P-wave velocity and Gamma density from multisensor core logger and its relation with deep-water sedimentary facies of Quaternary Mass-Transport Complex, Southern continental slope of Campos Basin

2017 ◽  
Author(s):  
Anderson Gomes de Almeida ◽  
Renato Oscar Kowsmann ◽  
Alberto Garcia Figueiredo
2013 ◽  
Author(s):  
Nathaly Archilha ◽  
Roseane Missàgia ◽  
Marco de Ceia ◽  
Irineu Lima Neto ◽  
Luan de Castro ◽  
...  

2019 ◽  
Vol 219 (2) ◽  
pp. 1300-1315 ◽  
Author(s):  
C Bailly ◽  
M Adelinet ◽  
Y Hamon ◽  
J Fortin

SUMMARY For the subsurface characterization of carbonates, linking physical properties (e.g. porosity and seismic reflectors) with their geological significance (e.g. sedimentary facies and diagenesis) is of primary importance. To address this issue, we study the lacustrine and palustrine carbonates on Samos Island through a geological and geophysical characterization of a sedimentary succession. The microstructures of the samples are described, and the samples’ physical properties are measured (porosity, P-wave velocity and density). The results show that the identification of only the primary (i.e. sedimentary) microstructure is not sufficient for explaining the huge variations in porosity and P-wave velocity. Hence, we highlight two early diagenetic processes that strongly impact the microstructures and control the physical properties: (i) neomorphism occludes porosity and increases the P-wave velocity of mud- and grain-supported microstructures, which implies a mineralogical stabilization of the grains; (ii) conversely, the dissolution process creates porosity and decreases the P-wave velocity of grain-supported microstructures if the mineralogical composition of the grains is not previously stabilized. These two diagenetic processes thus depend on the primary microstructures and mineralogy of the sediments. This work aims to explain the variations in porosity and P-wave velocity for each defined primary microstructure. A 1-D seismogram is then built to highlight seismic reflectors with a metre-scale resolution. These reflectors are associated with several geological contrasts. Hard kicks (positive amplitude reflectors) match well with exposure surfaces related to palaeosols. They correspond to contrasts between non-modified primary microstructures and highly neomorphosed microstructures. Conversely, soft kicks (negative amplitude reflectors) are linked with diagenetic contrasts (e.g. neomorphosed microstructures versus non-modified primary microstructures) and sedimentary contrasts that can be overprinted by diagenesis (e.g. neomorphosed mud-supported microstructures versus dissolved grain-supported microstructures). This study highlights that high-resolution seismic reflectors of lacustrine and palustrine carbonates are strongly related to the spatial contrasts of primary microstructures overprinted by early diagenesis.


2021 ◽  
Author(s):  
Dariusz Chlebowski ◽  
Zbigniew Burtan

AbstractA variety of geophysical methods and analytical modeling are applied to determine the rockburst hazard in Polish coal mines. In particularly unfavorable local conditions, seismic profiling, active/passive seismic tomography, as well as analytical state of stress calculating methods are recommended. They are helpful in verifying the reliability of rockburst hazard forecasts. In the article, the combined analysis of the state of stress determined by active seismic tomography and analytical modeling was conducted taking into account the relationship between the location of stress concentration zones and the level of rockburst hazard. A longwall panel in the coal seam 501 at a depth of ca.700 m in one of the hard coal mines operating in the Upper Silesian Coal Basin was a subject of the analysis. The seismic tomography was applied for the reconstruction of P-wave velocity fields. The analytical modeling was used to calculate the vertical stress states basing on classical solutions offered by rock mechanics. The variability of the P-wave velocity field and location of seismic anomaly in the coal seam in relation to the calculated vertical stress field arising in the mined coal seam served to assess of rockburst hazard. The applied methods partially proved their adequacy in practical applications, providing valuable information on the design and performance of mining operations.


2021 ◽  
pp. 228973
Author(s):  
Junhao Qu ◽  
Stephen S. Gao ◽  
Changzai Wang ◽  
Kelly H. Liu ◽  
Shaohui Zhou ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document