A Dynamic 3-D Wideband GBSM for Cooperative Massive MIMO Channels in Intelligent High-Speed Railway Communication Systems

Author(s):  
Tao Zhou ◽  
Yi Yang ◽  
Liu Liu ◽  
Cheng Tao ◽  
Yiqun Liang
2017 ◽  
Vol 2017 ◽  
pp. 1-15 ◽  
Author(s):  
Jianwen Ding ◽  
Lei Zhang ◽  
Jingya Yang ◽  
Bin Sun ◽  
Jiying Huang

The rapid development of high-speed railway (HSR) and train-ground communications with high reliability, safety, and capacity promotes the evolution of railway dedicated mobile communication systems from Global System for Mobile Communications-Railway (GSM-R) to Long Term Evolution-Railway (LTE-R). The main challenges for LTE-R network planning are the rapidly time-varying channel and high mobility, because HSR lines consist of a variety of complex terrains, especially the composite scenarios where tunnels, cuttings, and viaducts are connected together within a short distance. Existing researches mainly focus on the path loss and delay spread for the individual HSR scenarios. In this paper, the broadband measurements are performed using a channel sounder at 950 MHz and 2150 MHz in a typical HSR composite scenario. Based on the measurements, the pivotal characteristics are analyzed for path loss exponent, power delay profile, and tap delay line model. Then, the deterministic channel model in which the 3D ray-tracing algorithm is applied in the composite scenario is presented and validated by the measurement data. Based on the ray-tracing simulations, statistical analysis of channel characteristics in delay and Doppler domain is carried out for the HSR composite scenario. The research results can be useful for radio interface design and optimization of LTE-R system.


2021 ◽  
Vol 36 (7) ◽  
pp. 879-884
Author(s):  
Hao Li ◽  
Lu Xu ◽  
Feng Qian ◽  
Yong Zhou

As a convenient and efficient public transport system, high speed railway (HSR) was rapidly deployed in China. Since the fifth generation (5G) mobile communication system is commercially applied, it is necessary for mobile terminals antennas to cover multiple operating bands to be compatible with various communication systems. Here a HSR-mounted broadband and high-gain monopole antenna is proposed. By using the meander technology and introducing the tapered structure, the proposed antenna operates over a bandwidth of 694-960 MHz and 1350-5975 MHz (VSWR<1.8), which covers both 2G-5G mobile communication and WiFi frequency bands. The dimensions of the proposed antenna are 400 mm × 330 mm × 78 mm. The measured average gain is 6.11 dBi over the entire bandwidth.


2019 ◽  
Vol 2019 ◽  
pp. 1-15 ◽  
Author(s):  
Athar Waseem ◽  
Aqdas Naveed ◽  
Sardar Ali ◽  
Muhammad Arshad ◽  
Haris Anis ◽  
...  

Massive multiple-input multiple-output (MIMO) is believed to be a key technology to get 1000x data rates in wireless communication systems. Massive MIMO occupies a large number of antennas at the base station (BS) to serve multiple users at the same time. It has appeared as a promising technique to realize high-throughput green wireless communications. Massive MIMO exploits the higher degree of spatial freedom, to extensively improve the capacity and energy efficiency of the system. Thus, massive MIMO systems have been broadly accepted as an important enabling technology for 5th Generation (5G) systems. In massive MIMO systems, a precise acquisition of the channel state information (CSI) is needed for beamforming, signal detection, resource allocation, etc. Yet, having large antennas at the BS, users have to estimate channels linked with hundreds of transmit antennas. Consequently, pilot overhead gets prohibitively high. Hence, realizing the correct channel estimation with the reasonable pilot overhead has become a challenging issue, particularly for frequency division duplex (FDD) in massive MIMO systems. In this paper, by taking advantage of spatial and temporal common sparsity of massive MIMO channels in delay domain, nonorthogonal pilot design and channel estimation schemes are proposed under the frame work of structured compressive sensing (SCS) theory that considerably reduces the pilot overheads for massive MIMO FDD systems. The proposed pilot design is fundamentally different from conventional orthogonal pilot designs based on Nyquist sampling theorem. Finally, simulations have been performed to verify the performance of the proposed schemes. Compared to its conventional counterparts with fewer pilots overhead, the proposed schemes improve the performance of the system.


IEEE Access ◽  
2019 ◽  
Vol 7 ◽  
pp. 52818-52826 ◽  
Author(s):  
Tao Zhou ◽  
Huayu Li ◽  
Yang Wang ◽  
Liu Liu ◽  
Cheng Tao

2012 ◽  
Vol 2012 ◽  
pp. 1-7 ◽  
Author(s):  
Jingya Yang ◽  
Bo Ai ◽  
Zhangdui Zhong

The validity of the maximum capacity criterion applied to realize high-rank line-of-sight (LoS) multiple-input multiple-output (MIMO) channels is investigated for high speed railway scenarios. Performance is evaluated by ergodic capacity. Numerical results demonstrate that by simply adjusting antenna spacing according to the maximum capacity criterion, significant capacity gains are achievable. We find relatively low sensitivity of the system to displacements from the optimal point and angle in relatively short range. Thus, we present two proposals to reconfigure antenna arrays so as to maximize LoS MIMO capacity in the high speed railway scenarios


Sign in / Sign up

Export Citation Format

Share Document