Transverse variations of sound pressure in an ear canal occluded by a hearing aid

2006 ◽  
Vol 120 (5) ◽  
pp. 3159-3159
Author(s):  
Michael R. Stinson ◽  
Gilles A. Daigle
Keyword(s):  
2005 ◽  
Vol 16 (10) ◽  
pp. 781-788 ◽  
Author(s):  
Francis Kuk

The complaint from hearing aid wearers of hollowness in the sound of their voice is typically associated with excessive low-frequency sound pressure level (SPL) in the ear canal. Increasing the vent diameter and/or reducing the gain in the low frequency would typically minimize this complaint. This paper reports on a case where the origin of hollowness was insufficient low-frequency gain compared to a previous hearing aid fitting. It describes the systematic process that was followed in uncovering the origin of the patient's hollowness complaint. Clinicians might follow a similar objective approach in their fine-tuning process to resolve wearer complaints.


2021 ◽  
Vol 11 (2) ◽  
pp. 207-219
Author(s):  
Susan E. Ellsperman ◽  
Emily M. Nairn ◽  
Emily Z. Stucken

Bone conduction is an efficient pathway of sound transmission which can be harnessed to provide hearing amplification. Bone conduction hearing devices may be indicated when ear canal pathology precludes the use of a conventional hearing aid, as well as in cases of single-sided deafness. Several different technologies exist which transmit sound via bone conduction. Here, we will review the physiology of bone conduction, the indications for bone conduction amplification, and the specifics of currently available devices.


1965 ◽  
Vol 8 (2) ◽  
pp. 137-148 ◽  
Author(s):  
David P. Goldstein ◽  
Claude S. Hayes

This experiment tested the hypothesis that the occlusion effect is accompanied by an increase in sound pressure level in the external auditory canal. Pure tone bone conduction thresholds and sound pressure levels were measured, first with the ear canal open, then with the ear canal closed, at two positions of the bone vibrator and at five frequencies in 28 normal listeners. Statistical analyses revealed a significant difference between measures at 250, 500, and 1 000 cps but not at 2 000 and 4 000 cps. Average sound pressure level shifts tended to be larger than their threshold measure counterparts. The two measures, nevertheless, yielded positive correlations.


1989 ◽  
Vol 10 (4) ◽  
pp. 254-258 ◽  
Author(s):  
Judith A. Feigin ◽  
Judy G. Kopun ◽  
Patricia G. Stelmachowicz ◽  
Michael P. Gorga

2018 ◽  
Vol 37 (4) ◽  
pp. 1030-1036 ◽  
Author(s):  
Niloofar Ziayi Ghahnavieh ◽  
Siamak Pourabdian ◽  
Farhad Forouharmajd

Sound is one of the most important problems in industrial environments, and it causes hearing loss at different frequencies in the workforce. Incorrect fitting of hearing protector has a negative effect on noise reduction. The present study was conducted with the aim of determination of the effective frequencies on hearing loss and variations of the sound level in different frequencies after placing the earplug. A model of ear canal with different materials was simulated. Sound pressure sensors and earplugs were placed in both sides of the ear canal. The rates of sound reduction in octave frequency signals were calculated for the simulated canal of different materials, in different distances between the microphone and the earplug with Labview software. The results of sound simulation in octave frequency signals showed that by increasing the frequency, the rates of sound reduction in different conditions also had an increasing trend. The obtained peak rates for all the situations coincided with each other at fixed frequencies. In most cases, a noise reduction in the frequency of 4000 Hz showed a high number. The maximum sound reduction was observed at 25.5 mm at frequencies below 250 Hz, which was similar to the average of human ear canal length; so the simulated model can be used to determine the performance of the protective earphones and test them at different frequencies and sound pressure levels.


2005 ◽  
Vol 117 (4) ◽  
pp. 2564-2564
Author(s):  
Michael R. Stinson ◽  
Gilles A. Daigle

Sign in / Sign up

Export Citation Format

Share Document