Physical modelling of pile groups subjected to lateral soil movements

Author(s):  
S Jeong ◽  
Y Kim ◽  
D Seo
2008 ◽  
Vol 2 (1) ◽  
pp. 42-51 ◽  
Author(s):  
L. F. Miao ◽  
A.T.C. Goh ◽  
K.S. Wong ◽  
C.I. Teh
Keyword(s):  

2004 ◽  
Vol 41 (4) ◽  
pp. 644-656 ◽  
Author(s):  
Sangseom Jeong ◽  
Donghee Seo ◽  
Jinhyung Lee ◽  
Joogbai Park

A series of centrifuge model tests were performed to investigate the behavior of pile groups subjected to lateral soil movements by surcharge loading from approach embankments. The emphasis was on quantifying the time-dependent response in terms of deflections, bending moments, and earth pressures acting on pile groups during embankment construction and over short- and long-term periods after embankment construction. A variety of instruments were used to examine the soil–pile interaction for pile groups adjacent to surcharge loads. Through these studies, it is found that pile cap deflections and bending moments developed to their maximum values under the short-term surcharge loading and decreased gradually to minimum values under the long-term loading. The ground settlement reached its maximum value under long-term loading, however, due to the consolidation of soft clay. It is also found that the lateral mean pressure acting on the pile is about 0.75 and 0.35 times the surcharge load q (= γH, where γ is the unit weight of the soil and H is the height of the embankment) under short- and long-term loading, respectively.Key words: time-dependent response, lateral soil movements, pile groups, centrifuge model tests, surcharge loads, soft clay.


2019 ◽  
Vol 10 (2) ◽  
Author(s):  
Ida Ayu Irawati Diah Ratna Putra ◽  
Juventus Welly R Ginting ◽  
Eduardo Meyrianso Simanjuntak

Pile breakwater is an effective type of breakwater to reduce wave energy. To find out the effectiveness of the structure of the pile breakwater can be carried out physical modeling experiments in the laboratory. The structure is tested based on the variation of gap between piles (rows)/Diameter (b/D), distance between piles (columns) / Diameter (B/D), arrangement of laying piles (N), and gap width between pile groups stake (G). Besides structure, period (T) and wave height (H) are also varied. This physical model test is carried out in a fume with regular wave at a depth of 60 cm. From the results of physical modeling it can be seen the value of the transmission coefficient (Kt) which is determined based on variations in the gap structure between the piles (rows) /Diameter (b/D), the arrangement of laying piles (N), and the width of the gap between the pile groups (G) which is used as a reference to determine the effectiveness of the pile breakwater structure. Physical modelling of the pile is the optimum value of the transmission coefficient (Kt) to reduce the waveform shown in the variation of the structure of the distance between the pile rows (b/D) 0.5, 58.1 cm Gap, and configuration of the pile structure N2 (three rows pile breakwater).Key Word: Breakwater, Pile Breakwater Structure, Transmission Coefficient (Kt)


Author(s):  
Milad Souri

The results of five centrifuge models were used to evaluate the response of pile-supported wharves subjected to inertial and liquefaction-induced lateral spreading loads. The centrifuge models contained pile groups that were embedded in rockfill dikes over layers of loose to dense sand and were shaken by a series of ground motions. The p-y curves were back-calculated for both dynamic and static loading from centrifuge data and were compared against commonly used American Petroleum Institute p-y relationships. It was found that liquefaction in loose sand resulted in a significant reduction in ultimate soil resistance. It was also found that incorporating p-multipliers that are proportional to the pore water pressure ratio in granular materials is adequate for estimating pile demands in pseudo-static analysis. The unique contribution of this study is that the piles in these tests were subjected to combined effects of inertial loads from the superstructure and kinematic loads from liquefaction-induced lateral spreading.


Sign in / Sign up

Export Citation Format

Share Document