Optimized Active Power Management in Solar PV-Fed Transformerless Grid-Connected System for Rural Electrified Microgrid

2020 ◽  
pp. 2150039
Author(s):  
Bekkam Krishna ◽  
T. S. Bheemraj ◽  
V. Karthikeyan
Keyword(s):  
Renewable Energy ◽  
Power Management ◽  
Energy Systems ◽  
Primary Objective ◽  
Active Power ◽  
Current Control ◽  
Voltage Source ◽  
Solar Pv ◽  
Constant Power ◽  
Renewable Energy Systems

Dynamic voltage instability is one of the major issues faced by grid-connected renewable energy systems due to fluctuations in the generation and sudden variation in the loads. The primary objective of this paper is to propose a method for constant power consumption from the grid to maintain a stable DC-link voltage during peak and nonpeak hours. It can be achieved by implementing an optimized active power management (OAPM) scheme between the photovoltaic (PV) and the grid by enabling a battery energy storage system (BESS). The intelligent constant power balance (ICPB) algorithm and detailed control strategies for dual active bridge (DAB) isolated DC–DC converter and grid-connected voltage source inverter (VSI) are discussed in this paper. Moreover, the high-gain step-up DC–DC converter (HSDC) is utilized to perform maximum power point tracking (MPPT) operation and to meet the required DC-link voltage. The accuracy of power transmission of DAB gets improved by imposing a curve-fitting interpolation (CFI) approach, thereby maintaining a constant DC-link voltage. Furthermore, an instantaneous sinusoidal current control (ISCC) scheme assures the feeding of active power with better power quality. The measured results are obtained and verified under different dynamic conditions of load and generation. Based on the validation, we conclude that the proposed OAPM scheme is most suitable for grid-connected renewable energy systems in the rural electrified microgrid.

scholarly journals Realization of a Small Residential Building with Zero CO2 Emissions Due to Energy Use in Crete, Greece

2017 ◽  
Vol 4 (1) ◽  
pp. 112 ◽  
Author(s):  
John Vourdoubas
Keyword(s):  
Renewable Energy ◽  
Energy Consumption ◽  
Co2 Emissions ◽  
Energy Use ◽  
Residential Building ◽  
Energy Systems ◽  
Solar Pv ◽  
Renewable Energy Systems ◽  
The Creation ◽  
Solid Biomass

European buildings account for large amounts of energy consumption and CO2 emissions and current EU policies target in decreasing their energy consumption and subsequent CO2 emissions. Realization of a small, grid-connected, residential building with zero CO2 emissions due to energy use in Crete, Greece shows that this can be easily achieved. Required heat and electricity in the building were generated with the use of locally available renewable energies including solar energy and solid biomass. Annual energy consumption and on-site energy generation were balanced over a year as well as the annual electricity exchange between the building and the grid. Technologies used for heat and power generation included solar-thermal, solar-PV and solid-biomass burning which are reliable, mature and cost-effective. Annual energy consumption in the 65 m2 building was 180 KWh/m2 and its annual CO2 emissions were 84.67 kgCO2/m2. The total capital cost of the required renewable energy systems was estimated at approximately 10.77% of its total construction cost, and the required capital investments in renewable energy systems, in order to achieve the goal of a residential building with zero CO2 emissions due to energy use, were 1.65 € per kgCO2, saved annually. The results of this study prove that the creation of zero CO2 emissions buildings is technically feasible, economically attractive and environmentally friendly. Therefore they could be used to create future policies promoting the creation of this type of building additionally to the existing policies promoting near-zero energy buildings.

Optimal Network Reconfiguration in Presence of Renewable Distributed Generation Using Evolutionary Algorithm

2021 ◽  
Vol 4 (2) ◽  
pp. 38-43
Author(s):  
Linta Khalil ◽  
Mughees Riaz ◽  
M.Arslan Iqbal Awan ◽  
M.Kamran Liaquat Bhatti ◽  
Rabbia Siddique ◽  
...  
Keyword(s):  
Renewable Energy ◽  
Energy Systems ◽  
Active Power ◽  
Optimal Size ◽  
Network Reconfiguration ◽  
Power Losses ◽  
Gas Emissions ◽  
Renewable Energy Systems ◽  
Optimal Network ◽  
Active Power Losses

Utilization of new technologies and people lifestyle has greatly affected the world’s electricity market. This demands to design innovative renewable energy systems for efficient use of green energy. In terms of greenhouse gas emissions, electricity from traditional energy supplies has become particularly harmful for the world. To decrease the reliance on fossil fuels, it is need of time to enhance the renewable energy integration in the conventional energy systems. Renewable DGs integration in existing energy systems is not a simple task. To overcome challenges caused by enhanced penetration of renewable energy systems in existing networks, adaptation of smart techniques is essential. DGs Optimal size and selection of their suitable location for integration is crucial for cost effective power delivery to the consumers without compromising the quality of power. This paper presents impartial performance management by optimal network reconfiguration in parallel with renewable DGs and selecting suitable size for reducing active power losses, pollutant gas emissions and costs of annual operation. For analysis of active power losses, Fuzzy and SPEA2 based algorithms are used in MATLAB with IEEE BUS14 acting as load bus. While the cost of power generation and pollutant gases emissions are estimated using HOMER Pro software.

Sign in / Sign up

Export Citation Format

Share Document