scholarly journals Simulation Experiment on Energy Tower Coupled with Buried Pipe System of Ground-source Heat Pump for Cross-season Heat Storage

2021 ◽  
Vol 2108 (1) ◽  
pp. 012039
Author(s):  
Jianhui Wang ◽  
Ziqiang Liu ◽  
Yingkai Liang ◽  
Guohui Peng ◽  
Weiyu Wang ◽  
...  

Abstract It is proposed to use energy tower instead of solar collector system to store heat for buried pipe system of ground-source heat pump in summer, so as to solve the problem that soil temperature is too low due to unbalanced cold and heat load of GSHP in cold and severe cold area. The simulation results show that the thermal storage power of energy tower is affected by soil temperature and environmental temperature. The lower the soil temperature, the better the thermal storage effect of energy tower system for soil. The thermal storage power and environmental temperature change in a positive relationship. It is proved that the application of cross-season heat storage is feasible for energy tower coupled with buried pipe system of ground-source heat pump in cold and severe cold area.

2020 ◽  
Vol 2020 ◽  
pp. 1-18 ◽  
Author(s):  
Yan Gao ◽  
Zhi Sun ◽  
Xinxing Lin ◽  
Chuang Wang ◽  
Zongyu Sun ◽  
...  

The cold accumulation problem can lead to performance degradation of heat pumps. This paper presents the design and optimization of a solar-assisted storage system to solve this issue. A ground source heat pump (GSHP) project was established using the transient system simulation program (TRNSYS) based on a ground heat exchange theoretical model, which was validated by a previously established experiment in Beijing. The Beijing, Harbin, and Zhengzhou regions were used in numerical simulations to represent three typical cities where buildings require space heating (a cold region, a severe cold region, and a hot summer and cold winter region, respectively). System performance was simulated over periods of ten years. The simulation results showed that the imbalance efficiencies in the Beijing, Harbin, and Zhengzhou regions are 55%, 79%, and 38%, respectively. The annual average soil temperature decreases 7.3°C, 11.0°C, and 5.3°C during ten years of conventional GSHP operation in the Beijing, Harbin, and Zhengzhou regions, respectively. Because of the soil temperature decrease, the minimum heating coefficient of performance (COP) values decrease by 23%, 46%, and 11% over the ten years for GSHP operation in these three regions, respectively. Moreover, the simulation data show that the soil temperature would still be decreasing if based on the previous solar energy area calculation method. Design parameters such as the solar collector size are optimized for the building load and average soil temperature in various cold regions. Long-term operation will test the matching rate of the compensation system with the conventional GSHP system. After the system is optimized, the solar collector area increases of 20% in the Beijing region, 25% in the Harbin region, and 15% in the Zhengzhou region could help to maintain the annual average soil temperature balance. The optimized system could maintain a higher annual average COP because of the steady soil temperature. It provides a method for the design of a solar collector area which needs to be determined in the seasonal heat storage solar ground source heat pump system.


2012 ◽  
Vol 430-432 ◽  
pp. 1957-1962
Author(s):  
Xiao Hong Xie ◽  
Yong Li ◽  
Yu Lai ◽  
Yang Cao

The technology of Ground-Source Heat Pump (GSHP) is hot in building energy efficiency and HVAC field, and is largely used in engineering practices. We studied the construction of buried-pipe system of GSHP. In this article, purposes the experiment of thermal response by constructing piled pipes are analyzed in the buried-pipe system of GSHP and principles of testing system for buried pipes of GSHP are introduced, also the soil heat response experiments to achieve pre-assessment techniques of design. Through the above testing means, we believe that whether the buried-pipe system of GSHP finally tested meets the designed heat exchange requirement is determined, which is especially significant to estimate and verify whether the whole GSHP system meets requirements of heat capacity.


2011 ◽  
Vol 71-78 ◽  
pp. 2566-2571 ◽  
Author(s):  
Yi Liu ◽  
Ya Xuan Wang ◽  
Ya Ning Zhang

Experiment of a ground source heat pump system in cold area is studied in this paper. The results indicate that when the operation time increases to 100 hours, COPHP (COP of the heat pump) and COPSYS (COP of the system) decrease from 3.54 and 2.63 to 2.53 and 1.92, respectively. The average values of COPHP and COPSYS are 3.1 and 2.3, respectively. COPHP and COPSYS with 2 compressors at work are 11% and 12.2% higher than COPHP and COPSYS with 4 compressors at work, respectively. The average COPSYS with inverters is 6.42% higher than the COPSYS without inverters.


2020 ◽  
Vol 182 ◽  
pp. 03004
Author(s):  
Jintian Li ◽  
Yunzhe Ji ◽  
Bo Wang ◽  
Ling Xie

The load properties of underground engineering have an important influence on operating characteristics of ground source heat pump system. It has important reference value for design and operation management that Simulation analyzing operating conditions of ground source heat pump system under dynamic load conditions. It took an underground engineering as an example for dynamic load calculation in the paper, and simulated operating characteristics of ground source heat pump system under three operating conditions. The calculation results show that the engineering maintenance and management period is conducive to the recovery of soil temperature, and it improves the COP value of the unit. Some measures should be taken to restore soil temperature for long-term continuous operation of underground engineering. The use of heat recovery to make domestic hot water can relieve the problem of soil thermal imbalance to some extent. It is beneficial to improve heat pump unit performance.


Energies ◽  
2020 ◽  
Vol 13 (3) ◽  
pp. 554
Author(s):  
Hongkyo Kim ◽  
Yujin Nam ◽  
Sangmu Bae ◽  
Jae Sang Choi ◽  
Sang Bum Kim

A ground source heat pump system is one of the high-efficient technologies for space heating and cooling since it uses stable underground temperature. However, in actual application, many situations cannot be achieved due to the unsuitable design of operation. In particular, the design characteristics of buildings with different building load patterns are not reflected by the conventional design method. Moreover, the design capacity of the heat pump can be reduced by designing less capacity than the peak load through the introduction of the heat storage tank, but there is no related quantitative design method. Therefore, in this study, the effect of the ground source heat pump system design factors such as shape, length of the ground heat exchanger, and the capacity of the heat storage tank on the system performance was analyzed. To quantify the effect of such factors on system performance, an experimental plant was constructed and case studies were conducted for each design factor.


Sign in / Sign up

Export Citation Format

Share Document