AlGaInAs quantum dot solar cells: tailoring quantum dots for intermediate band formation

2012 ◽  
Vol 27 (3) ◽  
pp. 032002 ◽  
Author(s):  
C Schneider ◽  
S Kremling ◽  
N V Tarakina ◽  
T Braun ◽  
M Adams ◽  
...  
Nanomaterials ◽  
2021 ◽  
Vol 11 (5) ◽  
pp. 1317
Author(s):  
Asmae El Aouami ◽  
Laura M. Pérez ◽  
Kawtar Feddi ◽  
Mohamed El-Yadri ◽  
Francis Dujardin ◽  
...  

Solar cells that are based on the implementation of quantum dots in the intrinsic region, so-called intermediate band solar cells (IBSCs), are among the most widely used concepts nowadays for achieving high solar conversion efficiency. The principal characteristics of such solar cells relate to their ability to absorb low energy photons to excite electrons through the intermediate band, allowing for conversion efficiency exceeding the limit of Shockley–Queisser. IBSCs are generating considerable interest in terms of performance and environmental friendliness. However, there is still a need for optimizing many parameters that are related to the solar cells, such as the size of quantum dots, their shape, the inter-dot distance, and choosing the right material. To date, most studies have only focused on studying IBSC composed of cubic shape of quantum dots. The main objective of this study is to extend the current knowledge of IBSC. Thus, we analyze the effect of the shape of the quantum dot on the electronic and photonic characteristics of indium nitride and indium gallium nitride multiple quantum dot solar cells structure considering cubic, spherical, and cylindrical quantum dot shapes. The ground state of electrons and holes energy levels in quantum dot are theoretically determined by considering the Schrödinger equation within the effective mass approximation. Thus, the inter and intra band transitions are determined for different dot sizes and different inter dot spacing. Consequently, current–voltage (J-V) characteristic and efficiencies of these devices are evaluated and compared for different shapes. Our calculations show that, under fully concentrated light, for the same volume of different quantum dots (QD) shapes and a well determined In-concentration, the maximum of the photovoltaic conversion efficiencies reaches 63.04%, 62.88%, and 62.43% for cubic, cylindrical, and spherical quantum dot shapes, respectively.


2012 ◽  
pp. 297-316
Author(s):  
Kimberly A. Sablon ◽  
V. Mitin ◽  
J. W. Little ◽  
A. Sergeev ◽  
N. Vagidov

2013 ◽  
Vol 1551 ◽  
pp. 137-142
Author(s):  
Neil S. Beattie ◽  
Guillaume Zoppi ◽  
Ian Farrer ◽  
Patrick See ◽  
Robert W. Miles ◽  
...  

ABSTRACTThe device performance of GaAs p-i-n solar cells containing stacked layers of self-assembled InAs quantum dots is investigated. The solar cells demonstrate enhanced external quantum efficiency below the GaAs band gap relative to a control device without quantum dots. This is attributed to the capture of sub-band gap photons by the quantum dots. Analysis of the current density versus voltage characteristic for the quantum dot solar cell reveals a decrease in the series resistance as the device area is reduce from 0.16 cm2 to 0.01 cm2. This is effect is not observed in control devices and is quantum dot related. Furthermore, low temperature measurements of the open circuit voltage for both quantum dot and control devices provide experimental verification of the conditions required to realise an intermediate band gap solar cell.


2014 ◽  
pp. 406-429
Author(s):  
Yoshitaka Okada ◽  
Katsuhisa Yoshida ◽  
Yasushi Shoji

Advanced concepts for high efficiency solar cells such as hot carrier effects, Multi-Exciton Generation (MEG), and Intermediate-Band (IB) absorption in low-dimensional nanostructures are under focused research topics in recent years. Among various potential approaches, this chapter is devoted to the device physics and development of the state-of-the-art technologies for quantum dot-based IB solar cells.


2019 ◽  
Vol 13 (5) ◽  
pp. 215-217 ◽  
Author(s):  
Shun Chan ◽  
Dongyoung Kim ◽  
Ana M. Sanchez ◽  
Yunyan Zhang ◽  
Mingchu Tang ◽  
...  

RSC Advances ◽  
2020 ◽  
Vol 10 (51) ◽  
pp. 30707-30715
Author(s):  
Anju Elsa Tom ◽  
Ajith Thomas ◽  
V. V. Ison

Quantum dots (QDs) solids with iodide passivation are a key component for most of the well-performing PbS QDs solar cells.


2017 ◽  
Vol 5 (45) ◽  
pp. 23960-23966 ◽  
Author(s):  
Kunyuan Lu ◽  
Yongjie Wang ◽  
Jianyu Yuan ◽  
Zequn Cui ◽  
Guozheng Shi ◽  
...  

New-generation solar cells based on colloidal lead chalcogenide (PbX) quantum dots (CQDs) are promising low-cost solution-processed photovoltaics.


Sign in / Sign up

Export Citation Format

Share Document