Radiation Pressure in a Sound Wave

1950 ◽  
Vol 18 (1) ◽  
pp. 25-29 ◽  
Author(s):  
Robert T. Beyer
1994 ◽  
Vol 267 ◽  
pp. 1-22 ◽  
Author(s):  
Alexander A. Doinikov

The acoustic radiation pressure exerted by a plane — progressive or standing — sound wave on a compressible sphere suspended freely in a viscous fluid is calculated. In deriving the general expression for the radiation pressure, it is supposed that the radius of the sphere is arbitrary. Two limiting cases of interest are then considered. In the first of these, it is assumed that the sound wavelength is much larger than the radius of the sphere which is, in turn, much larger than the viscous wavelength, it being supposed that this condition is satisfied both outside and inside the sphere. In the second case, the situation is investigated when the radius of the sphere is small compared with the viscous wavelength which is, in turn, much smaller than the sound wavelength, it being supposed that this condition is satisfied, as before, both outside and inside the sphere. It is shown that in both cases the expressions for the radiation pressure are drastically different from the well-known expressions for the radiation pressure in a perfect fluid: the calculation of the radiation pressure from the formulae obtained for a perfect fluid in the cases when the effect of viscosity is not negligible gives both quantitatively and qualitatively wrong results.


2012 ◽  
Author(s):  
Bruno Moreira ◽  
Mauricio Kischinhevsky ◽  
Marcelo Zamith ◽  
Esteban Clua ◽  
Diego Brandao

Author(s):  
Rikushi KATO ◽  
Masanori MATSUSHITA ◽  
Hideyuki TAKAHASHI ◽  
Osamu MORI ◽  
Nobukatsu OKUIZUMI ◽  
...  

2013 ◽  
Vol 38 (4) ◽  
pp. 565-570 ◽  
Author(s):  
Bartłomiej Kruk

Abstract Research in termoacoustics began with the observation of the heat transfer between gas and solids. Using this interaction the intense sound wave could be applied to create engines and heat pumps. The most important part of thermoacoustic devices is a regenerator, where press of conversion of sound energy into thermal or vice versa takes place. In a heat pump the acoustic wave produces the temperature difference at the two ends of the regenerator. The aim of the paper is to find the influence of the material used for the construction of a regenerator on the properties of a thermoacoustic heat pump. Modern technologies allow us to create new materials with physical properties necessary to increase the temperature gradient on the heat exchangers. The aim of this paper is to create a regenerator which strongly improves the efficiency of the heat pump.


2006 ◽  
Vol 128 (6) ◽  
pp. 830-836 ◽  
Author(s):  
Yong-Ping Liu ◽  
Chuan Li ◽  
Kuo-Kang Liu ◽  
Alvin C. K. Lai

In this paper, the mechanical properties of erythrocytes were studied numerically based upon the mechanical model originally developed by Pamplona and Calladine (ASME J. Biomech. Eng., 115, p. 149, 1993) for liposomes. The case under study is the erythrocyte stretched by a pair of laser beams in opposite directions within buffer solutions. The study aims to elucidate the effect of radiation pressure from the optical laser because up to now little is known about its influence on the cell deformation. Following an earlier study by Guck et al. (Phys. Rev. Lett., 84, p. 5451, 2000; Biophys. J., 81, p. 767, 2001), the empirical results of the radiation pressure were introduced and imposed on the cell surface to simulate the real experimental situation. In addition, an algorithm is specially designed to implement the simulation. For better understanding of the radiation pressure on the cell deformation, a large number of simulations were conducted for different properties of cell membrane. Results are first discussed parametrically and then evaluated by comparing with the experimental data reported by Guck et al. An optimization approach through minimizing the errors between experimental and numerical data is used to determine the optimal values of membrane properties. The results showed that an average shear stiffness around 4.611×10-6Nm−1, when the nondimensional ratio of shear modulus to bending modulus ranges from 10 to 300. These values are in a good agreement with those reported in literature.


1991 ◽  
Vol 7 (Supple) ◽  
pp. 679-681
Author(s):  
TOSHIYUKI YAMAMOTO ◽  
TOHRU FUJII ◽  
TOMOKO MATSUI ◽  
TSUGUO SAWADA

1947 ◽  
Vol 19 (1) ◽  
pp. 290-291
Author(s):  
Francis M. Wiener
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document