1225 On-Board Measurement of Engine Performance and Emissions in D.I. Diesel Vehicle Operated with Waste-Cooking Oil Bio-Fuel

2005 ◽  
Vol 2005.80 (0) ◽  
pp. _12-47_-_12-48_
Author(s):  
Teppei SUZUKI ◽  
Teruaki HAIBARA ◽  
Jiro SENDA
Author(s):  
S. Cordiner ◽  
F. Mecocci ◽  
V. Mulone ◽  
V. Rocco

The use of biodiesel has been widely accepted as an effective solution to reduce greenhouse emissions. The high potential of biodiesel in terms of PM emission reduction may represent an additional motivation for its wide diffusion. This potential is related to the oxygenated nature of biodiesel, leading to a different PM-NOx trade-off. Wide diffusion is also under debate as it may represent a solution to the highly disputed issue of the development of alternative biofuels sources not competing with the food chain. In fact, besides second generation biofuels (e.g. from algae), the transesterification of Waste Cooking Oil (WCO) is another option, that however needs additional insight. In fact, in this case, the effects on particle emissions are still not well assessed, as well as the impact of fuel distillation on engine performance and emissions. In this paper an experimental study on particle emissions of a DEUTZ 4L off-road Diesel engine coupled to a DOC-DPF system is proposed. Experimental data have been gathered at the engine test bench of the University of Rome Tor Vergata, by using baseline fossil fuel (B06) and blends (30% vol) with both distilled and non distilled WCO biodiesel. Data have been acquired with respect to the three most probable engine points referring to the NRTC (Non-Road-Transient-Cycle), upstream and downstream of the AfterTreatment System. Results show that B30 fuels have always lower emission on a mass and number basis, and that distillation process may have an impact especially at high power and torque operation. A slightly better behavior in terms of mass emissions has been observed for the blend with distilled fuel, while a slightly better behavior in terms of particle number has been observed for the blend with non-distilled fuel.


Fuel ◽  
2021 ◽  
Vol 302 ◽  
pp. 121097
Author(s):  
M. Mourad ◽  
Khaled R.M. Mahmoud ◽  
El-Sadek H. NourEldeen

2021 ◽  
Vol 3 (4) ◽  
Author(s):  
Ali Hasan ◽  
Oskar J. Haidn

AbstractThe Paris Agreement has highlighted the need in reducing carbon emissions. Attempts in using lower carbon fuels such as Propane gas have seen limited success, mainly due to liquid petroleum gas tanks structural/size limitations. A compromised solution is presented, by combusting Jet A fuel with a small fraction of Propane gas. Propane gas with its relatively faster overall igniting time, expedites the combustion process. Computational fluid dynamics software was used to demonstrate this solution, with results validated against physical engine data. Jet A fuel was combusted with different Propane gas dosing fractions. Results demonstrated that depending on specific propane gas dosing fractions emission reductions in ppm are; NOx from 84 to 41, CO2 from less than 18,372 to less than 15,865, escaping unburned fuels dropped from 11.4 (just Jet A) to 6.26e-2 (with a 0.2 fraction of Propane gas). Soot and CO increased, this is due to current combustion chamber air mixing design.


Fuel ◽  
2014 ◽  
Vol 120 ◽  
pp. 91-97 ◽  
Author(s):  
Rakhi N. Mehta ◽  
Mousumi Chakraborty ◽  
Parimal A. Parikh

2015 ◽  
Vol 1113 ◽  
pp. 674-678
Author(s):  
Syarifah Yunus ◽  
Noriah Yusoff ◽  
Muhammad Faiz Fikri Ahmad Khaidzir ◽  
Siti Khadijah Alias ◽  
Freddawati Rashiddy Wong ◽  
...  

The continued using of petroleum energy as a sourced for fuel is widely recognized as unsustainable because of the decreasing of supplies while increasing of the demand. Therefore, it becomes a global agenda to develop a renewable, sustainable and alternative fuel to meets with all the demand. Thus, biodiesel seems to be one of the best choices. In Malaysia, the biodiesel used is from edible vegetable oil sources; palm oil. The uses of palm oil as biodiesel production source have been concern because of the competition with food materials. In this study, various types of biodiesel feedstock are being studied and compared with diesel. The purpose of this comparison is to obtain the optimum engine performance of these different types of biodiesel (edible, non-edible, waste cooking oil) on which are more suitable to be used as alternative fuel. The optimum engine performance effect can be obtains by considering the Brake Power (BP), Specific Fuel Consumption (SFC), Exhaust Gas Temperature (EGT) and Brake Thermal Efficiency (BTE).


Sign in / Sign up

Export Citation Format

Share Document