Design of a Micromix Fuel Injector for High Temperature Hybrid Concentrated Solar Power Plants

2014 ◽  
Author(s):  
Shane Coogan ◽  
Klaus Brun ◽  
David Teraji
Keyword(s):  
Power Plants ◽  
Solar Power ◽  
Inlet Temperature ◽  
Outlet Temperature ◽  
Fuel Injector ◽  
Concentrated Solar Power ◽  
Output Variability ◽  
Increased Risk ◽  
In Series ◽  
Solar Power Plants

The hybrid air Brayton concentrated solar power plant (CSP) combines a natural gas fired combustor in series with a traditional CSP system. The combination boosts turbine inlet temperature above the receiver temperature and reduces output variability. However, a combustor operating in this mode must tolerate an inlet air temperature equal to the solar receiver outlet temperature, which is expected to be as much as 1,000°C for next generation designs. High inlet temperature hybrid combustors must achieve low NOx emissions in spite of the increased risk for autoignition and flashback. In addition, the hybrid injector must be able to adjust to the variability inherent to the solar source. The design of a multibank micromix injector that meets these challenges is described with emphasis on its NOx and CO emissions characteristics.

Thermo-Economic Analyses and Comparisons of Two S-CO2-Brayton-Cycle-Based Combined Power Cycles for Concentrated Solar Power Plants

2018 ◽  
Author(s):  
Yuegeng Ma ◽  
Xuwei Zhang ◽  
Ming Liu ◽  
Jiping Liu
Keyword(s):  
Power Plants ◽  
Solar Power ◽  
Inlet Temperature ◽  
Brayton Cycle ◽  
Concentrated Solar Power ◽  
Power Cycles ◽  
Solar Power Plants ◽  
Cycle Efficiency ◽  
Concentrated Solar Power Plants ◽  
Residual Heat

In order to pursue superior cycle efficiency and lower power generation cost for the CSP plants, two S-CO2–Brayton–cycle–based power cycles with different utilization methods of the residual heat recover of the top S-CO2 Brayton cycle (SCBC) are investigated to seek alternatives to the stand-alone S-CO2 cycle as the power block of concentrated solar power plants. The residual heat released by the top S-CO2 cycle are either utilized to drive a LiBr absorption chiller (AC) for further chilling of the CO2 fluids exiting the precooler before entering the main compressor inlet temperature or recovered by an organic rankine cycle (ORC) for generating electricity. Thermo-economic analysis and optimization are performed for the SCBC–AC and SCBC–ORC, respectively. The results show that the thermal and exergetic efficiencies of the SCBC–AC are comparable with those of the SCBC–ORC in low pressure ratio conditions (PR<2.7) but are apparently lower than SCBC–ORC when PR is over 2.7. The LCOE of the CSP plant integrated with SCBC–AC is more sensitive to the change of PR. The optimal PR to maximum the cycle efficiency or minimize the plant LCOE for the SCBC–ORC is higher than that for the SCBC–AC, while the optimal recuperator effectiveness to minimize the LCOE of CSP plant integrated with SCBC–ORC is lower than that of SCBC–AC. The optimization results show that the thermo-economic performance of the SCBC–AC is comparable to that of the SCBC–ORC. Significant ηex improvement and LCOE reduction can be obtained by both the two combined cycles relative to the stand-alone S-CO2 cycle. The maximal ηex improvements obtained by the SCBC–ORC and SCBC–AC are 6.83% and 4.12%, respectively. The maximal LCOE reduction obtained by the SCBC-ORC and SCBC–AC are 0.70 ȼ / (kW·h) and 0.60 ȼ / (kW·h), respectively.

scholarly journals Potential of performance improvement of concentrated solar power plants by optimizing the parabolic trough receiver

2020 ◽  
Vol 14 (4) ◽  
pp. 867-881
Author(s):  
Honglun Yang ◽  
Qiliang Wang ◽  
Jingyu Cao ◽  
Gang Pei ◽  
Jing Li
Keyword(s):  
Heat Loss ◽  
Power Plants ◽  
Solar Power ◽  
Outlet Temperature ◽  
Positive Contribution ◽  
Concentrated Solar Power ◽  
Solar Absorption ◽  
Solar Power Plants ◽  
Freeze Protection ◽  
Concentrated Solar Power Plants

AbstractThis paper proposes a comprehensive thermodynamic and economic model to predict and compare the performance of concentrated solar power plants with traditional and novel receivers with different configurations involving operating temperatures and locations. The simulation results reveal that power plants with novel receivers exhibit a superior thermodynamic and economic performance compared with traditional receivers. The annual electricity productions of power plants with novel receivers in Phoenix, Sevilla, and Tuotuohe are 8.5%, 10.5%, and 14.4% higher than those with traditional receivers at the outlet temperature of 550°C. The levelized cost of electricity of power plants with double-selective-coated receivers can be decreased by 6.9%, 8.5%, and 11.6%. In Phoenix, the optimal operating temperature of the power plants is improved from 500°C to 560°C by employing a novel receiver. Furthermore, the sensitivity analysis of the receiver heat loss, solar absorption, and freeze protection temperature is also conducted to analyze the general rule of influence of the receiver performance on power plants performance. Solar absorption has a positive contribution to annual electricity productions, whereas heat loss and freeze protection temperature have a negative effect on electricity outputs. The results indicate that the novel receiver coupled with low melting temperature molten salt is the best configuration for improving the overall performance of the power plants.

scholarly journals Perspective on integration of concentrated solar power plants

2021 ◽  
Author(s):  
Bashria A A Yousef ◽  
Ahmed A Hachicha ◽  
Ivette Rodriguez ◽  
Mohammad Ali Abdelkareem ◽  
Abrar Inyaat
Keyword(s):  
Power Plants ◽  
Solar Power ◽  
Electrical Power ◽  
High Capacity ◽  
Solid Particles ◽  
Concentrated Solar Power ◽  
Power Fluctuation ◽  
Energy Technologies ◽  
Production Of Hydrogen ◽  
Solar Power Plants

Abstract Integration concept of energy resources can complement between the competing energy technologies. This manuscript presents a comprehensive review on the state-of-the-art of concentrated solar power (CSP) integration technology with various energy sources. Compared to CSP alone, integration of CSP and fossil fuel provides promising solution to solar energy intermittence, emissions and installation cost reduction, with 25% increase in electric power generation. On the other hand, integration of CSP with other sources such as geothermal and biomass can supply dispatchable power with almost zero emissions. The electricity produced via integrated CSP and photovoltaic (PV) has better power quality and less cost compared to that produced by PV alone or CSP alone, respectively. Integration of CSP and wind energy can meet peak demand, reduce power fluctuation and provide electrical power at a high capacity factor. However, the lack of reliable biomass, geothermal and wind data with the solar availability at specific locations is the main obstacle for the acceptance and further deployment of hybridization systems. The advantages and limitations of the hybrid technologies presented in this paper according to the literature are reviewed. Moreover, future directions of CSP such as production of hydrogen, solid particles receivers and the integration of supercritical carbon dioxide cycle are also discussed.

scholarly journals Concentrated Solar Power Plants with Molten Salt Storage: Economic Aspects and Perspectives in the European Union

2019 ◽  
Vol 2019 ◽  
pp. 1-10 ◽  
Author(s):  
Andrzej Bielecki ◽  
Sebastian Ernst ◽  
Wioletta Skrodzka ◽  
Igor Wojnicki
Keyword(s):  
Molten Salt ◽  
Molten Salts ◽  
Power Plants ◽  
Solar Power ◽  
Economic Aspects ◽  
The European Union ◽  
Concentrated Solar Power ◽  
Eu Legislation ◽  
Solar Power Plants ◽  
Concentrated Solar Power Plants

Concentrated solar power plants belong to the category of clean sources of renewable energy. The paper discusses the possibilities for the use of molten salts as storage in modern CSP plants. Besides increasing efficiency, it may also shift their area of application: thanks to increased controllability, they may now be used not only to cover baseload but also as more agile, dispatchable generators. Both technological and economic aspects are presented, with focus on the European energy sector and EU legislation. General characteristics for CSP plants, especially with molten salt storage, are discussed. Perspectives for their development, first of all in economic aspects, are considered.

Probabilistic assessment of concentrated solar power plants yield: The EVA methodology

2018 ◽  
Vol 91 ◽  
pp. 802-811 ◽  
Author(s):  
Carlos M. Fernández-Peruchena ◽  
Frank Vignola ◽  
Martín Gastón ◽  
Vicente Lara-Fanego ◽  
Lourdes Ramírez ◽  
...  
Keyword(s):  
Power Plants ◽  
Solar Power ◽  
Probabilistic Assessment ◽  
Concentrated Solar Power ◽  
Solar Power Plants ◽  
Concentrated Solar Power Plants
Sign in / Sign up

Export Citation Format

Share Document