scholarly journals Analysis of the Dose Drop at the Edge of the Target Area in Heavy Ion Radiotherapy

2021 ◽  
Vol 2021 ◽  
pp. 1-6
Author(s):  
Xiaoyun Ma ◽  
Mengling Zhang ◽  
Wanbin Meng ◽  
Xiaoli Lu ◽  
Ziheng Wang ◽  
...  

Background. The dose distribution of heavy ions at the edge of the target region will have a steep decay during radiotherapy, which can better protect the surrounding organs at risk. Objective. To analyze the dose decay gradient at the back edge of the target region during heavy ion radiotherapy. Methods. Treatment planning system (TPS) was employed to analyze the dose decay at the edge of the beam under different incident modes and multiple dose segmentation conditions during fixed beam irradiation. The dose decay data of each plan was collected based on the position where the rear edge of the beam began to fall rapidly. Uniform scanning mode was selected in heavy ion TPS. Dose decay curves under different beam setup modes were drawn and compared. Results. The dose decay data analysis showed that in the case of single beam irradiation, the posterior edge of the beam was 5 mm away, and the posterior dose could drop to about 20%. While irradiation in opposite direction, the posterior edge of the beam was 5 mm away, and the dose could drop to about 50%. In orthogonal irradiation of two beams, the posterior edge of the beam could drop to about 30-38% in a distance of 5 mm. Through the data analysis in the TPS, the sharpness of the dose at the back edge of the heavy ion beam is better than that at the lateral edge, but the generated X-ray contamination cannot be ignored. Conclusions. The effect of uneven CT value on the dose decay of heavy ion beam should also be considered in clinical treatment.

2015 ◽  
Vol 82 (1) ◽  
pp. 93-104 ◽  
Author(s):  
Tomonari Hirano ◽  
Yusuke Kazama ◽  
Kotaro Ishii ◽  
Sumie Ohbu ◽  
Yuki Shirakawa ◽  
...  

2016 ◽  
Vol 6 (1) ◽  
Author(s):  
Kento Nagata ◽  
Chika Hashimoto ◽  
Tomomi Watanabe-Asaka ◽  
Kazusa Itoh ◽  
Takako Yasuda ◽  
...  

2006 ◽  
Vol 23 (2) ◽  
pp. 163-167 ◽  
Author(s):  
Kiyoshi Miyazaki ◽  
Ken-ichi Suzuki ◽  
Kazunari Iwaki ◽  
Takaaki Kusumi ◽  
Tomoko Abe ◽  
...  

2011 ◽  
Vol 30 (2) ◽  
pp. 1037-1044 ◽  
Author(s):  
Cerrone S. Cabanos ◽  
Hiroki Katayama ◽  
Hiroyuki Urabe ◽  
Chikara Kuwata ◽  
Yuri Murota ◽  
...  

2012 ◽  
Vol 81 (3) ◽  
pp. 269-274 ◽  
Author(s):  
Akemi Ohmiya ◽  
Tomomi Toyoda ◽  
Hideki Watanabe ◽  
Keishi Emoto ◽  
Yoshihiro Hase ◽  
...  

2020 ◽  
Vol 52 (11) ◽  
pp. 2585-2593 ◽  
Author(s):  
R. Rathika ◽  
M. Kovendhan ◽  
D. Paul Joseph ◽  
Rekha Pachaiappan ◽  
A. Sendil Kumar ◽  
...  

Author(s):  
S Rinaldi ◽  
M Riadi ◽  
Rafiuddin ◽  
AR Trisnawaty ◽  
M M Putra ◽  
...  

2008 ◽  
Vol 25 (1) ◽  
pp. 113-117 ◽  
Author(s):  
Yusuke Kazama ◽  
Hiroyuki Saito ◽  
Yoshiharu Y. Yamamoto ◽  
Yoriko Hayashi ◽  
Hiroyuki Ichida ◽  
...  

2017 ◽  
Vol 2017 ◽  
pp. 1-13
Author(s):  
Shu-Yang Wang ◽  
Yong-Heng Bo ◽  
Xiang Zhou ◽  
Ji-Hong Chen ◽  
Wen-Jian Li ◽  
...  

Heavy-ion irradiation technology has advantages over traditional methods of mutagenesis. Heavy-ion irradiation improves the mutation rate, broadens the mutation spectrum, and shortens the breeding cycle. However, few data are currently available regarding its effect onStreptomyces avermitilismorphology and productivity. In this study, the influence of heavy-ion irradiation onS. avermitiliswhen cultivated in approximately 10 L stirred-tank bioreactors was investigated. The specific productivity of the avermectin (AVM) B1a-producing mutantS. avermitilis147-G58 increased notably, from 3885 to 5446 μg/mL, approximately 1.6-fold, compared to the original strain. The mycelial morphology of the mutant fermentation processes was microscopically examined. Additionally, protein and metabolite identification was performed by using SDS-PAGE, 2- and 3-dimensional electrophoresis (2DE and 3DE). The results showed that negative regulation gene deletion of mutants led to metabolic process upregulating expression of protein and improving the productivity of an avermectin B1a. The results showed that the heavy-ion beam irradiation dose that corresponded to optimal production was well over the standard dose, at approximately 80 Gy at 220 AMeV (depending on the strain). This study provides reliable data and a feasible method for increasing AVM productivity in industrial processes.


Sign in / Sign up

Export Citation Format

Share Document