Analytical Upper Limit of Drag Reduction With Polymer Additives in Turbulent Pipe Flow

2018 ◽  
Vol 140 (5) ◽  
Author(s):  
Xin Zhang ◽  
Xili Duan ◽  
Yuri Muzychka

Flow drag reduction induced by chemical additives, more commonly called drag-reducing agents (DRAs), has been studied for many years, but few studies can manifest the mechanism of this phenomenon. In this paper, a new mathematical model is proposed to predict the upper limit of drag reduction with polymer DRAs in a turbulent pipe flow. The model is based on the classic finitely extensible nonlinear elastic-Peterlin (FENE-P) theory, with the assumption that all vortex structures disappear in the turbulent flow, i.e., complete laminarization is achieved. With this model, the maximum drag reduction by a DRA at a given concentration can be predicted directly with several parameters, i.e., bulk velocity of the fluid, pipe size, and relaxation time of the DRA. Besides, this model indicates that both viscosity and elasticity contribute to the drag reduction: before a critical concentration, both viscosity and elasticity affect the drag reduction positively; after this critical concentration, elasticity still works as before but viscosity affects drag reduction negatively. This study also proposes a correlation format between drag reduction measured in a rheometer and that estimated in a pipeline. This provides a convenient way of pipeline drag reduction estimation with viscosity and modulus of the fluids that can be easily measured in a rheometer.

Author(s):  
Seiya Nakazawa ◽  
Takaaki Shimura ◽  
Akihiko Mitsuishi ◽  
Kaoru Iwamoto ◽  
Akira Murata

Abstract Drag reduction effect by traveling wavy wall deformation control in turbulent pipe flow was experimentally investigated. From the visualization, we confirmed the downstream traveling wave although it was not uniform in the circumferential direction. When the frequency is 110 Hz, the wall deformation amplitude and the wavelength indicated that the effective values for drag reduction. The wavespeed is approximately effective values for drag reduction. As a result, the maximum drag reduction rate of 6.8 % is obtained. The result of a LDV measurement shows that the mean streamwise velocity gradient decreased near the wall by the control, which leads to drag reduction.


2019 ◽  
Vol 874 ◽  
pp. 699-719 ◽  
Author(s):  
Jose M. Lopez ◽  
George H. Choueiri ◽  
Björn Hof

Polymer additives can substantially reduce the drag of turbulent flows and the upper limit, the so-called state of ‘maximum drag reduction’ (MDR), is to a good approximation independent of the type of polymer and solvent used. Until recently, the consensus was that, in this limit, flows are in a marginal state where only a minimal level of turbulence activity persists. Observations in direct numerical simulations at low Reynolds numbers ($Re$) using minimal sized channels appeared to support this view and reported long ‘hibernation’ periods where turbulence is marginalized. In simulations of pipe flow at $Re$ near transition we find that, indeed, with increasing Weissenberg number ($Wi$), turbulence expresses long periods of hibernation if the domain size is small. However, with increasing pipe length, the temporal hibernation continuously alters to spatio-temporal intermittency and here the flow consists of turbulent puffs surrounded by laminar flow. Moreover, upon an increase in $Wi$, the flow fully relaminarizes, in agreement with recent experiments. At even larger $Wi$, a different instability is encountered causing a drag increase towards MDR. Our findings hence link earlier minimal flow unit simulations with recent experiments and confirm that the addition of polymers initially suppresses Newtonian turbulence and leads to a reverse transition. The MDR state on the other hand results at these low$Re$ from a separate instability and the underlying dynamics corresponds to the recently proposed state of elasto-inertial turbulence.


2012 ◽  
Vol 40 (2) ◽  
pp. 69-77 ◽  
Author(s):  
Shinji Tamano ◽  
Kotaro Miyagawa ◽  
Yohei Morinishi ◽  
Motoyuki Itoh ◽  
Keijiro Taga

Author(s):  
Alparslan Oztekin ◽  
Sudhakar Neti ◽  
Ananchai Ukaew

Spatial and temporal characteristics of turbulent pipe flows using nanofluids and dilute polymer solutions are examined by means of instantaneous differential pressure and velocity measurements. Spherical and elongated nanosilica particles (SiO2) are mixed into water to make nanofluid and polyacrylamide (PAC) is dissolved into water to make PAC solution. The effects of nanofluid on the drag reduction and turbulent structure are determined and compared with the effects of polymer additives on the turbulent structures and drag reduction. Suppression of turbulence near pipe wall was observed with the introduction of both spherical and elongated nanoparticles. Although experimental results show that nanofluids are not candidates for drag reduction unlike polymer additives, they do not increase pressure drop. Hence addition of nanoparticles into heat transfer fluids could have the potential for heat transfer enhancement in pipe flow without paying the penalty of increasing pumping power.


1988 ◽  
Vol 31 (9) ◽  
pp. 2518-2523 ◽  
Author(s):  
Hiromoto Usui ◽  
Katsuhiro Maeguchi ◽  
Yuji Sano

2010 ◽  
Vol 22 (11) ◽  
pp. 115103 ◽  
Author(s):  
F. Auteri ◽  
A. Baron ◽  
M. Belan ◽  
G. Campanardi ◽  
M. Quadrio

Sign in / Sign up

Export Citation Format

Share Document