Gas Permeability Change With Deformation and Cracking of a Sandstone Under Triaxial Compressiongas Permeability Change With Deformation and Cracking of a Sandstone Under Triaxial Compression

In this paper, a THMC (Thermal-Hydrological-Mechanical-Chemical) multi-field coupling triaxial cell was used to systematically study the evolution of gas permeability and the deformation characteristics of sandstone. The effects of confining pressure, axial pressure, and air pressure on gas permeability characteristics were fully considered in the test. The gas permeability of sandstone decreases with increasing confining pressure. When the confining pressure is low, the variation of gas permeability is greater than the variation of gas permeability at high confining pressure. The gas injection pressure has a significant effect on the gas permeability evolution of sandstone. As the gas injection pressure increases, the gas permeability of sandstone tends to decrease. At the same confining pressure, the gas permeability of the sample during the unloading path is less than the gas permeability of the sample in the loading path. When axial pressure is applied, it has a significant influence on the permeability evolution of sandstone. When the axial pressure is less than 30 MPa, the gas permeability of the sandstone increases as the axial pressure increases. At axial pressures greater than 30 MPa, the permeability decreases as the axial pressure increases. Finally, the micro-pore/fracture structure of the sample after the gas permeability test was observed using 3D X-ray CT imaging.

Physics of runaway electrons with shattered pellet injection at JET

Runaway electrons created during tokamak disruptions pose a threat to a reliable operation of future larger machines. Experiments using Shattered Pellet Injection (SPI) have been carried out at the JET tokamak to investigate ways to prevent their generation or suppress them if avoidance is not sufficient. Avoidance is possible if the SPI contains a sufficiently low fraction of high-Z material, or if it is fired early in advance of a disruption prone to runaway generation. These results are consistent with previous similar findings obtained with Massive Gas Injection. Suppression of an already accelerated beam is not efficient using High-Z material, but deuterium leads to harmless terminations without heat loads. This effect is the combination of a large MHD instability scattering runaway electrons on a large area and the absence of runaway regeneration during the subsequent current collapse thanks to the flushing of high-Z impurities from the runaway companion plasma. This effect also works in situations where the runaway beam moves upwards and undergoes scraping-off on the wall.

CFD Modeling of Multiphase Flow in an SKS Furnace with New Tuyere Arrangements

There has been a great deal of focus on the optimization of tuyere arrangements in SKS bottom blown copper smelting furnaces since the last decade, as the improved furnace operation efficiency of SKS technology has potential that cannot be ignored. New –x + 0 + x deg tuyere arrangements with 14 tuyeres are proposed in this research paper. Using a previously verified numerical model, CFD tests on the velocity distribution and wall shear stress for scaled-down SKS furnace models were conducted, with a constant total volumetric gas flow rate, and different operating parameters and furnace cross-section geometries. The results indicate that, at a relatively low gas injection speed compared with the previously optimized tuyere arrangement, although the –x +0 +x deg tuyere arrangements are unable to supply enhanced agitation in the typical round furnaces, they achieve better performance in elliptical furnaces. At a comparatively higher gas injection speed, the – x + 0 + x deg tuyere arrangements can improve the agitation performance in a round furnace while maintaining an acceptable wall shear stress on the bottom and side wall. The agitation enhancement with the − x +0 +x deg tuyere arrangements can essentially be attributed to stronger interactions between bubble plumes and furnace side walls. To further exploit the advantages of the new tuyere arrangements, an optimized tuyere angle was confirmed by a full-scale furnace model simulation.