60 GHz bandpass filters with small and large bandwidths using thin film coupled microstrip in 0.18-μm CMOS

AbstractThin film-based optical sensors have been attracting increasing interest for use in developing technologies such as biometrics. Multilayered dielectric thin films with different refractive indices have been utilized to modulate the optical properties in specific wavelength bands for spectral selectivity of Thin Film Narrow Bandpass Filters (TFNBFs). Progress in TFNBF design has been made with the incorporation of metallic thin films. Narrower bandwidths with higher transmittance have been achieved in specific spectral bands. In this work, Ti/TiO2/SiO2 based multilayer thin films were prepared using pulsed-DC reactive sputtering. Computer simulations using the Essential Macleod Program allowed the optimal number of layers and thickness of the multilayer thin films to be determined to efficiently tailor the optical path transmitting specific wavelength bands. The addition of Ti metal layers within dielectric (TiO2/SiO2) multilayer thin films significantly changes the cutoff frequency of transmittance at specific wavelengths. Representative 26 multilayer films consisting of Ti, TiO2, and SiO2 show lower transmittance of 10.29% at 400 nm and 10.48% at 680 nm. High transmittance of 80.42% at 485 nm was observed, which is expected to improve the spectral selectivity of the TFNBF. This work provides a contribution to future simulation based design strategy based on experimental thin film engineering for potential industrial development opportunities such as optical biometrics.

Download Full-text

Optimised Performance of Non-Dispersive Infrared Gas Sensors Using Multilayer Thin Film Bandpass Filters

Coatings ◽

10.3390/coatings8120472 ◽

2018 ◽

Vol 8 (12) ◽

pp. 472 ◽

Cited By ~ 2

Author(s):

Pinggui Wang ◽

Xiuhua Fu ◽

Des Gibson ◽

Lewis Fleming ◽

Sam Ahmadzadeh ◽

...

Keyword(s):

Thin Film ◽

Work Performance ◽

Microwave Plasma ◽

Light Emitting Diode ◽

Spectral Characteristics ◽

Optical Filter ◽

Deposition Process ◽

Bandpass Filters ◽

Temperature Sensitive ◽

Sensor Performance

In this work, performance improvements are described for a low-power consumption non-dispersive infrared (NDIR) methane (CH4) gas sensor using customised optical thin film bandpass filters (BPFs) centered at 3300 nm. BPFs shape the spectral characteristics of the combined mid-infrared III–V based light emitting diode (LED)/photodiode (PD) light source/detector optopair, enhancing the NDIR CH4 sensor performance. The BPFs, deposited using a novel microwave plasma-assisted pulsed DC sputter deposition process, provide room temperature deposition directly onto the temperature-sensitive PD heterostructure. BPFs comprise germanium (Ge) and niobium pentoxide (Nb2O5) alternating high and low refractive index layers, respectively. Two different optical filter designs are progressed with BPF bandwidths (BWs) of 160 and 300 nm. A comparison of the modelled and measured NDIR sensor performance is described, highlighting the maximised signal-to-noise ratio (SNR) and the minimised cross-talk performance benefits. The BPF spectral stability for various environmental temperature and humidity conditions is demonstrated.

Download Full-text