Criticality Calculations and Basic Sensitivity/Uncertainty Investigation of LR-0 Benchmark Core

Author(s):  
Tomáš Czakoj ◽  
Evžen Losa

Three-dimensional Monte Carlo code KENO-VI of SCALE-6.2.2 code system was applied for criticality calculation of the LR-0 reactor core. A central module placed in the center of the core was filled by graphite, lithium fluoride-beryllium fluoride (FLIBE), and lithium fluoride-sodium fluoride (FLINA) compounds. The multiplication factor was obtained for all cases using both ENDF/B-VII.0 and ENDF/B-VII.1 nuclear data libraries. Obtained results were compared with benchmark calculations in the MCNP6 using ENDF/B-VII.0 library. The results of KENO-VI calculations are found to be in good agreement with results obtained by the MCNP6. The discrepancies are typically within tens of pcm excluding the case with the FLINA filling. Sensitivities and uncertainties of the reference case with no filling were determined by a continuos-energy version of the TSUNAMI sequence of SCALE-6.2.2. The obtained uncertainty in multiplication factor due to the uncertainties in nuclear data is about 650 pcm with ENDF/B-VII.1.

2019 ◽  
Vol 211 ◽  
pp. 03004
Author(s):  
Antonín Krása ◽  
Anatoly Kochetkov ◽  
Nadia Messaoudi ◽  
Alexey Stankovskiy ◽  
Guido Vittiglio ◽  
...  

Delayed neutron parameters of fast VENUS-F reactor core configurations are determined with Monte Carlo calculations using various nuclear data libraries. Differences in the calculated effective delayed neutron fraction and the impact of the delayed neutron data (6- or 8-group precursors) that are applied in the experimental data analysis on the measured reactivity effects are studied. Considerable differences are found due to application of 235U and 238U delayed neutron data from JEFF, JENDL and ENDF evaluations.


2020 ◽  
Vol 239 ◽  
pp. 22007 ◽  
Author(s):  
Donny Hartanto ◽  
Victor Gillette ◽  
Tagor Malem Sembiring ◽  
Peng Hong Liem

The Indonesian Multipurpose Research Reactor namely Reaktor Serba Guna G.A. Siwabessy (RSG GAS) is a 30 MWth (max.) pool-type reactor loaded with plate-type low-enriched uranium fuel, using light water as coolant and moderator, and beryllium as reflector. The benchmark of the 1st criticality core of RSG GAS using different nuclear data libraries such as JENDL-4.0, JENDL-3.3, ENDF/B-VII.0, and JEFF-3.1 have been performed in the previous work and compared with the experiment result. In this work, the newly released ENDF/B-VIII.0 neutron reaction and thermal neutron scattering libraries will be used and the important neu-tronics parameters such as multiplication factor, kinetics parameters, and fission reaction rate will be calculated using Monte Carlo code MCNP6.2 and compared against the previous work and the experiment result.


2019 ◽  
Vol 6 (1) ◽  
Author(s):  
Massimo Sarotto ◽  
Gabriele Firpo ◽  
Anatoly Kochetkov ◽  
Antonin Krása ◽  
Emil Fridman ◽  
...  

Abstract During the EURATOM FP7 project FREYA, a number of experiments were performed in a critical core assembled in the VENUS-F zero-power reactor able to reproduce the ALFRED lead-cooled fast reactor spectrum in a dedicated island. The experiments dealt with the measurements of integral and local neutronic parameters, such as the core criticality, the control rod and the lead void reactivity worth, the axial distributions of fission rates for the nuclides of major interest in a fast spectrum, the spectral indices of important actinides (238U, 239Pu, 237 Np) with respect to 235U. With the main aim to validate the neutronic codes adopted for the ALFRED core design, the VENUS-F core and its characterization measurements were simulated with both deterministic (ERANOS) and stochastic (MCNP, SERPENT) codes, by adopting different nuclear data libraries (JEFF, ENDF/B, JENDL, TENDL). This paper summarizes the main results obtained by highlighting a general agreement between measurements and simulations, with few discrepancies for some parameters that are discussed here. Additionally, a sensitivity and uncertainty analysis was performed with deterministic methods for the core reactivity: it clearly indicates that the small over-criticality estimated by the different codes/libraries resulted to be lower than the uncertainties due to nuclear data.


2016 ◽  
Vol 1814 ◽  
Author(s):  
A. A. P. Macedo ◽  
Carlos E. Velasquez ◽  
C. A. M. da Silva ◽  
C. Pereira

ABSTRACTThis paper studies the performance of (U, Pu)C fuel in a hexagonal assembly of a GFR (Gas Fast Reactor). The SCALE 6.0 (Standardized Computer Analysis for Licensing Evaluation version 6.0) code was used in the calculation. The goal is to evaluate the behavior of the infinite multiplication factor (kinf) for a heterogeneous assembly model using four nuclear data libraries: V6-238, V7-238, ENDF/B-VI.8 and ENDF/B-VII.0. The burnup of (U, Pu)C was performed by the TRITON-6 module, and the isotopic concentrations were evaluated during the cycle. The present work comprises calculations at Zero Power and Full Power condition. This study intends to achieve more information about different Fast Reactors.


2021 ◽  
Vol 7 (2) ◽  
pp. 103-109
Author(s):  
Olga N. Andrianova ◽  
Yury Ye. Golovko ◽  
Gleb B. Lomakov ◽  
Yevgeniya S. Teplukhina ◽  
Gennady M. Zherdev

The paper presents the results of a comparative analysis of criticality calculations using a Monte-Carlo code with the BNAB-93 and BNAB-RF neutron group constants, as well as with evaluated neutron data files from the Russian ROSFOND evaluated nuclear data library and other evaluated nuclear data libraries (ENDF, JEFF, JENDL) from different years. A set of integral experiments on BFS critical assemblies carried out in different years at the Institute of Physics and Power Engineering (60 different critical configurations) was analyzed. The considered integral experiments are included in the database of evaluated experimental neutronic data used to justify the neutronic performance of sodium and lead cooled fast reactors, to verify codes and nuclear data as well as to estimate uncertainties in neutronic parameters due to the nuclear data uncertainties. It has been shown that the ROSFOND evaluated nuclear data library is a library that minimizes the calculation and experimental discrepancies for the considered set of integral experiments. The paper also presents the results of criticality calculations for models of sodium and lead cooled fast reactors based on different evaluated neutron data libraries and provides estimates for the uncertainty in criticality associated with nuclear data.


Author(s):  
Masao Yamanaka

AbstractExcess reactivity and control rod worth are generally considered important reactor physics parameters for experimentally examining the neutron characteristics of criticality in a core, and for maintaining safe operation of the reactor core in terms of neutron multiplication in the core. For excess reactivity and control rod worth at KUCA, as well as at the Fast Critical Assembly in the Japan Atomic Energy Agency, special attention is given to analyzing the uncertainty induced by nuclear data libraries based on experimental data of criticality in representative cores (EE1 and E3 cores). Also, the effect of decreasing uncertainty on the accuracy of criticality is discussed in this study. At KUCA, experimental results are accumulated by measurements of excess reactivity and control rod worth. To evaluate the accuracy of experiments for benchmarks, the uncertainty originated from modeling of the core configuration should be discussed in addition to uncertainty induced by nuclear data, since the uncertainty from modeling has a potential to cover the eigenvalue bias more than uncertainty by nuclear data. Here, to investigate the uncertainty of criticality depending on the neutron spectrum of cores, it is very useful to analyze the reactivity of a large number of measurements in typical hard (EE1) and soft (E3) spectrum cores at KUCA.


Sign in / Sign up

Export Citation Format

Share Document