Map-Based Channel Model for Evaluation of 5G Wireless Communication Systems

2017 ◽  
Vol 65 (12) ◽  
pp. 6491-6504 ◽  
Author(s):  
Pekka Kyosti ◽  
Janne Lehtomaki ◽  
Jonas Medbo ◽  
Matti Latva-aho
2021 ◽  
Vol 2021 ◽  
pp. 1-11
Author(s):  
Kai Zhang ◽  
Fangqi Zhang ◽  
Guoxin Zheng ◽  
Lei Cang

With the rapid development of high-mobility wireless communication systems, e.g., high-speed train (HST) and metro wireless communication systems, more and more attention has been paid to the wireless communication technology in tunnel-like scenarios. In this paper, we propose a three-dimensional (3D) nonstationary multiple-input multiple-output (MIMO) channel model with high-mobility wireless communication systems using leaky coaxial cable (LCX) inside a rectangular tunnel over the 1.8 GHz band. Taking into account single-bounce scattering under line-of-sight (LoS) and non-line-of-sight (NLoS) propagations condition, the analytical expressions of the channel impulse response (CIR) and temporal correlation function (T-CF) are derived. In the proposed channel model, it is assumed that a large number of scatterers are randomly distributed on the sidewall of the tunnel and the roof of the tunnel. We analyze the impact of various model parameters, including LCX spacing, time separation, movement velocity of Rx, and K-factor, on the T-CF of the MIMO channel model. For HST, the results of some further studies on the maximum speed of 360 km/h are given. By comparing the T-CF between the dipole MIMO system and the LCX-MIMO system, we can see that the performance of the LCX-MIMO system is better than that of the dipole MIMO system.


2017 ◽  
Vol 16 (4) ◽  
pp. 2057-2068 ◽  
Author(s):  
Ammar Ghazal ◽  
Yi Yuan ◽  
Cheng-Xiang Wang ◽  
Yan Zhang ◽  
Qi Yao ◽  
...  

2020 ◽  
Vol 6 (2) ◽  
pp. 211-222 ◽  
Author(s):  
Jie Huang ◽  
Cheng-Xiang Wang ◽  
Lu Bai ◽  
Jian Sun ◽  
Yang Yang ◽  
...  

2021 ◽  
pp. 228-235
Author(s):  
Sarun Duangsuwan ◽  

A challenge swarm unmanned aerial vehicles (swarm UAVs)-based wireless communication systems have been focused on channel modeling in various environments. In this paper, we present the characterized path loss air-to-air (A2A) channel modeling-based measurement and prediction model. The channel model was considered using A2A Two-Ray (A2AT-R) extended path loss modeling. The prediction model was considered using an artificial neural network (ANN) algorithm to train the measured dataset. To evaluate the measurement result, path loss models between the A2AT-R model and the prediction model are shown. We show that the prediction model using ANN is optimal to train the measured data for the A2A channel model. To discuss the result, the parametric prediction errors such as mean absolute error (MAE), root mean square error (RMSE), and R-square (R2), are performed.


2021 ◽  
Author(s):  
mojtaba ghermezcheshmeh ◽  
Vahid Jamali ◽  
Haris Gacanin, ◽  
Nikola zlatanov

<div>Large intelligent surface-based transceivers (LISBTs), in which a spatially continuous surface is being used for signal transmission and reception, have emerged as a promising solution for improving the coverage and data rate of wireless communication systems. To realize these objectives, the acquisition of accurate channel state information (CSI) in LISBT-assisted wireless communication systems is crucial. In this paper, we propose a channel estimation scheme based on a parametric physical channel model for line-of-sight dominated communication in millimeter and terahertz wave bands. The proposed estimation scheme requires only five pilot signals to perfectly estimate the channel parameters assuming there is no noise at the receiver. In the presence of noise, we propose an iterative estimation algorithm that decreases the channel estimation error due to noise. The training overhead and computational cost of the proposed scheme do not scale with the number of antennas. The simulation results demonstrate that the proposed estimation scheme significantly outperforms other benchmark schemes.</div>


2021 ◽  
Author(s):  
mojtaba ghermezcheshmeh ◽  
Vahid Jamali ◽  
Haris Gacanin, ◽  
Nikola zlatanov

<div>Large intelligent surface-based transceivers (LISBTs), in which a spatially continuous surface is being used for signal transmission and reception, have emerged as a promising solution for improving the coverage and data rate of wireless communication systems. To realize these objectives, the acquisition of accurate channel state information (CSI) in LISBT-assisted wireless communication systems is crucial. In this paper, we propose a channel estimation scheme based on a parametric physical channel model for line-of-sight dominated communication in millimeter and terahertz wave bands. The proposed estimation scheme requires only five pilot signals to perfectly estimate the channel parameters assuming there is no noise at the receiver. In the presence of noise, we propose an iterative estimation algorithm that decreases the channel estimation error due to noise. The training overhead and computational cost of the proposed scheme do not scale with the number of antennas. The simulation results demonstrate that the proposed estimation scheme significantly outperforms other benchmark schemes.</div>


2019 ◽  
Vol 12 (1) ◽  
pp. 25-30
Author(s):  
Awwab Q. Jumaah

In wireless communication systems, the channel estimation problem has been played an essential challenge to accurately retrieve the channel state information (CSI) such that reliable communication & wide coverage can be provided. Due to the improvement and rapid growth of communication systems and in order to maintain a reliable data transmission, estimation of CSI has become necessary. This in turn results, precise receiver demodulation, accurate decoding, and equalization processes. This paper gives a survey on a fading phenomena and a comprehensive review of the recent works that have already been done and studied related to the problem of estimating channel parameters in wireless communication systems. Varieties of best channel estimation techniques that have been recently evolved are explored. Comparison between them in terms of computational cost, simplicity and appropriateness conditions is also discussed. This paper also provides a basic introduction of wireless channel model, SIMO and MIMO channel.


Sign in / Sign up

Export Citation Format

Share Document