Determination of the Mode of Occurrence of As, Cr, and Hg in Three Chinese Coal Samples by Sequential Acid Leaching

2007 ◽  
Vol 29 (14) ◽  
pp. 1327-1336 ◽  
Author(s):  
B. Wang ◽  
W. Li ◽  
G. Wang ◽  
H. Chen ◽  
B. Li
2011 ◽  
Vol 396-398 ◽  
pp. 620-623
Author(s):  
Ya Li Zhang ◽  
Xian Jin Yu ◽  
Xiao Na Guo ◽  
Xiao Bin Li

In this work, it was aimed to select and propose a feasible as well as an applicable method, or series of methods for the extraction of zinc. After determination of the components of the residue, water leaching, acid leaching and roasting-leaching were performed to reclaim Zn. Roasting-leaching was found to be effectively for Zn extraction by controlling acid mass, roasting duration and temperature as parameters. At the optimum conditions, 0.7 times the amount of H2SO4 at 250 °C for 150 min in roasting, 82.05% of initial Zn content was extracted.


2020 ◽  
Vol 15 (2) ◽  
pp. 193-198
Author(s):  
Zhiying Shao ◽  
Mei Xue ◽  
Qin Liu ◽  
Peng Li ◽  
Yong Fang ◽  
...  

2019 ◽  
Vol 322 (3) ◽  
pp. 1351-1356 ◽  
Author(s):  
Grzegorz Szaciłowski ◽  
Jakub Ośko ◽  
Tomasz Pliszczyński

Abstract The elevated concentration of 210Po attached to aerosol particles inside a non-ferrous metal refinery was studied. The aerosols were collected on Petrianov or glass-fiber filters and subsequently subjected to radiochemical procedure consisting of acid leaching and concentration by micro co-precipitation with manganese oxide. For the activity determination alpha spectrometry and liquid scintillation counting (LSC) were applied. The obtained results showed that usually observed polonium concentration inside the plant was lower than 78 mBq m−3, however short spikes up to 7430 ± 710 mBq m−3 (related to the specific thermal process) were also observed.


1986 ◽  
Vol 64 (3) ◽  
pp. 488-491 ◽  
Author(s):  
Jack M. Miller ◽  
Timothy R. B. Jones ◽  
Tina Kenney ◽  
David W. Rupp ◽  
Brian N. Green ◽  
...  

The application of fast atom bombardment (FAB) mass spectrometry to the determination of lead isotope ratios in nineteenth century pottery glazes from the Niagara Peninsula has been investigated with the aim of determining the source of the lead used in the glazes. Methods of sampling have been compared, including direct analysis of glass chips, analysis of powdered glaze scrapings, analysis of acid extracts of the former, and simple acid leaching of the surface of a piece of pottery. The latter method gave the best results. The FAB data, as obtained on an older mass spectrometer, can distinguish lead from igneous vs. sedimentary deposits, but is not adequate to determine specific mining locations. Although newer FAB instrumentation can narrow this range, the overlap of data from the Niagara Peninsula and England precludes a simple answer to the archeological question as to English vs. Canadian origin of the lead used in the Jordan pottery glazes. However, the data do suggest that the potter used a local source for the lead.


1895 ◽  
Vol 57 (340-346) ◽  
pp. 386-394

This memoir embodies the results of a series of investigations which were initiated by the Right Hon. Viscount Cross, sometime H. M. Secretary of State for India, shortly after the annexation of Burma by the British Government. The researches were undertaken with a view to the determination of the value of the celebrated ruby mines of that country, and of the conditions under which the gem is found.


1995 ◽  
Vol 44 (1) ◽  
pp. 19-23 ◽  
Author(s):  
Kazuo WATANABE ◽  
Kyoichiro TAKASHIMA ◽  
Hiroyuki FUKUSHIMA

1975 ◽  
Vol 29 (1) ◽  
pp. 44-48 ◽  
Author(s):  
J. A. Goleb ◽  
C. R. Midkiff

A flameless atomic absorption technique, employing a tantalum strip atomizer, has been developed to determine barium and antimony in gunshot residue. Cotton swabs, wetted with 5% HNO3, are used to collect residue. Barium and antimony are released from the swabs by acid leaching or plasma ashing. Both techniques give good recoveries; the ashing technique is preferred for blood-stained swabs. The sensitivity for barium is 0.1 ng/10 µl and antimony 0.2 ng/10 µl. At nanogram levels the standard relative deviation for barium is 8.3% and for antimony 8.5%.


2003 ◽  
Vol 82 (9) ◽  
pp. 679-685 ◽  
Author(s):  
Dan LIU ◽  
Masateru NISHIOKA ◽  
Masayoshi SADAKATA

Sign in / Sign up

Export Citation Format

Share Document