Alignment of Photo-Cross-Linkable Copolymer Liquid Crystals Induced by Linearly Polarized UV Irradiation and Thermal Treatment

Author(s):  
Nobuhiro Kawatsuki ◽  
Masaki Hayashi ◽  
Tohei Yamamoto
2004 ◽  
Vol 59 (7-8) ◽  
pp. 510-516 ◽  
Author(s):  
Ewa Chrzumnicka ◽  
Mirosław Szybowicz ◽  
Danuta Bauman

The orientational behaviour of some liquid crystals with various molecular structures was studied by means of the Raman scattering depolarization method. The Raman scattering spectra of linearly polarized light were recorded as a function of temperature in the nematic phase. On the basis of these spectra the order parameters 〈P2〉 and 〈P4〉 as well as the molecular distribution function were determined. The obtained data were compared with those estimated on the basis of polarized light absorption and emission measurements. The influence of the molecular structure on the orientational order of liquid crystals was discussed.


2015 ◽  
Vol 6 ◽  
pp. 19-26 ◽  
Author(s):  
Yit Lung Khung ◽  
Siti Hawa Ngalim ◽  
Andrea Scaccabarozzi ◽  
Dario Narducci

In this letter, we report results of a hydrosilylation carried out on bifunctional molecules by using two different approaches, namely through thermal treatment and photochemical treatment through UV irradiation. Previously, our group also demonstrated that in a mixed alkyne/alcohol solution, surface coupling is biased towards the formation of Si–O–C linkages instead of Si–C linkages, thus indirectly supporting the kinetic model of hydrogen abstraction from the Si–H surface (Khung, Y. L. et al. Chem. – Eur. J. 2014, 20, 15151–15158). To further examine the probability of this kinetic model we compare the results from reactions with bifunctional alkynes carried out under thermal treatment (<130 °C) and under UV irradiation, respectively. X-ray photoelectron spectroscopy and contact angle measurements showed that under thermal conditions, the Si–H surface predominately reacts to form Si–O–C bonds from ethynylbenzyl alcohol solution while the UV photochemical route ensures that the alcohol-based alkyne may also form Si–C bonds, thus producing a monolayer of mixed linkages. The results suggested the importance of surface radicals as well as the type of terminal group as being essential towards directing the nature of surface linkage.


2014 ◽  
Vol 92 (7/8) ◽  
pp. 832-837
Author(s):  
J. Molina ◽  
C. Zúñiga ◽  
M. Moreno ◽  
W. Calleja ◽  
P. Rosales ◽  
...  

In this work, rutile-phase TiO2 particles (r-TiO2, about 360 nm in size) are embedded within a silicon oxide matrix using different concentration ratios of r-TiO2 with respect to SiO2:H2O, so that suspensions of mixed TiO2:SiO2 oxides were obtained and analyzed. These TiO2:SiO2 suspensions were deposited on previously-cleaned crystalline silicon and quartz substrates so that thin films of TiO2:SiO2 were obtained. All films were then exposed to relatively high-temperature thermal treatments in nitrogen and different characterization techniques were used to determine their physical and electrical properties before and after ultraviolet (UV) irradiation. Before high thermal treatment, X-ray diffraction patterns show that the main diffraction peaks for the obtained TiO2:SiO2 films correspond to the crystalline phase of rutile-TiO2. Infrared analyses before and after thermal treatment show significant changes in the chemical bonding of the final films relative to the temperatures used during annealing. Also, UV–visible spectra provide a constant optical band gap for the films, independent of different TiO2 concentrations as expected. On the other hand, atomic-force microscopy measurements before and after UV irradiation show an appreciable difference in the grain size and surface morphology of the resulting TiO2:SiO2 oxides annealed at 1000 °C. Finally, photoelectrical I–V properties were obtained for all TiO2:SiO2 films by depositing ultrathin titanium stripes on top of the photoactive material and then, measuring the total current flowing through the metal electrode before and after UV irradiation. From these last measurements, a detectable increase in the I–V slope (lower resistance of the titanium stripe) is found for all samples during UV exposure, thus making this device to act as a simple photoresistor based on r-TiO2 particles.


2020 ◽  
Vol 54 (1 (251)) ◽  
pp. 56-60
Author(s):  
H.H. Hovakimyan

In this work we study the propagation of light in a twist-oriented pleochroic nematic liquid crystal with pleochroic dye. The dependence of the intensity of transmitted light on the azimuthal angle of the linearly polarized incoming light has been investigated experimentally. As a result, the role of absorption anisotropy has been identified.


Sign in / Sign up

Export Citation Format

Share Document