Interaction and acoustics of separated flows from a D-shaped bluff body

2021 ◽  
Vol ahead-of-print (ahead-of-print) ◽  
Author(s):  
Guangyuan Huang ◽  
Ka Him Seid ◽  
Zhigang Yang ◽  
Randolph Chi Kin Leung
Keyword(s):  
Vortex Shedding ◽  
Bluff Body ◽  
Leading Edge ◽  
Separated Flows ◽  
Pressure Waves ◽  
Bluff Bodies ◽  
Trailing Edge ◽  
Content Type ◽  
Trailing Edges ◽  
Edge Vortex

Purpose For flow around elongated bluff bodies, flow separations would occur over both leading and trailing edges. Interactions between these two separations can be established through acoustic perturbation. In this paper, the flow and the acoustic fields of a D-shaped bluff body (length-to-height ratio L/H = 3.64) are investigated at height-based Reynolds number Re = 23,000 by experimental and numerical methods. The purpose of this paper is to study the acoustic feedback in the interaction of these two separated flows. Design/methodology/approach The flow field is measured by particle image velocimetry, hotwire velocimetry and surface oil flow visualization. The acoustic field is modeled in two dimensions by direct aeroacoustic simulation, which solves the compressible Navier–Stokes equations. The simulation is validated against the experimental results. Findings Separations occur at both the leading and the trailing edges. The leading-edge separation point and the reattaching flow oscillate in accordance with the trailing-edge vortex shedding. Significant pressure waves are generated at the trailing edge by the vortex shedding rather than the leading-edge vortices. Pressure-based cross-correlation analysis is conducted to clarify the effect of the pressure waves on the leading-edge flow structures. Practical implications The understanding of interactions of separated flows over elongated bluff bodies helps to predict aerodynamic drag, structural vibration and noise in engineering applications, such as the aerodynamics of buildings, bridges and road vehicles. Originality/value This paper clarifies the influence of acoustic perturbations in the interaction of separated flows over a D-shaped bluff body. The contribution of the leading- and the trailing-edge vortex in generating acoustic perturbations is investigated as well.

Wake Frequency Analysis of a Plunging Airfoil with Trailing-Edge Strips

2012 ◽  
Vol 225 ◽  
pp. 3-7
Author(s):  
Fariba Ajalli ◽  
Mahmoud Mani ◽  
Mozhgan Gharakhanlou
Keyword(s):  
Vortex Shedding ◽  
Power Spectra ◽  
Leading Edge ◽  
Hot Wire ◽  
Initial Angle ◽  
Trailing Edge ◽  
Wake Structure ◽  
Velocity Defect ◽  
Edge Vortex ◽  
Dominant Frequencies

Experimental measurements were conducted on a plunging Eppler 361 strip flapped airfoil to study wake structure in the wake. The heights of strip flap were 2.6% and 3.3% chord. The velocity in the wake was measured by hot-wire anemometry. It was found that the trailing-edge strip had different effects on the plunging wake profile during the oscillation cycle. At initial angle of 0 degree, the trailing-edge strip causes more velocity defect in the oscillation phases of 180º and 270º. At high initial angle 12 degrees, a significant decrease in value of velocity is found at 180º because of the leading edge vortex shedding. The power spectra of dominant frequencies were significantly increased by fitting the strip flap on the plunging airfoil.

A study of three-dimensional aspects of vortex shedding from a bluff body with a mild geometric disturbance

1997 ◽  
Vol 330 ◽  
pp. 85-112 ◽  
Author(s):  
N. TOMBAZIS ◽  
P. W. BEARMAN
Keyword(s):  
Reynolds Number ◽  
Vortex Shedding ◽  
Bluff Body ◽  
Vortex Formation ◽  
Three Dimensional ◽  
Base Pressure ◽  
Trailing Edge ◽  
Blunt Trailing Edge ◽  
Trailing Edges ◽  
Mode Transitions

Experiments have been carried out to study the three-dimensional characteristics of vortex shedding from a half-ellipse shape with a blunt trailing edge. In order to control the occurrence of vortex dislocations, the trailing edges of the models used were constructed with a series of periodic waves across their spans. Flow visualization was carried out in a water tunnel at a Reynolds number of 2500, based on trailing-edge thickness. A number of shedding modes were observed and the sequence of mode transitions recorded. Quantitative data were obtained from wind tunnel measurements performed at a Reynolds number of 40000. Two shedding frequencies were recorded with the higher frequency occurring at spanwise positions coinciding with minima in the chord. At these same positions the base pressure was lowest and the vortex formation length longest. Arguments are put forward to explain these observations. It is shown that the concept of a universal Strouhal number holds, even when the flow is three-dimensional. The spanwise variation in time-average base pressure is predicted using the estimated amount of time the flow spends at the two shedding frequencies.

Characteristics of Bluff Body Stabilized Turbulent Premixed Flames

2011 ◽  
Author(s):  
Alejandro M. Briones ◽  
Balu Sekar ◽  
Hugh Thornburg
Keyword(s):  
Bluff Body ◽  
Three Dimensional ◽  
Leading Edge ◽  
Reacting Flows ◽  
Chemical Mechanism ◽  
Reacting Flow ◽  
Bluff Bodies ◽  
Two Dimensional ◽  
Aspect Ratios ◽  
Trailing Edges

Non-reacting and reacting flows past typical flameholders are modeled with URANS and LES. The continuity, momentum, energy, species, and turbulence governing equations are solved using two- and three-dimensional configurations. Either 2-step global or 44-step reduced chemical mechanism for C3H8-air combustion, accounting for turbulence-chemistry interaction, and with temperature- and species-dependent thermodynamic and transport properties is utilized. For square and rectangular bluff bodies the flow separates at the leading edges, whereas for triangular bluff body separation occurs only at the trailing edges. These bluff bodies exhibit two shear layers at the trailing edges that shed asymmetric vortices. For rectangular bluff bodies with aspect ratios (AR) less than 2.3 there is backflow from the wake. With increasing AR from unity, backflow is gradually diminished, and the von Ka´rma´n Strouhal number (StvK) decreases. For 2.0<AR<2.3, StvK jumps to a higher value and separation again occurs at the trailing edges for AR = 2.3. Further increase in AR decreases StvK again. The simulations with URANS qualitatively and quantitatively match experimental results for StvK vs. AR. Quantitative discrepancies are, however, found for AR≥2.3. In addition, two-dimensional non-reacting flows with URANS are sufficient to predict StvK. Moreover, two-dimensional simulations of reacting flow indicate that the flame promotes static and dynamic stability for AR = 1.0 and 2.3. The flame is dynamically unstable for AR = 2.0, exhibiting a von Ka´rma´n flow pattern. Stable flames anchored at the most downstream separation location (e.g., the flame anchored at AR = 1.0 is attached to the leading edge, whereas that of AR = 2.3 is attached to the trailing edge). Realizable k-ε URANS and LES simulations for the triangular cylinder closely match the experimental StvK for both non-reacting and reacting flows. Nonetheless, LES predicts a smaller recirculation length than k-ε URANS. LES predicts a flow field in which Be´rnard/von Ka´rma´n (BvK) instability is suppressed, whereas URANS predicts a competition between the Kelvin-Helmholtz (KH) instability and BvK.

Particle image velocimetry and visualization of natural and forced flow around rectangular cylinders

2003 ◽  
Vol 478 ◽  
pp. 299-323 ◽  
Author(s):  
RICHARD MILLS ◽  
JOHN SHERIDAN ◽  
KERRY HOURIGAN
Keyword(s):  
Particle Image Velocimetry ◽  
Flow Visualization ◽  
Vortex Shedding ◽  
Particle Image ◽  
Leading Edge ◽  
Trailing Edge ◽  
Image Velocimetry ◽  
Edge Vortex ◽  
Rectangular Cylinders ◽  
Leading Edge Vortices

Particle image velocimetry (PIV) measurements and flow visualization in a water tunnel show that vortex shedding at the leading and trailing edges of rectangular cylinders can be simultaneously phase-locked to transverse velocity perturbations when the applied perturbation Stp is close to an impinging leading-edge vortex/trailing-edge vortex shedding (ILEV/TEVS) frequency. The transverse perturbations, analogous to β-mode duct acoustic resonances, are generated through harmonic oscillations of the sidewalls. When this occurs, the leading-edge vortices are found always to pass the trailing edge at the same phase in the perturbation cycle regardless of the chord-to-thickness (c/t) ratio. Applying perturbations at an Stp not equal to the natural global frequency also results in phase-locked vortex shedding from the leading edge, and a near wake with a frequency equal to the perturbation frequency. This is consistent with previous experimental findings. However, vortex shedding at the trailing edge is either weaker or non-existent. PIV results and flow visualization showed trailing-edge vortex growth was weaker because leading-edge vortices arrive at the trailing edge at a phase in the perturbation cycle where they interfere with trailing-edge shedding. The frequencies at which trailing-edge vortices form for different c/t ratios correspond to the natural ILEV/TEVS frequencies. As in the case of natural shedding, peaks in base suction occur when the leading-edge vortices pass the trailing edge at the phase in the perturbation cycle (and thus in the leading-edge shedding cycle) that allows strong trailing-edge shedding. This is the reason for the similarity in the Stvs.c/t relationship for three seemingly different sets of experiments.

Some modeling issues on trailing-edge vortex shedding

AIAA Journal ◽  
2001 ◽  
Vol 39 ◽  
pp. 787-793
Author(s):  
Wei Ning ◽  
Li He
Keyword(s):  
Vortex Shedding ◽  
Trailing Edge ◽  
Edge Vortex

Vortex shedding from bluff bodies in a shear flow

1973 ◽  
Vol 60 (2) ◽  
pp. 401-409 ◽  
Author(s):  
D. J. Maull ◽  
R. A. Young
Keyword(s):  
Shear Flow ◽  
Vortex Shedding ◽  
Bluff Body ◽  
Pressure Coefficient ◽  
Uniform Flow ◽  
Base Pressure ◽  
Longitudinal Vortex ◽  
Bluff Bodies ◽  
Stream Direction

Experiments are described in which the vortex shedding from a bluff body and the base pressure coefficient have been measured in a shear flow. It is shown that the shedding breaks down into a number of spanwise cells in each of which the frequency is constant. The division between the cells is thought to be marked by a longitudinal vortex in the stream direction and this is supported by evidence from experiments where a longitudinal vortex was generated in an otherwise uniform flow.

Sign in / Sign up

Export Citation Format

Share Document