Time and Temperature Dependence of the Viscoelastic Properties of PEEK/IM7

2004 ◽  
Vol 38 (20) ◽  
pp. 1815-1830 ◽  
Author(s):  
José Daniel D. Melo ◽  
Donald W. Radford
1992 ◽  
pp. 1031-1037 ◽  
Author(s):  
Amy Lautenschlager ◽  
Finley Markley ◽  
James McAdams ◽  
Barbara Sizemore

1986 ◽  
Vol 59 (4) ◽  
pp. 592-604 ◽  
Author(s):  
Koichi Arai ◽  
John D. Ferry

Abstract Measurements of dynamic storage and loss shear moduli G′ and G″ (0.12 to 2 Hz) and shear relaxation modulus G(t) (up to 104 s) have been made on six vulcanized and one unvulcanized carbon-black-filled rubber compounds over a temperature range from −22.5° to 63°C. The maximum shear strain in the oscillatory deformations was less than 0.005 and in the stress relaxation measurements, 0.015. The temperature dependence of viscoelastic properties could not be fully described in terms of horizontal shifts (αT) of logarithmic time or frequency scales. It could, however, be largely described by vertical shifts (ST) corresponding to uniform temperature dependence of the magnitudes of contributions to modulus from a spectrum of relaxation mechanisms. There were some departures from this behavior, especially in a blend containing two rubber species and in the unvulcanized compound at long times. The temperature dependence of the ST shift factors followed the van't Hoff equation with values of ΔH from 5.9 to 14.7 kJ/mole, attributable to a heat of dissociation of contacts between particle aggregates. The slow relaxation over many logarithmic decades of time scale in the rubbery zone of viscoelastic behavior is attributed to adjustments of such contacts by Brownian motion, which leave the density of the structure unchanged as shown by constancy of the differential dynamic modulus measured by superposed small oscillating deformations.


Author(s):  
Shintaro Itoh ◽  
Kenji Fukuzawa ◽  
Yuya Hamamoto ◽  
Hedong Zhang

In this study, we measured temperature dependence of viscoelastic properties of PFPE lubricant that was confined in nanometer-sized gap widths. In the viscoelastic measurement, we used the fiber wobbling method, which is the highly sensitive shear force measuring method that we have originally developed. Our experimental results showed that the temperature dependence of the lubricant’s viscosity was declined at the gap width of less than 5 nm. Since the elasticity also appeared at the gap width of 5 nm, the reduced temperature dependence is considered to be caused by the repression of molecular mobility due to the solidification of the confined lubricant.


2007 ◽  
Vol 3 ◽  
pp. 41-48 ◽  
Author(s):  
Junhao Wu ◽  
Shuji Fujii ◽  
Seiichi Kawahara ◽  
Yoshinobu Isono

Sign in / Sign up

Export Citation Format

Share Document