scholarly journals Statistical modelling for recurrent injury events: an application to Rugby League injuries

2010 ◽  
Vol 16 (Supplement 1) ◽  
pp. A191-A191
Author(s):  
S. Ullah ◽  
C. F. Finch ◽  
T. J. Gabbett
2002 ◽  
Vol 7 (4) ◽  
pp. 8-10
Author(s):  
Christopher R. Brigham ◽  
Leon H. Ensalada

Abstract Recurrent radiculopathy is evaluated by a different approach in the AMA Guides to the Evaluation of Permanent Impairment (AMA Guides), Fifth Edition, compared to that in the Fourth Edition. The AMA Guides, Fifth Edition, specifies several occasions on which the range-of-motion (ROM), not the Diagnosis-related estimates (DRE) method, is used to rate spinal impairments. For example, the AMA Guides, Fifth Edition, clarifies that ROM is used only for radiculopathy caused by a recurrent injury, including when there is new (recurrent) disk herniation or a recurrent injury in the same spinal region. In the AMA Guides, Fourth Edition, radiculopathy was rated using the Injury Model, which is termed the DRE method in the Fifth Edition. Also, in the Fourth Edition, for the lumbar spine all radiculopathies resulted in the same impairment (10% whole person permanent impairment), based on that edition's philosophy that radiculopathy is not quantifiable and, once present, is permanent. A rating of recurrent radiculopathy suggests the presence of a previous impairment rating and may require apportionment, which is the process of allocating causation among two or more factors that caused or significantly contributed to an injury and resulting impairment. A case example shows the divergent results following evaluation using the Injury Model (Fourth Edition) and the ROM Method (Fifth Edition) and concludes that revisions to the latter for rating permanent impairments of the spine often will lead to different results compared to using the Fourth Edition.


Erdkunde ◽  
2008 ◽  
Vol 62 (2) ◽  
pp. 101-115 ◽  
Author(s):  
Heiko Paeth ◽  
Arcade Capo-Chichi ◽  
Wilfried Endlicher

2021 ◽  
Vol 13 (2) ◽  
pp. 973
Author(s):  
Gigel Paraschiv ◽  
Georgiana Moiceanu ◽  
Gheorghe Voicu ◽  
Mihai Chitoiu ◽  
Petru Cardei ◽  
...  

Our paper presents the hammer mill working process optimization problem destined for milling energetic biomass (MiscanthusGiganteus and Salix Viminalis). For the study, functional and constructive parameters of the hammer mill were taken into consideration in order to reduce the specific energy consumption. The energy consumption dependency on the mill rotor spinning frequency and on the sieve orifices in use, as well as on the material feeding flow, in correlation with the vegetal biomass milling degree was the focus of the analysis. For obtaining this the hammer mill was successively equipped with 4 different types of hammers that grind the energetic biomass, which had a certain humidity content and an initial degree of reduction ratio of the material. In order to start the optimization process of hammer mill working process, 12 parameters were defined. The objective functions which minimize hammer mill energy consumption and maximize the milled material percentage with a certain specific granulation were established. The results obtained can serve as the basis for choosing the optimal working, constructive, and functional parameters of hammer mills in this field, and for a better design of future hammer mills.


Sign in / Sign up

Export Citation Format

Share Document