scholarly journals NOISE MODEL OF QUANTIZATION OF THE VECTOR WITH NON-ZERO MATHEMATICAL EXPECTATIONS

2020 ◽  
Vol 12 (2) ◽  
pp. 37-48
Author(s):  
V.V. Zavolokin ◽  
Keyword(s):  
Noise Model

Unified small-signal-noise model for active microwave devices

1993 ◽  
Vol 140 (1) ◽  
pp. 55 ◽  
Author(s):  
Z.R. Hu ◽  
Z.M. Yang ◽  
V.F. Fusco ◽  
J.A.C. Stewart
Keyword(s):  
Noise Model ◽  
Microwave Devices ◽  
Small Signal ◽  
Signal Noise

Extension of the LTV Phase Noise Model of Electrical Oscillators for the Output Harmonics

2012 ◽  
Vol E95.C (12) ◽  
pp. 1846-1856 ◽  
Author(s):  
Seyed Amir HASHEMI ◽  
Hassan GHAFOORIFARD ◽  
Abdolali ABDIPOUR
Keyword(s):  
Phase Noise ◽  
Noise Model ◽  
Electrical Oscillators

scholarly journals Reconstruction of Relative Phase of Self-Transmitting Devices by Using Multiprobe Solutions and Non-Convex Optimization

Sensors ◽  
2021 ◽  
Vol 21 (7) ◽  
pp. 2459
Author(s):  
Rubén Tena Sánchez ◽  
Fernando Rodríguez Varela ◽  
Lars J. Foged ◽  
Manuel Sierra Castañer
Keyword(s):  
Iterative Algorithm ◽  
Degrees Of Freedom ◽  
Relative Phase ◽  
Low Cost ◽  
Initial Guess ◽  
Noise Model ◽  
Medium Size ◽  
Phase Reconstruction ◽  
Linear Combinations ◽  
Iterative Optimization Algorithm

Phase reconstruction is in general a non-trivial problem when it comes to devices where the reference is not accessible. A non-convex iterative optimization algorithm is proposed in this paper in order to reconstruct the phase in reference-less spherical multiprobe measurement systems based on a rotating arch of probes. The algorithm is based on the reconstruction of the phases of self-transmitting devices in multiprobe systems by taking advantage of the on-axis top probe of the arch. One of the limitations of the top probe solution is that when rotating the measurement system arch, the relative phase between probes is lost. This paper proposes a solution to this problem by developing an optimization iterative algorithm that uses partial knowledge of relative phase between probes. The iterative algorithm is based on linear combinations of signals when the relative phase is known. Phase substitution and modal filtering are implemented in order to avoid local minima and make the algorithm converge. Several noise-free examples are presented and the results of the iterative algorithm analyzed. The number of linear combinations used is far below the square of the degrees of freedom of the non-linear problem, which is compensated by a proper initial guess. With respect to noisy measurements, the top probe method will introduce uncertainties for different azimuth and elevation positions of the arch. This is modelled by considering the real noise model of a low-cost receiver and the results demonstrate the good accuracy of the method. Numerical results on antenna measurements are also presented. Due to the numerical complexity of the algorithm, it is limited to electrically small- or medium-size problems.

Model Refinement Learning and an Example on Channel Estimation With Universal Noise Model

2021 ◽  
Vol 39 (1) ◽  
pp. 31-46
Author(s):  
Hui-Ming Wang ◽  
Jia-Cheng Jiang ◽  
Yu-Ning Wang
Keyword(s):  
Channel Estimation ◽  
Noise Model ◽  
Model Refinement

Acoustic Modeling of Meteorological Effects on Roadway Noise

2021 ◽  
pp. 036119812199458
Author(s):  
Roger L. Wayson ◽  
Kenneth Kaliski
Keyword(s):  
Road Traffic ◽  
Traffic Noise ◽  
Model Development ◽  
The United States ◽  
Noise Model ◽  
Road Traffic Noise ◽  
Atmospheric Conditions ◽  
Noise Propagation ◽  
Transportation Research ◽  
Meteorological Effects

Modeling road traffic noise levels without including the effects of meteorology may lead to substantial errors. In the United States, the required model is the Traffic Noise Model which does not include meteorology effects caused by refraction. In response, the Transportation Research Board sponsored NCHRP 25-52, Meteorological Effects on Roadway Noise, to collect highway noise data under different meteorological conditions, document the meteorological effects on roadway noise propagation under different atmospheric conditions, develop best practices, and provide guidance on how to: (a) quantify meteorological effects on roadway noise propagation; and (b) explain those effects to the public. The completed project at 16 barrier and no-barrier measurement positions adjacent to Interstate 17 (I-17) in Phoenix, Arizona provided the database which has enabled substantial developments in modeling. This report provides more recent information on the model development that can be directly applied by the noise analyst to include meteorological effects from simple look-up tables to more precise use of statistical equations.

scholarly journals Forgery Detection in Digital Images by Multi-Scale Noise Estimation

2021 ◽  
Vol 7 (7) ◽  
pp. 119
Author(s):  
Marina Gardella ◽  
Pablo Musé ◽  
Jean-Michel Morel ◽  
Miguel Colom
Keyword(s):  
Noise Model ◽  
Correlated Noise ◽  
Forgery Detection ◽  
Color Channel ◽  
Image Block ◽  
Multi Scale ◽  
Compressed Images ◽  
Inconsistency Analysis ◽  
Highly Correlated ◽  
The Moment

A complex processing chain is applied from the moment a raw image is acquired until the final image is obtained. This process transforms the originally Poisson-distributed noise into a complex noise model. Noise inconsistency analysis is a rich source for forgery detection, as forged regions have likely undergone a different processing pipeline or out-camera processing. We propose a multi-scale approach, which is shown to be suitable for analyzing the highly correlated noise present in JPEG-compressed images. We estimate a noise curve for each image block, in each color channel and at each scale. We then compare each noise curve to its corresponding noise curve obtained from the whole image by counting the percentage of bins of the local noise curve that are below the global one. This procedure yields crucial detection cues since many forgeries create a local noise deficit. Our method is shown to be competitive with the state of the art. It outperforms all other methods when evaluated using the MCC score, or on forged regions large enough and for colorization attacks, regardless of the evaluation metric.

scholarly journals Analysis of Noise and Velocity in GNSS EPN-Repro 2 Time Series

2021 ◽  
Vol 13 (14) ◽  
pp. 2783
Author(s):  
Sorin Nistor ◽  
Norbert-Szabolcs Suba ◽  
Kamil Maciuk ◽  
Jacek Kudrys ◽  
Eduard Ilie Nastase ◽  
...  
Keyword(s):  
Time Series ◽  
Visual Inspection ◽  
Flicker Noise ◽  
Vertical Component ◽  
Likelihood Estimation ◽  
Noise Model ◽  
Noise Amplitude ◽  
Allan Deviation ◽  
Power Spectral ◽  
Position Time Series

This study evaluates the EUREF Permanent Network (EPN) station position time series of approximately 200 GNSS stations subject to the Repro 2 reprocessing campaign in order to characterize the dominant types of noise and amplitude and their impact on estimated velocity values and associated uncertainties. The visual inspection on how different noise model represents the analysed data was done using the power spectral density of the residuals and the estimated noise model and it is coherent with the calculated Allan deviation (ADEV)-white and flicker noise. The velocities resulted from the dominant noise model are compared to the velocity obtained by using the Median Interannual Difference Adjusted for Skewness (MIDAS). The results show that only 3 stations present a dominant random walk noise model compared to flicker and powerlaw noise model for the horizontal and vertical components. We concluded that the velocities for the horizontal and vertical component show similar values in the case of MIDAS and maximum likelihood estimation (MLE), but we also found that the associated uncertainties from MIDAS are higher compared to the uncertainties from MLE. Additionally, we concluded that there is a spatial correlation in noise amplitude, and also regarding the differences in velocity uncertainties for the Up component.

Anti-noise model-free adaptive control and its application in the circulating fluidized bed boiler

2020 ◽  
pp. 095965182097937
Author(s):  
Na Dong ◽  
Wenjin Lv ◽  
Shuo Zhu ◽  
Donghui Li
Keyword(s):  
Adaptive Control ◽  
Complete Convergence ◽  
Circulating Fluidized Bed ◽  
Control Method ◽  
Noise Model ◽  
Good Resistance ◽  
Industrial Systems ◽  
Noise Interference ◽  
Model Free ◽  
Tracking Differentiator

Model-free adaptive control has been developed greatly since it was proposed. Up to now, model-free adaptive control theory has become mature and tends to be an effective solution for complex unmodeled industrial systems. In practical industrial processes, most control systems are inevitably accompanied by noise that will result in indelible error and may further cause inaccurate feedback to the output. In order to solve this kind of problem with model-free technique, this article incorporates an improved tracking differentiator into model-free adaptive control. After that, the anti-noise model-free adaptive control method with complete convergence analysis is proposed. Meanwhile, numerical simulation proves that the improved control method can quickly track a given signal with good resistance to noise interference. Finally, the effectiveness and practicability of the proposed algorithm are verified by experiments through the control of drum water level of circulating fluidized.

Sign in / Sign up

Export Citation Format

Share Document