Gain Enhancement in L–Band EDFA by Splitting EDF into Two Stages

2012 ◽  
Author(s):  
Sulaiman Wadi Harun ◽  
Harith Ahmad

Sebuah esperimen bagi menambah daya pembesaran untuk jalur gelombang panjang (jalur–L) pembesar terdop erbium (PTE) telah didemonstrasi menggunakan reka bentuk yang berbadan dua. Jika dibandingkan dengan pembesar yang berbadan satu, pembesar ini dapat menambah pembesaran untuk isyarat 1580 nm sebanyak 5.5 dB dengan sedikit sahaja penambahan nilai bisingan. Nilai bisingan bertambah sebanyak 0.3 dB kerana kemasukan isolator dalam reka bentuk. Kadar kuasa pam pertama mestilah 33% daripada jumlah keseluruhan kuasa pam untuk nilai optima. Pembesaran maksimum sebanyak 8.3 dB telah diperolehi oleh isyarat 1568 nm semasa kuasa isyarat dan kuasa pam, masing–masing ditetapkan pada 30 dBm dan 92 mW. Keputusan esperimen menunjukkan penggunaan pembesar berbadan dua dapat menjimatkan kos kerana ia menggunakan kuasa pam yang lebih rendah. Kata kunci: Gentian terdop erbium, pembesar optik, pembesar terdop erbium, jalus LPTE An experiment on gain enhancement in the long–wavelength band erbium–doped fiber amplifier (L–band EDFA) is demonstrated using a dual stage configuration. Compared to a conventional single–stage amplifier, the small signal gain for a 1580 nm signal can be improved by 5.5 dB without paying much noise figure penalty. The corresponding noise figure penalty was 0.3 dB due to the insertion loss of the optical isolator. The optimum pump power ratio for the first pump was experimentally determined to be 33%. The maximum gain improvement of 8.3 dB was obtained at a signal wavelength of 1568 nm while signal and total pump powers were fixed at –30 dBm and 92 mW, respectively. These results show that the employment of the dual–stage amplifier system will play an important role in the development of a practical L–band EDFA from the perspective of economical usage of pump power. Key words: Erbium doped fiber, optical amplifier, L-band EDFA, dual-stage EDFA, amlified spontaneous emission

1970 ◽  
Vol 4 (1) ◽  
Author(s):  
S. W. Harun and H. Ahmad

An experiment on gain enhancement in the long wavelength band erbium doped fiber amplifier (L-band EDFA) is demonstrated. It uses a dual stage technique with dual forward pumping scheme. Compared to a conventional single stage amplifier, the small signal gain for 1580nm signal can be improved by 5.5dB without paying much noise figure penalty. The corresponding noise figure penalty was 0.3dB due to the insertion loss of the optical isolator. The optimum pump power ratio for the first pump is experimentally determined to be 33%. The maximum gain improvement of 8.3dB was obtained at a signal wavelength of 1568nm while signal and total pump powers were fixed at -30dBm and 92mW, respectively. The employment of dual stage amplifier system seems to play an important role in the development of practical L-band EDFA from the perspective of economical usage of pump power.Key Words:  erbium doped fibre; optical amplifier; L-band EDFA; dual stage EDFA; amplified spontaneous emission


2012 ◽  
Author(s):  
Sulaiman Wadi Harun ◽  
T. Subramaniam ◽  
Nizam Tamchek ◽  
Harith Ahmad

Kesan suntikan pancaran spontan terkuat (ASE) jalur–C terhadap prestasi jalur–L penguat gentian terdop–erbium (EDFA) ditunjukkan. Sebuah pekeliling dan parutan gentian Bragg lebar jalur luas digunakan untuk menyalurkan ASE jalur–C ke dalam sistem penguat. Dengan penyuntikan sejumlah kecil ASE (20 dB pelemahan dan lebih), gandaan isyarat kecil ditingkatkan tanpa peningkatan nilai hingar berbanding penguat tanpa suntikan ASE. Peningkatan gandaan maksimum adalah sebanyak 3.5 dB dan dicapai semasa pelemahan 20 dB untuk isyarat 1580 nm. Walau bagaimanapun, jika penguat disuntik dengan jumlah ASE yang besar (VOA=0 dB), gandaan penguat didapati mendatar pada 15.2 dB dari –40 hingga –10 dBm dengan variasi gandaan kurang daripada 0.3 dB. Kuasa tepu juga bertambah dari –8 dBm (semasa tiada ASE) kepada 2 dBm (VOA=0 dB) dengan sedikit peningkatan nilai hingar. Keputusan ini menunjukkan bahawa teknik menyuntik ASE boleh digunakan sama ada untuk meningkatkan gandaan atau untuk menetapkan nilai gandaan dalam EDFA jalur–L. Kata kunci: Penetapan gandaan, penguat optik, EDFA jalur-L, penambahan gandaan, pancaran spontan terkuat The effect of injecting conventional band amplified spontaneous emission (C–band ASE) on the performance of long wavelength band erbium–doped fiber amplifier (L–band EDFA) is demonstrated. A circulator and a broadband fiber Bragg grating (FBG) were used to route a C–band ASE into amplifier system. Injection of a small amount of ASE (attenuation of 20 dB and above) improves the small signal gain with a negligible noise figure penalty compared to that of an amplifier without the ASE injection. A maximum gain improvement of 3.5 dB is obtained at an attenuation of 20 dB for signal wavelength of 1580 nm. At very large amount of ASE injection (VOA=0 dB), the gain of the amplifier is clamped at 15.2 dB from –40 to –10 dBm with a gain variation of less than 0.3 dB. The saturation power is also increased from –8 dBm (for without ASE injection) to 2 dBm (VOA=0 dB) with a slight noise figure penalty. These results show that the ASE injection technique can be used either for gain improvement or gain clamping in L–band EDFA. Keywords: Gain clamping, optical amplifier, L-band EDFA, gain enhancement, amplified spontaneous emission


2003 ◽  
Vol 42 (Part 2, No. 2B) ◽  
pp. L173-L175 ◽  
Author(s):  
Sulaiman Wadi Harun ◽  
Nizam Tamchek ◽  
Prabakaran Poopalan ◽  
Harith Ahmad

Author(s):  
Sami D. Alaruri

In this work, the construction of a single stage L-band erbium-doped fiber amplifier which incorporates a short 5.1 m erbium doped fiber coil is described. Gain and noise figure measurements as a function of forward, backward and counter-propagating CW 1480 nm pumping schemes at different pump power levels are presented. Further, the Erbium Doped Fiber Amplifier (EDFA) power conversion efficiency (PCE) calculations as a function of pump power are provided.


2004 ◽  
Vol 13 (02) ◽  
pp. 315-319
Author(s):  
S. W. HARUN ◽  
H. AHMAD

The effect of injecting of C-band amplified spontaneous emission (ASE) from C-band erbium-doped fiber amplifier (EDFA) on the performance of L-band EDFA is demonstrated using a circulator and broadband fiber Bragg grating (FBG). Injecting a large amount of ASE (VOA=0 dB) clamps the gain at 15.2 dB from -40 to -10 dBm with a gain variation of less than 0.3 dB. Injecting a small amount of ASE (attenuation of 20 dB and above) improves the small signal gain with a negligible noise figure penalty compared to that of an amplifier without the ASE injection. A maximum gain improvement of 3.5 dB is obtained at an attenuation of 20 dB. These results show that the ASE injection technique can be used either for gain improvement or gain clamping in L-band EDFA.


2006 ◽  
Vol 15 (03) ◽  
pp. 303-307
Author(s):  
HARITH AHMAD ◽  
SULAIMAN WADI HARUN

A double-pass erbium-doped fiber amplifier (EDFA) based on a depressed cladding erbium-doped fiber, which operates in the short wavelength (S-band) region is proposed and demonstrated. This amplifier provides a small signal gain as high as 30 dB at 1500 nm, using only 15 m depressed cladding erbium-doped fiber (EDF) and 130 mW of 980 nm pump power. Compared to the single-pass configuration, this amplifier shows a gain enhancement of about 14 dB for pump powers above 120 mW. However, noise figures penalties of less than 0.9 dB are obtained for these pump powers. The proposed double-pass amplifier will play an important role in the development of a practical S-band EDFA from the perspective of economical usage of EDF and pump power.


2019 ◽  
Vol 12 (1) ◽  
pp. 66-72
Author(s):  
A. K. Abass

This work demonstrates the simulation of two different types of optical fiber amplifiers (OFA) utilizing OptiSystem–10, namely, 3 m length of erbium doped fiber amplifier (EDFA) and 7 km length of Raman fiber amplifier (RFA). The counter-pumped architecture is adopted for both proposed optical amplifiers. The optimum pump power (OPP) for each amplifier determines in which the longest 3–dB flat gain bandwidth (3–dB BW), reasonable average gain level (Gav), proper average noise figure (NFav) and lower gain variation (Gvar) were achieved. The EDFA shows best performance at conventional band (C–band) within the pump power of 30 mW.While the better performance is observed at long band (L–band) within the pump power of 600 mW for the RFA.


2012 ◽  
Vol 285 (6) ◽  
pp. 1383-1386 ◽  
Author(s):  
N.Md. Yusoff ◽  
A.F. Abas ◽  
S. Hitam ◽  
M.A. Mahdi

Sign in / Sign up

Export Citation Format

Share Document