An investigation has been made to improve the properties of the friction stir welded (FSW) 6061-T6 aluminum alloys. A cryogenic thermal treatment is developed for the joints during welding and its effects on mechanical and metallurgical properties, and precipitates are evaluated at various welding parameters. The friction stir welded joints with cryogenic treatment attained the better properties than the without cryogenic treatment. The improvement of properties was attributed to the refinement of grain size and to the introduction of a reduction in the softening region of the welded joints. Under cryogenic cooling rates, joints were experienced to the low temperature environments and faster cooling rates, which are contributed to enhance the hardness of the stir zone and heat affected zone regions and the formation of fine grain structure in the stir zone. The results indicated that the formation of finer grains of less than 5 µm in the stir zone, which is smaller than the joints of without cryogenic treatment. Subsequently, mechanical properties drastically improved and the joints achieved a maximum joint efficiency of 74% of the base material
Erratum to: Multi-response optimization using the Taguchi-based grey relational analysis: a case study for dissimilar friction stir butt welding of AA6082-T6/AA5754-H111
