Selection of a local area network for the Cronus distributed operating system

1983 ◽  
Vol 13 (3) ◽  
pp. 25-35
Author(s):  
Kenneth T. Pogran
2020 ◽  
Author(s):  
Sasqia Ismi Aulia ◽  

This study aims to design a LAN network for data backup systems that are in accordance with certain aspects such as the selection of network design, network hardware, network transmission media, network connection devices, and network operating systems. Data is the most important thing for everyone, data can usually be reused even though it has not been used for some time, and therefore data storage is a serious problem that must be considered. Data on the server computer is very important to be maintained so that a backup process is needed on that data to another computer that is used as a backup in the event of damage to the hardware and software of the server computer. FTP is one of the solutions to the problems faced above,where FTP can be used to process the download and upload between the server and client computers. This design uses the Autobot system. The expected benefit in designing this LAN is that the existing network at SMP Negeri 6 Pekanbaru is not only used by employees and employees but can be used and enjoyed by teachers and students to access the internet anywhere as long as it is still within the scope of the SMP Negeri 6 area Pekanbaru.


2015 ◽  
Vol 32 (1) ◽  
pp. 97-111 ◽  
Author(s):  
D. K. Rawal ◽  
Mangey Ram ◽  
V. V. Singh

Purpose – The purpose of this paper is to find the reliability measures of Linux operating system connected in local area network (LAN). Design/methodology/approach – The system has two different topologies, i.e. star topology (subsystem-1) and bus topology (subsystem-2), are placed at two different places, and connected to a server through a hub. Both the topologies have n clients. The system has partial failure and complete failure. The partial failure is of two type’s namely minor partial and major partial. The minor partial failure degrades the system whereas the major partial failure brings the system to a break down mode. The system can completely fail due to failure of server hacking and blocking. Findings – By using supplementary variable technique and Laplace transformation, by taking different types of failure and two types of repairs the availability, non-availability, mean time to failure and cost analysis (expected profit) of the design system have been obtained. Originality/value – In this research, a mathematical model of Linux operating system has been discussed from which one can check the behavioral analysis of the designed system.


Compiler ◽  
2015 ◽  
Vol 4 (1) ◽  
Author(s):  
Eko Teguh Prasetyo ◽  
Nurcahyani Dewi Retnowati

Smartphones with Android operating system is one proof that the very quickly progress of technology. Functions and services on Android smartphones is no longer just for communication but also for entertainment such as games. Application are made in this research is a game that applies artificial intelligence with pathfinding techniques and can be played in single player and two players using the wireless local area network as data traffic lane with distribution techniques client server and can be played on smartphones with Android operating system. Software used to create this game is the Unity 3D engine. Unity 3D is a game creator software that is very powerful at this time. By using Unity 3D can make a game in a variety of devices, one of which is on a smartphones with Android operating system. With the application of this game can be a means the entertainment for anybody.


2020 ◽  
Vol 7 (6) ◽  
pp. 1205
Author(s):  
Abdul Jalil

<p>Salah satu tantangan di era revolusi industri 4.0 adalah pengembangan sistem kontrol secara jarak jauh menggunakan koneksi jaringan nirkabel. Tujuan penelitian ini adalah membangun sistem kontrol perangkat elektronik jarak jauh dengan memanfaatkan jaringan <em>wireless tethering </em>pada <em>smartphone</em> menggunakan topologi <em>Wireless Local Area Network</em> (WLAN) dan <em>Robot Operating System</em> (ROS) sebagai perangkat lunak kontrol. Pemanfaatan <em>wireless tethering smartphone</em> untuk berbagi koneksi internet dapat dimanfaatkan untuk mengontrol perangkat elektronik yang terkoneksi ke Raspberry Pi. Koneksi jaringan <em>wireless tethering</em> memiliki arsitektur jaringan yang cukup sederhana jika dibandingkan dengan arsitektur pengontrolan jarak jauh lainnya, serta memiliki jarak jangkau koneksi yang cukup jauh dibandingkan dengan koneksi Bluetooth. Metodologi yang digunakan untuk mengontrol perangkat elektronik pada penelitian ini adalah menggunakan <em>Remote Access Control</em> (RAC) berbasis protokol SSH. Pemanfaatan <em>wireless tethering</em> dan aplikasi <em>mobile</em> SSH dapat digunakan untuk mengirim perintah ROS <em>message</em> dari <em>smartphone</em> ke Raspberry Pi untuk mengontrol pin GPIO Raspberry Pi agar aktif <em>high</em> atau aktif <em>low</em>. Pada saat ROS <em>message</em> mengirim perintah ke GPIO untuk aktif <em>high</em>, maka sistem akan memberikan instruksi kepada relay untuk menyalakan perangkat elektronik. Selanjutnya pada saat GPIO menerima perintah untuk aktif <em>low</em>, maka sistem akan memberikan instruksi kepada relay untuk mematikan perangkat elektronik. Hasil penelitian ini adalah <em>smartphone </em>android dapat digunakan untuk mengontrol perangkat elektronik seperti lampu, kipas angin, pemanas ruangan, dan <em>air conditioner</em> secara jarak jauh menggunakan jaringan WLAN berdasarkan perintah dari ROS <em>message</em>. Perangkat elektronik pada penelitian ini dapat di kontrol secara efektif pada jarak 20 meter di dalam ruangan dan 40 meter di area bebas hambatan.</p><p> </p><p class="Judul2"><strong><em>Abstract</em></strong></p><p class="Abstract"><em>One of the challenges in the Industrial Revolution 4.0 is the development of control systems by remotely using a wireless network connection. This study aims to build a control system for controlling the electronic devices by remotely with the utilization of wireless tethering network in the smartphone used Wireless Local Area Network (WLAN) topology and Robot Operating System (ROS) as software for the controller. Utilization of wireless tethering in the smartphone for share the internet connection can be used for control the electronic devices that connected to the Raspberry Pi. The connection of wireless tethering has a simple architecture when compared with the other architecture of the control system by remotely, it then has a long-range connection when compared to the Bluetooth connection. The methodology has used to manage the electronic devices in this study is used Remote Access Control (RAC) based on SSH protocol. The utilization of wireless tethering and mobile SSH can be used to sends ROS message command from smartphone to the Raspberry Pi to control the Raspberry Pi GPIO pin to active high or active low. When android smartphone send ROS message command to the Raspberry Pi to make the GPIO to active high, the system will instruct the relay to turn on the electronic devices. Then when GPIO accepts the instruction to active low, the system will instruct the relay to turn off the electronic devices. The result of this study is that android smartphone can be used to control the electronic devices such as a lamp, fan, heater, and air conditioner by remotely used WLAN network and command from ROS message. The electronic devices on this study can be controlled by effectively with the distance of 20 meters in the rooms and 40 meters at the outside area. </em></p><p class="Judul2"><strong><em><br /></em></strong></p>


2021 ◽  
Vol 1 (1) ◽  
pp. 13-19
Author(s):  
Ayyub Ramli ◽  
Sriyono Sriyono ◽  
Harry Ramza

Perkembangan teknologi informasi tidak bisa dipisahkan dari perkembangan teknologi dan infrastruktur jaringan komputer. Pembuatan suatu jaringan diperlukan perancangan dan simulasi terlebih dahulu supaya hasilnya sesuai dengan keinginan atau mendapatkan sesuatu yang maksimal. Banyak sekali komponen yang dapat digunakan untuk perancangan seperti router. Router sendiri memiliki banyak system operasi contohnya router MikrotikOS. Jurnal ini untuk merancang dan mensimulasikan jaringan komputer. Perancangan dan simulasi jaringan komputer dapat menggunakan aplikasi Graphical Network Simulator 3(GNS3). GNS3 adalah software simulasi jaringan komputer berbasis GUI yang mirip dengan Cisco Packet Tracer. Namun pada GNS3 memungkinkan simulasi jaringan yang komplek, karena menggunakan operating system asli dari perangkat jaringan seperti cisco, mikrotik dan juniper. Sehingga kita berada kondisi lebih nyata dalam mengkonfigurasi router langsung daripada di Cisco Packet Tracer. Berbeda dengan Cisco Packet Tracer, pada GNS3 harus menginstal terlebih dahulu system operasi dari router itu sendiri yaitu router MikrotikOS maupun CiscoIOS. Di dalam penulisan ini akan dibahas mengenai bagaimana merancang dan mensimulasikan jaringan komputer menggunakan aplikasi GNS3 dengan konfigurasi yang baik dan benar sehingga dapat diterapkan dengan baik.


Author(s):  
Muhammad Iqbal Nahwi ◽  
Edy Victor Haryanto ◽  
Budi Triandi

<p>ABSTRAK <br /> <br />Pada saat ini data telekomunikasi dalam kehidupan manusia sangatlah penting, baik untuk berhubungan antara manusia dalam hal pemenuhan kebutuhan dan informasi maupun hiburan. Sedangkan secara nyata, utuk biaya komunikasi di negara indonesia masih termasuk mahal. Pemanfaatan teknologi VoIP dalam komunikasi yang murah, aman dengan kualitas yang cukup baik sangat tepat untuk diterapkan di negara ini. Pada teknologi VoIP ini berkomunikasi melalui telepon tidak hanya bisa dilakukan dengan mengandalkan pesawat telepon konvensional maupun handphone, namun melalui jaringan internet juga bisa dilakukannya. Dalam penelitian ini metodologi yang digunakan adalah mengimplementasi sistem VoIP pada linux trixbox. Infrastruktur jaringan VoIP yang dirancang menggunakan protokol SIP(session initiation protokol) <br />sebagai protokol komunikasi, memanfaatkan free software linux Trixbox sebagai operating system, asteriks sebagai aplikasi server, dan di sisi client menggunakan softphone X-lite. aplikasi Keyyo VoIP digunakan untuk client pada smartphone.</p>


1981 ◽  
Vol 1 (1) ◽  
pp. 21 ◽  
Author(s):  
David Hutchison ◽  
Doug Shepherd

1991 ◽  
Vol 30 (01) ◽  
pp. 53-64 ◽  
Author(s):  
R. Schosser ◽  
C. Weiss ◽  
K. Messmer

This report focusses on the planning and realization of an interdisciplinary local area network (LAN) for medical research at the University of Heidelberg. After a detailed requirements analysis, several networks were evaluated by means of a test installation, and a cost-performance analysis was carried out. At present, the LAN connects 45 (IBM-compatible) PCs, several heterogeneous mainframes (IBM, DEC and Siemens) and provides access to the public X.25 network and to wide-area networks for research (EARN, BITNET). The network supports application software that is frequently needed in medical research (word processing, statistics, graphics, literature databases and services, etc.). Compliance with existing “official” (e.g., IEEE 802.3) and “de facto” standards (e.g., PostScript) was considered to be extremely important for the selection of both hardware and software. Customized programs were developed to improve access control, user interface and on-line help. Wide acceptance of the LAN was achieved through extensive education and maintenance facilities, e.g., teaching courses, customized manuals and a hotline service. Since requirements of clinical routine differ substantially from medical research needs, two separate networks (with a gateway in between) are proposed as a solution to optimally satisfy the users’ demands.


Sign in / Sign up

Export Citation Format

Share Document