Experimental validation of an adaptive control for a Voltage Source Converter

Author(s):  
Rasoul M. Milasi ◽  
Alan F. Lynch ◽  
Yun Wei Li
2021 ◽  
Vol 23 (07) ◽  
pp. 678-689
Author(s):  
Bilal Ahmad Ganie ◽  
◽  
Dr. (Mrs.) Lini Mathew ◽  

This study provides an adaptive control approach of VSC (voltage source converter) coupled with SPV (solar photovoltaic array), in a 3P3W (three-phase three-wire) system with three single-phase non-linear loads having Distributed Static Compensator (DSTATCOM) abilities using P and O (perturb & observe) methodology. The adaptive control technique converges quickly and has a low mean square error. For the correction of power factor and zero voltage regulation modes, the system is studied and simulated. The system’s great efficacy at high voltages is due to its one-stage structure. Grid current harmonics are significantly below the IEEE-519 norm. The suggested system is modeled and simulated with the available sim power system toolbox in MATLAB/Simulink, and the system’s behavior under different loads and environmental circumstances is confirmed.


Processes ◽  
2019 ◽  
Vol 7 (8) ◽  
pp. 490 ◽  
Author(s):  
Yueping Jiang ◽  
Xue Jin ◽  
Hui Wang ◽  
Yihao Fu ◽  
Weiliang Ge ◽  
...  

Voltage source converter (VSC) has been extensively applied in renewable energy systems which can rapidly regulate the active and reactive power. This paper aims at developing a novel optimal nonlinear adaptive control (ONAC) scheme to control VSC in both rectifier mode and inverter mode. Firstly, the nonlinearities, parameter uncertainties, time-varying external disturbances, and unmodelled dynamics can be aggregated into a perturbation, which is then estimated by an extended state observer (ESO) called high-gain perturbation observer (HGPO) online. Moreover, the estimated perturbation will be fully compensated through state feedback. Besides, the observer gains and controller gains are optimally tuned by a recent emerging biology-based memetic salp swarm algorithm (MSSA), the utilization of such method can ensure a desirably satisfactory control performance. The advantage of ONAC is that even though the operation conditions are constantly changing, the control performance can still be maintained to be globally consistent. In addition, it is noteworthy that in rectifier mode only the reactive power and DC voltage are required to be measured, while in inverter mode merely the reactive power and active power have to be measured. At last, in order to verify the feasibility of ONAC in practical application, a hardware experiment is implemented.


Author(s):  
Mohamed Amine Kazi ◽  
Radouane Majdoul ◽  
Nadia Machkour

The growing demand for electricity and the increasing integration of clean energies into the electrical grids requires the multiplication and reinforcement of high-voltage direct current (HVDC) projects throughout the world and demonstrates the interest in this electricity transmission technology. The transmitting system of the voltage source converter-high-voltage direct current (VSC-HVDC) consists primarily of two converter stations that are connected by a dc cable. In this paper, a nonlinear control based on the backstepping approach is proposed to improve the dynamic performance of a VSC-HVDC transmission system, these transport systems are characterized by different complexities such as parametric uncertainties, coupled state variables, neglected dynamics, presents a very interesting research topic. Our contribution through adaptive control based on the backstepping approach allows regulating the direct current (DC) bus voltage and the active and reactive powers of the converter stations. Finally, the validity of the proposed control has been verified under various operating conditions by simulation in the MATLAB/Simulink environment.


Sign in / Sign up

Export Citation Format

Share Document