Electromagnetic transients study due to lightning strikes on two interconnected wind turbines

Author(s):  
R. B. Rodrigues ◽  
V. M. F. Mendes ◽  
J. P. S. Catalao
2020 ◽  
Vol 11 (7-2020) ◽  
pp. 66-72
Author(s):  
Liubov A. Belova ◽  

The earth-termination system for towers of ground-based wind turbines in addition to protective and functional grounding provides lightning protection grounding, which is especially important since the wind turbine is susceptible to lightning strikes. If insufficient protective measures are taken, the risk of damage to a wind turbine due to a lightning strike increases. Therefore, a well-thought-out built-in grounding system for wind turbine towers is needed, which would function as necessary and guarantee long-term mechanical strength and corrosion resistance. The configuration of grounding systems for wind turbines is discussed in IEC 61400-24, which deals with the topic of lightning protection for wind turbines, including detailed information on the choice of lightning protection measures and surge protection. It is advisable to create a lightning protection concept at the initial stage of planning a wind turbine in order to avoid later costly repairs and retrofitting.


Energies ◽  
2019 ◽  
Vol 12 (16) ◽  
pp. 3193 ◽  
Author(s):  
Pornchai Sestasombut ◽  
Atthapol Ngaopitakkul

This paper evaluates the effect of a lightning strike directly on the 24 kV distribution lines in Thailand, where such strikes are one of the main causes of power outages. The voltage across the insulator, and the arrester energy absorbed due to the lightning, need to be analyzed for different grounding distances of the overhead ground wire, ground resistance, lightning impact positions, and lightning current waveforms. Analysis and simulations are conducted using the Alternative Transients Program/Electromagnetic Transients Program (ATP/EMTP) to find the energy absorbed by the arrester and the voltages across the insulator. The results indicate that when surge arresters are not installed, the voltage across the insulator at the end of the line is approximately 1.4 times that in the middle of the line. In addition, the ground resistance and grounding distance of the overhead ground wire affect the voltage across the insulator if the overhead ground wire is struck. When surge arresters are installed, a shorter grounding distance of the overhead ground wire and a lower ground resistance are not always desirable; this is because they reduce the back-flashover rate and the voltage across the insulator if lightning strikes the overhead ground wire. However, lightning strikes to the phase conductor result in high arrester energy and the possibility that the arrester will fail. Furthermore, the tail time of the lightning waveform is a significant variable when considering the energy absorbed by the arrester, whereas the front time is important for the voltage across the insulator. In case lightning strikes directly on the connected point between the overhead lines and the underground cables, the distribution line system is protected only by the lightning arrester at the connection point. The overvoltage at the connection point is lower than the basic impulse level at 24 kV of 125 kV, but the overvoltage at the end of the cable is still more than 125 kV in case the cable is longer than 400 m. When the distribution line system is protected by the lightning arrester at both the connection point and the end of the cable, it results in overvoltage throughout the cable is lower than the critical flashover of insulation. This method is the best way to reduce the failure rate of underground cables and equipment that are connected to the distribution line system.


Author(s):  
Riccardo Torchio ◽  
Martino Nicora ◽  
Daniele Mestriner ◽  
Massimo Brignone ◽  
Renato Procopio ◽  
...  

2021 ◽  
Author(s):  
Walter L. M. de Azevedo ◽  
Wagner C. da Silva ◽  
Anderson R. J. de Araujo ◽  
Jose Pissolato Filho

2020 ◽  
Author(s):  
Gerhard Diendorfer

<p>Upward lightning triggered by elevated objects, such as wind turbines (WT), may increase significantly the number of lightning strikes to these objects. In the recently publishes 2<sup>nd</sup> edition of the international standard IEC 61400-24 an environmental factor C<sub>DWL</sub> for winter lightning conditions was introduced to account for this additional lightning risk in the lightning exposure assessment of a WT. Values for C<sub>DWL</sub> should be 4 (in medium winter lightning activity areas) or 6 (high activity areas) or even higher in special cases. The main challenge is to get reliable data about the winter lightning activity for a given region and for first estimates maps of winter lightning activity for the continents are given in IEC 62400-24, Annex B.</p><p>A different approach is used in this contribution. As there is already a high number of WT installed in Europe, we have investigated the number (percentage) of existing WT that was at least struck one time in the winter periods of 2017/18 an 2018/19 based on data of the EUCLID lightning location system.</p><p>We have extracted the locations of 10.225 WT sites in Europe in the area from 45°N - 50°N and 10°W -30°E form OpenStreetMap database. Then we checked if there were any lightning strikes located by EUCLID within a 0.003° circular area (is about a 300 m radius) around each of these turbines during the cold season (October to April) in 2017/18 and 2018/2019, respectively. Out of the 10.225 WT 1.131 (11,1 %) and 913 (8,9 %) have been struck by lightning in cold season 2017/18 and 2018/19, respectively. It is worth noting, that only 101 WT (1%) were struck in both seasons, indicating that it is more a dependency on regional meteorological conditions changing from year to year, rather than on a specific group of WT. EUCLID detected flashes are likely to represent only about one half of the real occurring upward flashes from the WT. ICC<sub>Only</sub> type upward lightning, which are discharges with current waveforms not followed by any return strokes are typically not detected by lightning location systems, and on instrumented towers this type of discharges makes up about 50% of all upward lightning. But there is a high chance, that a large fraction of this ICC<sub>Only</sub> discharges were triggered by the same WT, where EUCLID detected some strokes.</p><p>In terms of dependency of the altitude of the WT site above sea level we observe a clear increase of probability of WT lightning with increasing altitude. About 10 % (29/315) of the 315 WT at altitudes up to 50 m ASL are struck by lightning increasing to almost 50 % (15/31) for WT at sites of 950 to 1000 m altitudes ASL. No clear trend is observed for higher altitudes, likely due to the low number of WT above 1000 m.</p><p>The obtained 10 % of the WTs triggering at least one upward lighting per cold season demonstrates the high probability of lightning to WT and emphasizes the need of proper protection of the WTs mechanical structure (rotor blades) as well as the entire electrical installation.</p>


Energies ◽  
2020 ◽  
Vol 13 (3) ◽  
pp. 691
Author(s):  
Yang Zhao ◽  
Xi Wang ◽  
Qibin Zhou ◽  
Zhenxing Wang ◽  
Xiaoyan Bian

In order to solve the problem of icing on the surface of wind turbine blade, a heating system that includes a carbon fiber net (CFN) and power cables is proposed recently. When lightning strikes at the blade with a de-icing heating system, the blade and its heating system are more easily damaged due to the overvoltage between the lightning protection system (LPS) of the blade and the heating system. In this paper, the models of a wind turbine blade with the de-icing heating system are established by Alternative Transients Program/Electromagnetic Transients Program (ATP–EMTP) and the accuracy of models is verified through an experiment. With these models, the influence of lightning current, surge protective devices (SPDs) and earthing resistance of wind turbine are analyzed by calculating the voltage between the down-conductor of the LPS and the heating system. The results show that the voltage is positively correlated with lightning current amplitude and negatively correlated with the front time of lightning current. SPDs are quite useful to reduce the voltage, and an optimal installation scheme of SPDs is obtained by simulation. It is noted that voltage decreases slightly with the increasing earthing resistance with the optimal installation scheme of SPDs.


2021 ◽  
Vol 141 (5) ◽  
pp. 400-401
Author(s):  
Masaru Ishii ◽  
Mikihisa Saito ◽  
Daisuke Natsuno

2011 ◽  
Vol 2011 ◽  
pp. 1-6 ◽  
Author(s):  
J. G. Fantidis ◽  
C. Potolias ◽  
D. V. Bandekas

Wind turbines are becoming widely used as they are an environmentally friendly way for energy production without emissions; however, they are exposed to a corrosive environment. In addition, as wind turbines typically are the tallest structures in the surrounding area of a wind farm, it is expected that they will attract direct lightning strikes several times during their operating life. The purpose of this paper is to show that the radiography with a transportable unit is a solution to find defects in the wind turbine blade and reduce the cost of inspection. A transportable neutron radiography system, incorporating an Sb–Be source, has been simulated using the MCNPX code. The simulated system has a wide range of radiography parameters.


Sign in / Sign up

Export Citation Format

Share Document