In this experimental studies, three types of fabric such as Jute, Okra and Pineapple Leaf Fiber (PALF) were selected and matrix material such as polypropylene (PP) was selected to manufacture composites. Jute/PP, Okra/PP, and PALF/PP based composites were prepared successfully by a conventional compression molding technique. The objective of this study is to compare the mechanical such as tensile strength (TS), tensile modulus (TM), bending strength (BS), bending modulus (BM), elongation at break (Eb%) and interfacial properties of the composites. Jute fiber (hessian cloth)-reinforced polypropylene matrix composites (45wt% fiber) were fabricated by compression molding. TS, TM, BS, BM, and IS of the composites were found to be 45 MPa, 2.2 GPa, 54 MPa, 4.1 GPa, and 16 kJ/m2, respectively. Then Okra and PALF fiber reinforced polypropylene-based composites (45 wt% fiber) were fabricated and the mechanical properties were compared with those of the jute-based composites. The result revealed that mechanical properties of PALF composite higher than jute and Okra fiber reinforced composites. Water absorption and elongation percentage at break showed different scenario and it was noticed from the experimental study that water absorption and elongation at break (%) of jute fabric was higher than other composites. Fracture sides of the composites were studied by scanning electron microscope (SEM), and the results revealed poor fiber-matrix adhesion for jute fiber-based composites compared to that of the other fiber-based composites (OF/PP and PALF/PP). KEY WORDS: Polypropylene, Jute Fiber, Okra Fiber, Pineapple Fiber, Mechanical Properties, Interfacial Properties, Composites. *Corresponding Address: [email protected]
EFFECT OF WATER ABSORPTION ON THE MECHANICAL PROPERTIES \OF FLAX FIBER REINFORCED EPOXY COMPOSITES
