K+-CHANNELS IN RAT VENTRICULAR CELLS SHOW VOLTAGE-DEPENDENT OUTWARD RECTIFICATION AND NON-LINEAR VOLTAGE TO CURRENT RELATION

1985 ◽  
pp. 145-152
1985 ◽  
Vol 4 (4) ◽  
pp. 143-146 ◽  
Author(s):  
C. G. Steyn ◽  
J. D. Van Wyk

A novel suggestion for a non-linear turn-off snubber is simulated experimentally with linear capacitors and an auxiliary power electronic switch. Thus the principle and advantages of this concept is partly illustrated, particularly concerning the important reduction of reactive stored energy for the same switching dissipation in the main power device. The full advantages of the concept will be realised when a snubber capacitor with non-linear, voltage dependent dielectric is used. The work on this part of the solution is being continued.


1998 ◽  
Vol 111 (2) ◽  
pp. 363-379 ◽  
Author(s):  
Izumi Sugihara

Effects of internal Sr2+ on the activity of large-conductance Ca2+-activated K+ channels were studied in inside-out membrane patches from goldfish saccular hair cells. Sr2+ was approximately one-fourth as potent as Ca2+ in activating these channels. Although the Hill coefficient for Sr2+ was smaller than that for Ca2+, maximum open-state probability, voltage dependence, steady state gating kinetics, and time courses of activation and deactivation of the channel were very similar under the presence of equipotent concentrations of Ca2+ and Sr2+. This suggests that voltage-dependent activation is partially independent of the ligand. Internal Sr2+ at higher concentrations (>100 μM) produced fast and slow blockade both concentration and voltage dependently. The reduction in single-channel amplitude (fast blockade) could be fitted with a modified Woodhull equation that incorporated the Hill coefficient. The dissociation constant at 0 mV, the Hill coefficient, and zd (a product of the charge of the blocking ion and the fraction of the voltage difference at the binding site from the inside) in this equation were 58–209 mM, 0.69–0.75, 0.45–0.51, respectively (n = 4). Long shut events (slow blockade) produced by Sr2+ lasted ∼10–200 ms and could be fitted with single-exponential curves (time constant, τl−s) in shut-time histograms. Durations of burst events, periods intercalated by long shut events, could also be fitted with single exponentials (time constant, τb). A significant decrease in τb and no large changes in τl−s were observed with increased Sr2+ concentration and voltage. These findings on slow blockade could be approximated by a model in which single Sr2+ ions bind to a blocking site within the channel pore beyond the energy barrier from the inside, as proposed for Ba2+ blockade. The dissociation constant at 0 mV and zd in the Woodhull equation for this model were 36–150 mM and 1–1.8, respectively (n = 3).


1982 ◽  
Vol 80 (5) ◽  
pp. 663-682 ◽  
Author(s):  
C M Armstrong ◽  
R P Swenson ◽  
S R Taylor

We have studied the interactions of Ba ion with K channels. Ba2+ blocks these channels when applied either internally or externally in millimolar concentrations. Periodic depolarizations enhance block with internal Ba2+, but diminish the block caused by external Ba2+. At rest, dissociation of Ba2+ from blocked channels is very slow, as ascertained by infrequent test pulses applied after washing Ba2+ form either inside or outside. The time constant for recovery from internal and external Ba2+ is the same. Frequent pulsing greatly shortens recovery time constant after washing away both Ba2+in and Ba2+out. Block by Ba2+ applied internally or externally is voltage dependent. Internal Ba2+ block behaves like a one-step reaction governed by a dissociation constant (Kd) that decreases e-fold/12 mV increase of pulse voltage: block deepens with more positive pulse voltage. For external Ba2+, Kd decreases e-fold/18 mV as holding potential is made more negative: block deepens with increasing negativity. Millimolar external concentrations of some cations can either lessen (K+) or enhance (NH+4, Cs+) block by external Ba2+. NH+4 apparently enhances block by slowing exist of Ba ions from the channels. Rb+ and Cs+ also slow clearing of Ba ions from channels. We think that (a) internally applied Ba2+ moves all the way through the channels, entering only when activation gates are open; (b) externally applied Ba2+ moves two-thirds of the way in, entering predominantly when activation gates are closed; (c) at a given voltage, Ba2+ occupies the same position in the channels whether it entered from inside or outside.


Sign in / Sign up

Export Citation Format

Share Document