Survey and Implementation of Programmable Gain Amplifiers

2021 ◽  
Author(s):  
Sara M Mohamed ◽  
Alaa AbdAlrhman ◽  
Ahmed Soltan ◽  
Ahmed Madian
Keyword(s):  
Programmable Gain

scholarly journals Offset Cancellation and Programmable Gain Design for Switched Capacitor Amplifier in Digital DC-DC Converter

2021 ◽  
Vol 714 (4) ◽  
pp. 042053
Author(s):  
Panpan Zhang ◽  
Peng Zhao ◽  
Xiaoping Chen ◽  
Yang Song ◽  
Zongjiang Zhang
Keyword(s):  
Switched Capacitor ◽  
Offset Cancellation ◽  
Programmable Gain

scholarly journals Measuring Current in a Power Converter Using Fuzzy Automatic Gain Control

2021 ◽  
Vol 11 (13) ◽  
pp. 5793
Author(s):  
Bartosz Dominikowski
Keyword(s):  
High Resolution ◽  
Fuzzy Controller ◽  
Automatic Gain Control ◽  
Gain Control ◽  
Measurement Range ◽  
Power Converter ◽  
Current Measurement ◽  
Dc Power ◽  
Programmable Gain ◽  
Electric Loads

The accuracy of current measurements can be increased by appropriate amplification of the signal to within the measurement range. Accurate current measurement is important for energy monitoring and in power converter control systems. Resistance and inductive current transducers are used to measure the major current in AC/DC power converters. The output value of the current transducer depends on the load motor, and changes across the whole measurement range. Modern current measurement circuits are equipped with operational amplifiers with constant or programmable gain. These circuits are not able to measure small input currents with high resolution. This article proposes a precise loop gain system that can be implemented with various algorithms. Computer analysis of various automatic gain control (AGC) systems proved the effectiveness of the Mamdani controller, which was implemented in an MCU (microprocessor). The proposed fuzzy controller continuously determines the value of the conversion factor. The system also enables high resolution measurements of the current emitted from small electric loads (≥1 A) when the electric motor is stationary.

scholarly journals High-CMRR Low-Noise Fully Integrated Front-End for EEG Acquisition Systems

Electronics ◽  
2019 ◽  
Vol 8 (10) ◽  
pp. 1157 ◽  
Author(s):  
Robert Chebli ◽  
Mohamed Ali ◽  
Mohamad Sawan
Keyword(s):  
Low Noise ◽  
Common Mode ◽  
Fully Integrated ◽  
Dc Offset ◽  
Chopper Stabilization ◽  
Logarithmic Amplifier ◽  
Offset Voltage ◽  
High Cmrr ◽  
Programmable Gain ◽  
Stabilization Technique

We present in this paper a fully integrated low-noise high common-mode rejection ratio (CMRR) logarithmic programmable gain amplifier (LPGA) and chopped LPGA circuits for EEG acquisition systems. The proposed LPGA is based on a rail-to-rail true logarithmic amplifier (TLA) stage. The high CMRR achieved in this work is a result of cascading three amplification stages to construct the LPGA in addition to the lower common-mode gain of the proposed logarithmic amplification topology. In addition, the 1 / f noise and the inherent DC offset voltage of the input transistors are reduced using a chopper stabilization technique. The CMOS 180 nm standard technology is used to implement the circuits. Experimental results for the integrated LPGA show a CMRR of 140 dB, a differential gain of 37 dB, an input-referred noise of 0.754 μ Vrms, a 189 μ W power consumption from 1.8 V power supply and occupies an active area of 0.4 mm 2 .

A DC to 10.1 GHz, 31 dB gain range control, digital programmable gain amplifier

2016 ◽  
Author(s):  
Xuan-Quang Du ◽  
Anselm Knobloch ◽  
Markus Grozing ◽  
Matthias Buck ◽  
Manfred Berroth
Keyword(s):  
Programmable Gain Amplifier ◽  
Programmable Gain
Sign in / Sign up

Export Citation Format

Share Document