Recycling and reuse of carbon fiber reinforcement

Author(s):  
F. Kopf ◽  
J. Kortmann ◽  
P. Jehle
2013 ◽  
Vol 302 ◽  
pp. 338-342
Author(s):  
Soo Yeon Seo

This paper presents the study to find retrofit effect in case of Near-Surface-Mounted Retrofit (NSMR) using Carbon Fiber Reinforcement Polymer (CFRP) plate targeting reinforcement concrete (RC) beam by comparing the previous Externally Bonded Retrofit (EBR) method through experimental analytical works. Three RC beam specimens were made and two of them were retrofitted with CFRP plate by using EBR and NSMR. Also Finite Element (FE) analysis was performed in order to simulate the structural behavior of the beams by considering the bond properties between concrete and CFRP. From the study, it was found that the beam retrofitted with EBR hada reduction of bond capacity in the joint while the beam retrofitted with NSMR had perfect bond capacity.


2013 ◽  
Vol 86 (7) ◽  
pp. 1099-1107
Author(s):  
E. V. Shinkareva ◽  
P. I. Statkevich ◽  
V. D. Koshevar ◽  
N. L. Budeiko ◽  
S. N. Leonovich

Author(s):  
Fei Liang ◽  
Jihua Gou ◽  
He Shen ◽  
Yunjun Xu ◽  
Bob Mabbott

Shape memory polymers (SMPs) are one of the most popular smart materials due to light weight and high elastic deformation capability. In this study, highly conductive carbon nanofibers paper (CNFP) was coated on the surface of SMP as a conductive layer for electro actuation of SMP. To overcome the drawback of low modulus and low strength of shape memory polymer (SMP), continuous carbon fiber reinforcement was also incorporated with SMP by autoclave processing. The dynamic mechanical analysis (DMA) result showed over 600% increase of storage modulus of SMP by introducing carbon fiber reinforcement. Also, the shape recovery time of SMP has been reduced over 150%, while the recovery ratio of SMP has been improved to 99% by incorporating with carbon fiber reinforcement. Additionally, the mechanical property degradation of SMP composites has been investigated after different electro actuation cycles. After 50 actuation cycles, the decrease of flexural modulus of SMP composites is negligible (< 2%), and the ultimate flexural strength of SMP composites only decreased 25%. The SMP composite shows high strength and modulus, and good durability.


2019 ◽  
Vol 12 (4) ◽  
pp. 52-55
Author(s):  
Wojciech Brymerski ◽  
Jan-Philipp Fuhr ◽  
Farbod Nezami

2015 ◽  
Vol 2015.51 (0) ◽  
pp. _411-1_-_411-2_
Author(s):  
Yuki OIKAWA ◽  
Yuma MIKUNI ◽  
Yuma ENDO ◽  
Tetsuya OIZUMI ◽  
Takatoshi SUENAGA

1981 ◽  
Vol 16 (6) ◽  
pp. 633-636
Author(s):  
Yu. G. Korabel'nikov ◽  
V. M. Bondarenko ◽  
A. N. Shiryaev ◽  
A. V. Zakharov ◽  
M. T. Azarova ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document