shows that the greater the traffic volume of the phase including the through and left-turn shared lanes, the higher the operation efficiency of the LWA intersection compared with the typical permitted phase intersection. When the left-turn vehicles of the shared lanes in each cycle are less than the stop spaces, the LWA intersection can effectively reduce the average PI of the shared lanes. Furthermore, the more the stop spaces in the LWA, the lower the average PI in the same traffic conditions.

scholarly journals An Innovative Signal Timing Strategy for Implementing Contraflow Left-Turn Lanes at Signalized Intersections with Split Phasing

2021 ◽  
Vol 13 (11) ◽  
pp. 6307
Author(s):  
Rongwei Guo ◽  
Jinli Liu ◽  
Yi Qi
Keyword(s):  
Traffic Simulation ◽  
Design Procedure ◽  
Signalized Intersections ◽  
Signal Timing ◽  
Current Signal ◽  
Clearance Time ◽  
Left Turn ◽  
Simulation Based ◽  
Time Requirements

Contraflow Left-Turn Lanes (CLLs) have the potential of being a solution for mitigating congestions at signalized intersections where split phasing is recommended or required. However, the current signal timing strategy for the intersections with CLLs cannot be directly applied at the signalized intersections with split phasing (SIWSP). To address this problem, this study proposed an innovative signal timing strategy, which is referred to as Counterclockwise Split Phasing (CSP) signal timing, for implementing the CLLs at the SIWSPs. A traffic simulation-based case study was conducted and the results indicate that, by using the proposed CSP signal timing plan, CLLs can be implemented at the SIWSP and can significantly reduce the traffic congestions caused by the high left-turn demand at this type of intersection. In addition, since the proposed CSP signal timing design procedure has fully considered the clearance time requirements for the left-turn vehicles on the CLLs, the risk associated with the use of CLLs can be controlled which makes it safe to use this innovative intersection design at SIWSPs.

Modeling Capacity of Through Movement at Signalized Intersection Affected by Short Left-Turn Bay under Different Signal Settings

2021 ◽  
pp. 036119812110064
Author(s):  
Zihang Wei ◽  
Yunlong Zhang ◽  
Xiaoyu Guo ◽  
Xin Zhang
Keyword(s):  
Cycle Length ◽  
Signalized Intersections ◽  
Signalized Intersection ◽  
Essential Factor ◽  
Highway Capacity ◽  
Left Turn ◽  
Highway Capacity Manual ◽  
Proposed Model ◽  
Vehicle Demand ◽  
The One

Through movement capacity is an essential factor used to reflect intersection performance, especially for signalized intersections, where a large proportion of vehicle demand is making through movements. Generally, left-turn spillback is considered a key contributor to affect through movement capacity, and blockage to the left-turn bay is known to decrease left-turn capacity. Previous studies have focused primarily on estimating the through movement capacity under a lagging protected only left-turn (lagging POLT) signal setting, as a left-turn spillback is more likely to happen under such a condition. However, previous studies contained assumptions (e.g., omit spillback), or were dedicated to one specific signal setting. Therefore, in this study, through movement capacity models based on probabilistic modeling of spillback and blockage scenarios are established under four different signal settings (i.e., leading protected only left-turn [leading POLT], lagging left-turn, protected plus permitted left-turn, and permitted plus protected left-turn). Through microscopic simulations, the proposed models are validated, and compared with existing capacity models and the one in the Highway Capacity Manual (HCM). The results of the comparisons demonstrate that the proposed models achieved significant advantages over all the other models and obtained high accuracies in all signal settings. Each proposed model for a given signal setting maintains consistent accuracy across various left-turn bay lengths. The proposed models of this study have the potential to serve as useful tools, for practicing transportation engineers, when determining the appropriate length of a left-turn bay with the consideration of spillback and blockage, and the adequate cycle length with a given bay length.

Impact of Turning Lane Storage Length and Turning Proportions on Throughput at Oversaturated Signalized Intersections

2021 ◽  
pp. 036119812110171
Author(s):  
A. M. Tahsin Emtenan ◽  
Christopher M. Day
Keyword(s):  
Flow Rate ◽  
Cycle Length ◽  
Signal Timing ◽  
Real World Data ◽  
Left Turn ◽  
Common Response ◽  
Cycle Lengths ◽  
Saturation Flow Rate ◽  
Saturation Flow ◽  
Timing Strategies

During oversaturated conditions, common objectives of signal timing are to maximize vehicle throughput and manage queues. A common response to increases in vehicle volumes is to increase the cycle length. Because the clearance intervals are displayed less frequently with longer cycle lengths and fewer cycles, more of the total time is used for green indications, which implies that the signal timing is more efficient. However, previous studies have shown that throughput reaches a peak at a moderate cycle length and extending the cycle length beyond this actually decreases the total throughput. Part of the reason for this is that spillback caused by the turning traffic may cause starvation of the through lanes resulting in a reduction of the saturation flow rate within each lane. Gaps created by the turning traffic after a lane change may also reduce the saturation flow rate. There is a relationship between the proportions of turning traffic, the storage length of turning lanes, and the total throughput that can be achieved on an approach for a given cycle length and green time. This study seeks to explore this relationship to yield better signal timing strategies for oversaturated operations. A microsimulation model of an oversaturated left-turn movement with varying storage lengths and turning proportions is used to determine these relationships and establish a mathematical model of throughput as a function of the duration of green, storage length, and turning proportion. The model outcomes are compared against real-world data.

Derivation of Decision Boundaries for Left-Turn Treatments at Signalized Intersections

2017 ◽  
Vol 2620 (1) ◽  
pp. 1-9 ◽  
Author(s):  
Andrew Raessler ◽  
Jidong J. Yang
Keyword(s):  
Decision Making ◽  
Signalized Intersections ◽  
Maintenance Costs ◽  
Left Turn ◽  
Practical Guidelines ◽  
Decision Boundaries ◽  
Boundary Curves ◽  
Benefits And Costs

A new methodology is proposed to establish practical guidelines for four incremental left-turn treatments: ( a) permissive single left-turn lane, ( b) protected–permissive single left-turn lane, ( c) protected dual left-turn lanes with equal lane use, and ( d) protected dual left-turn lanes with unequal lane use. Decision boundaries were derived from the equilibrium at which the delays of two incremental treatments were equal. The benefits and costs associated with different left-turn treatments—including safety impact and construction and maintenance costs—also were considered. These benefits and costs effectually shift the boundary curves for more realistic decision making.

scholarly journals Design of Signal Timing Plan for Urban Signalized Networks including Left Turn Prohibition

2018 ◽  
Vol 2018 ◽  
pp. 1-16 ◽  
Author(s):  
Qinrui Tang ◽  
Bernhard Friedrich
Keyword(s):  
Travel Time ◽  
Treatment Options ◽  
User Equilibrium ◽  
Signal Timing ◽  
Stochastic User Equilibrium ◽  
Left Turn ◽  
Traffic Demand ◽  
Total Travel Time ◽  
Left Turns ◽  
Demand Patterns

Urban road networks may benefit from left turn prohibition at signalized intersections regarding capacity, for particular traffic demand patterns. The objective of this paper is to propose a method for minimizing the total travel time by prohibiting left turns at intersections. With the flows obtained from the stochastic user equilibrium model, we were able to derive the stage generation, stage sequence, cycle length, and the green durations using a stage-based method which can handle the case that stages are sharing movements. The final output is a list of the prohibited left turns in the network and a new signal timing plan for every intersection. The optimal list of prohibited left turns was found using a genetic algorithm, and a combination of several algorithms was employed for the signal timing plan. The results show that left turn prohibition may lead to travel time reduction. Therefore, when designing a signal timing plan, left turn prohibition should be considered on a par with other left turn treatment options.

Sign in / Sign up

Export Citation Format

Share Document