Flame ionization detector response to coeluting hydrocarbons and carbon disulphide and its application to the determination of the sum of C6-C11 alkanes and cycloalkanes in air

1983 ◽  
Vol 48 (3) ◽  
pp. 722-734
Author(s):  
Martin Koval
Keyword(s):  
Carbon Disulphide ◽  
Internal Standard ◽  
Calibration Procedure ◽  
Detector Response ◽  
Column Temperature ◽  
Flame Ionization ◽  
Other Substances ◽  
Flame Ionisation Detector ◽  
Ionisation Detector

The flame ionisation detector response to C6-C11 aliphatic hydrocarbon solutions in carbon disulphide in the concentration range between 1.3-9.5 mg ml-1 retained lineary despite the excess of solvent entering the detector simultaneously with the analyte. Pure carbon disulphide exhibited a small positive detector response which did not interfere in calibration procedure and which, under certain GC conditions, inverted to negative values. This response was not proportional to the injected volume and was strongly influenced by the column temperature and/or bleed. On the basis of these findings, a method compatible with the widely used charcoal tube carbon disulphide desorption procedure was developed and evaluated. It consists of static desorption of the sum of aliphatic alkanes and cycloalkanes from the activated charcoal after which an internal standard is added to the supernatant eluate. The resulting carbon disulphide solution is analysed on a highly polar stationary phase 1,2,3-tris(2-cyanoethoxy)propane where the solvent and the analyte coelute in a single peak, the height of which is practically proportional to the sum of alkanes and cycloalkanes present. This also makes determinations of other substances present in the sample more simple. The field test of the proposed method yielded values comparable in precision and accuracy with a control infrared spectrophotometric method.

Gas-Liquid Chromatographic Determination of Oxydemeton-Methyl in Commercial Formulations

1978 ◽  
Vol 61 (3) ◽  
pp. 500-503
Author(s):  
Leonard R Schronk ◽  
Billy M Colvin ◽  
Alan R Hanks
Keyword(s):  
Rapid Determination ◽  
Internal Standard ◽  
Chromatographic Determination ◽  
Peak Height ◽  
Detector Response ◽  
Gel Chromatography ◽  
Gas Liquid Chromatography ◽  
Flame Ionization ◽  
Silica Gel Chromatography

Abstract Flame ionization gas-liquid chromatography (GLC) with a 10% DC-200 on 80-100 mesh Gas-Chrom Q column is used for the rapid determination of oxydemeton-methyl in commercial formulations. The detector response is linear for 1.0–10.0 μg oxydemeton-methyl, with a sensitivity of 4 ng. The column was stabilized before analysis by injection of a lecithin solution. Samples were diluted with chloroform and injected; peak height ratios were used for quantitation with fluoranthrene as the internal standard. Carbaryl was removed from mixed formulations by silica gel chromatography, oxydemeton- methyl was eluted with methanolchloroform (2+98), and the eluate was collected for infrared (IR) and GLC analyses. Methoxychlor and Karathane were removed by chromatography on Florisil before IR analysis. GLC results compare favorably with those for IR, with recoveries ranging from 98.44 to 102.88% for spiked formulations.

Determination of Vanillin and Ethyl Vanillin by Gas-Liquid Chromatography

1964 ◽  
Vol 47 (3) ◽  
pp. 561-562 ◽  
Author(s):  
Glenn E Marten ◽  
Frank J Feeny ◽  
Frank P Scaringelli
Keyword(s):  
Liquid Chromatography ◽  
Rapid Method ◽  
Internal Standard ◽  
Flame Ionization Detector ◽  
Gas Liquid Chromatography ◽  
Ionization Detector ◽  
Ethyl Vanillin ◽  
Flame Ionization ◽  
Other Substances

Abstract A rapid method has been developed in which gas-liquid chromatography is used to separate vanillin and ethyl vanillin in vanilla samples and determine them quantitatively. A flame ionization detector is used for the vanillin determination. 2-Phenoxyethanol is used as internal standard. The presence of any other substances is eliminated.

Gas-chromatographic determination of cholesterol sulfate in plasma and erythrocytes, for the diagnosis of recessive X-linked ichthyosis.

1983 ◽  
Vol 29 (7) ◽  
pp. 1404-1407 ◽  
Author(s):  
F A Muskiet ◽  
G Jansen ◽  
B G Wolthers ◽  
A Marinkovic-Ilsen ◽  
P C van Voorst Vader
Keyword(s):  
Internal Standard ◽  
Dehydroepiandrosterone Sulfate ◽  
Chromatographic Determination ◽  
Anion Exchange Chromatography ◽  
Exchange Chromatography ◽  
Single Step ◽  
Flame Ionization Detection ◽  
Cholesterol Sulfate ◽  
Flame Ionization

Abstract We describe a rapid method for determining cholesterol sulfate in plasma and erythrocytes. After its single-step isolation by means of anion-exchange chromatography cholesterol sulfate is hydrolyzed, trimethylsilylated, and determined by gas chromatography with flame ionization detection. 5 beta-Cholestan-3 alpha-ol sulfate is used as internal standard. The method enables simultaneous determination of dehydroepiandrosterone sulfate in plasma. We applied it for the diagnosis of seven patients with recessive X-linked ichthyosis. Concentrations are given for plasma and erythrocytes from four unaffected relatives of patients with X-linked ichthyosis, a patient with placental sulfatase deficiency, two patients with other types of ichthyoses, and 20 controls. The method may also be of use for the rapid isolation of other organic sulfates from biological material, as illustrated by a comparison of gas chromatograms of urine from a normal pregnant woman and that from a patient with placental sulfatase deficiency.

Determination of Phenothiazine and Several of its Derivatives by Gas-Liquid Chromatography

1966 ◽  
Vol 49 (4) ◽  
pp. 857-859
Author(s):  
C L Bramlett
Keyword(s):  
Liquid Chromatography ◽  
Internal Standard ◽  
Flame Ionization Detector ◽  
Gas Liquid Chromatography ◽  
Chromatographic Technique ◽  
Ionization Detector ◽  
Flame Ionization ◽  
Hydrogen Flame

Abstract Phenothiazine, promethazine.HCl, chlorpromazine. HCl, promazine.HCl, and levomepromazine. HCl were chromatographed satisfactorily on a column containing 5% Apiezon L coated on Anakrom ABS, 100/110 mesh, using a hydrogen-flame ionization detector. This gas chromatographic technique is rapid and more specific than existing official methods. The use of an internal standard to improve precision will be investigated.

Capillary Gas Chromatographic Determination Of Cypermethrin In Formulations: Collaborative Study

1985 ◽  
Vol 68 (3) ◽  
pp. 592-595
Author(s):  
Peter D Bland
Keyword(s):  
Active Ingredient ◽  
Collaborative Study ◽  
Internal Standard ◽  
Chromatographic Determination ◽  
Fused Silica ◽  
Flame Ionization ◽  
Wettable Powder ◽  
Peak Areas ◽  
Liquid Concentrate

Abstract A method is described for the determination of cypermethrin, 3-(2,2- dichloroethenyl)-2,2-dimethyl-cyclopropanecarboxylate cyano-(3- phenoxyphenyl)methyl ester, in technical and formulated material by capillary gas chromatography (CGC). Samples of technical or formulated material are dissolved in CH2Cl2 containing dicyclohexyl phthalate as internal standard. The solution is injected into a gas chromatograph fitted with a flame ionization detector and capillary column of 25 m x 0.32 mm fused silica with a thick film OV-1 phase at 240°C. Injection is made into a heated injection port fitted with an antidiscrimination device in a split mode. Peak areas obtained at retention times of the internal standard and active ingredient are measured with an integrator. The quantity of cypermethrin is determined by comparing the internal standard and active ingredient peak areas with those obtained from a calibration solution containing known amounts of internal standard and pure active ingredient. Five samples were chosen for collaborative study: technical cypermethrin, 70% liquid concentrate, 3 lb/US gal. emulsifiable, 3 ib/US gal. oil concentrate, and 40% wettable powder. Twelve collaborators carried out replicate determinations on each sample on separate days. Coefficients of variation between laboratories (CVX) were 2.13 for the technical, 2.94 for the emulsifiable concentrate, 3.51 for the liquid concentrate, 2.66 for the wettable powder, and 2.29 for the oil concentrate. The method was adopted official first action.

Determination of Pyrantel in Swine Liver by Flame Ionization Gas Chromatography and Confirmation by Gas Chromatography /Mass Spectrometry

1990 ◽  
Vol 73 (6) ◽  
pp. 883-886
Author(s):  
Susan S.C Tai ◽  
Nancy Cargile ◽  
Charlie J Barnes ◽  
Philip Kijak
Keyword(s):  
Mass Spectrometry ◽  
Gas Chromatography ◽  
Internal Standard ◽  
Gas Chromatography Mass Spectrometry ◽  
Tissue Samples ◽  
Flame Ionization ◽  
Chromatography Mass Spectrometry ◽  
Ionization Method ◽  
Swine Liver

Abstract During an evaluation of the gas chromatography/mass spectrometry (GC/MS) confirmatory procedure of Lynch and Bartoluccl for pyrantel residues in swine tissues, we developed a GC flame Ionization method for quantltatlng pyrantel residues In extracts of swine liver. The method was subjected to trial principally In the laboratories of Biospherics, Inc., using control liver, fortified control liver, and Incurred liver tissue samples. Although the method does not meet all of the current Food and Drug Administration criteria, it compares favorably to the official determinative method. Portions of the same extract can be used for quantitation and for GC/MS confirmation, true recoveries appear to be slightly higher, and an internal standard Is not required. The precision of this method equals or exceeds that of the official determinative method.

Gas-Liquid Chromatographic Determination of Tetradif on Technical and Formulations: Collaborative Study

1981 ◽  
Vol 64 (4) ◽  
pp. 829-832
Author(s):  
Bram Van Rossum ◽  
Albertus Martijn ◽  
James E Launer ◽  
◽  
E C Calamita ◽  
...  
Keyword(s):  
Collaborative Study ◽  
Internal Standard ◽  
Chromatographic Determination ◽  
Flame Ionization ◽  
Coefficients Of Variation ◽  
Liquid Chromatographic Determination ◽  
Liquid Chromatographic

Abstract The gas-liquid chromatographic determination of tetradifon technical and formulations was collaboratively studied in duplicate with 12 laboratories. Six samples were dissolved in dichloroethane with n-hexacosane as the internal standard, chromatographed on a column of 3% SE-52, and detected by flame ionization. The average coefficients of variation were 1.2% for the 2 technical samples, 1.6% for the 2 wettable powders, and 1.5% for the 2 emulsifiable concentrates. The method has been adopted official first action.

Gas-Liquid Chromatographic Determination of Pyridazinones in Technical Products and Formulations

1978 ◽  
Vol 61 (1) ◽  
pp. 161-163
Author(s):  
Giuseppe Cellerino ◽  
Mariarosa Re
Keyword(s):  
Internal Standard ◽  
Standard Technique ◽  
Chromatographic Determination ◽  
Gas Liquid Chromatography ◽  
Flame Ionization ◽  
Selective Detector ◽  
Liquid Chromatographic Determination ◽  
Liquid Chromatographic ◽  
Technical Products

Abstract Simultaneous determination of the active ingredient and of by-products in technical and formulated pyridazinones was rapidly performed by gas-liquid chromatography with complete resolution of all compounds. Quantitative determination by the internal standard technique is accurate and precise. The lower limit of detectability is 8 × 10–12 g/sec with a flame ionization detector and 1 × 10–12 g/sec with a nitrogen-phosphorus selective detector operating in the nitrogen mode.

Determination of volatile alcohols and acetone in serum by non-polar capillary gas chromatography after direct sample injection.

1984 ◽  
Vol 30 (10) ◽  
pp. 1672-1674 ◽  
Author(s):  
N B Smith
Keyword(s):  
Gas Chromatography ◽  
Capillary Gas Chromatography ◽  
Capillary Column ◽  
Internal Standard ◽  
Fused Silica ◽  
Gas Chromatograph ◽  
Ionization Detector ◽  
Flame Ionization ◽  
Split Ratio

Abstract In this method for detection and quantification of volatile alcohols by capillary gas chromatography, the serum sample is deproteinized, then directly injected into the gas chromatograph with 1-propanol as the internal standard. The capillary column is a 30-m bonded methylsilicone-coated, fused-silica column. With helium as the carrier gas, the injector inlet is set at a split ratio of 1/30 and the average linear velocity in the column is 25 cm/s. Injector and flame-ionization detector temperatures are 280 degrees C, oven temperature 35 degrees C. Chromatography time is less than 3 min.

Sign in / Sign up

Export Citation Format

Share Document