No Back-pressure Effect Micro-dispenser Suction Pump

2006 ◽  
Author(s):  
Chun-fu Lu ◽  
Jinn-cherng Yang ◽  
Chien-chung Fu
Keyword(s):  
Pressure Effect ◽  
Back Pressure ◽  
Suction Pump

scholarly journals Considering the turbine back-pressure effect of thermal units to optimize the PQ_power generation in power system

2013 ◽  
Vol 16 (3) ◽  
pp. 58-71
Author(s):  
Quang Huu Vinh Luu
Keyword(s):  
Power System ◽  
Loss Factor ◽  
Pressure Effect ◽  
Back Pressure ◽  
Power Losses ◽  
Order Polynomial ◽  
Network Transmission ◽  
Sinusoidal Functions ◽  
Optimum Solution ◽  
Cost Characteristics

A new algorithm of PQ_power optimization is mentioned and some typical numerical examples are presented in this article. The fuel cost characteristics being obtained in form of superposition of some high order polynomial and sinusoidal functions can approximately simulate the turbine back-pressure effect of the generator units at the electrical thermal stations and solve the problem of economic active power dispatch. A new loss factor formula expressing the network transmission power losses is a second order polynomial function of generator powers containing a square matrix. This loss factor formula is proposed for optimum solution of generator reactive powers in multi-machine power system.

Laser-Controlled Combustion of Solid Propellant

2014 ◽  
Vol 884-885 ◽  
pp. 87-90 ◽  
Author(s):  
Zhao Qin ◽  
Jiang Wu ◽  
Rui Qi Shen ◽  
Ying Hua Ye ◽  
Li Zhi Wu
Keyword(s):  
Burning Rate ◽  
Laser Irradiation ◽  
Power Density ◽  
Experimental Work ◽  
Laser Power ◽  
Solid Propellant ◽  
Pressure Effect ◽  
Laser Power Density ◽  
Back Pressure ◽  
Solid Propellants

This paper describes experimental work on laser-controlled combustion of solid propellants. Combustion of AP/HTPB, including ignition, combustion, extinction and re-ignition could be controlled by CO2 laser irradiation at the back pressure of 0.1, 0.3 and 0.5 MPa in nitrogen. Burning rate of propellant increased linearly with the increasing of laser power density. Vieilles law was used here to check pressure effect to burning rate, pressure exponent under different power density (except 0.5 MW/m2) are very close to 0.17.

The Hydrostatic Pressure Effect on Elastic Properties of B2-Phase Single Crystals Ti50Ni48Fe2and Ti50Ni45Fe5Alloys

1995 ◽  
Vol 05 (C8) ◽  
pp. C8-729-C8-734
Author(s):  
A.I. Lotkov ◽  
V.P. Lapshin ◽  
V.A. Goncharova ◽  
H.V Chernysheva ◽  
V.N. Grishkov ◽  
...  
Keyword(s):  
Hydrostatic Pressure ◽  
Single Crystals ◽  
Elastic Properties ◽  
Pressure Effect ◽  
B2 Phase

PRESSURE EFFECT ON THE CURIE TEMPERATURE OF Gd1-xYxCo2

1988 ◽  
Vol 49 (C8) ◽  
pp. C8-275-C8-276
Author(s):  
H. Yoshida ◽  
T. Komatsu ◽  
T. Kaneko ◽  
S. Abe ◽  
K. Kamigaki
Keyword(s):  
Curie Temperature ◽  
Pressure Effect

PRESSURE EFFECT ON CURIE TEMPERATURE FOR (FeNi)90 Zr10 AMORPHOUS ALLOYS

1988 ◽  
Vol 49 (C8) ◽  
pp. C8-1281-C8-1282
Author(s):  
H. Tange ◽  
Y. Tanaka ◽  
K. Shirakawa
Keyword(s):  
Curie Temperature ◽  
Amorphous Alloys ◽  
Pressure Effect

Re-Dispersion of Flocculated Nanoparticles Using Back Pressure Valve with Small Orifice Channel

2014 ◽  
Vol 2 ◽  
pp. 78-81
Author(s):  
Nobuaki Aoki ◽  
Noriyoshi Manabe ◽  
Tadafumi Adschiri
Keyword(s):  
Back Pressure
Sign in / Sign up

Export Citation Format

Share Document