Experiments on the Model Testing of the 2nd Phase of Die Casting Process Compared with the Results of Numerical Simulation
Keyword(s):
Abstract Experiments of filling the model moulds cavity of various inner shapes inserted in rectangular cavity of the casting die (dimensions: 280 mm (height) × 190 mm (width) × 10 mm (depth) by applying model liquids of various density and viscosity are presented in the paper. Influence of die venting as well as inlet system area and inlet velocity on the volumetric rate of filling of the model liquid - achieved by means of filming the process in the system of a cold-chamber casting die was tested. Experiments compared with the results of simulation performed by means of the calculation module Novacast (Novaflow&Solid) for the selected various casting conditions - are also presented in the paper.
Keyword(s):
2007 ◽
pp. 1801-1804
◽
Keyword(s):
2017 ◽
Vol 3
(3)
◽
pp. 438-448
Keyword(s):
1992 ◽
Vol 31
(1-2)
◽
pp. 65-74
◽
Keyword(s):
2012 ◽
Vol 192-193
◽
pp. 293-298
◽
Keyword(s):
2007 ◽
Vol 26-28
◽
pp. 1041-1044
2013 ◽
Vol 94
(2)
◽
pp. 147-153
◽
2012 ◽
Vol 490-495
◽
pp. 2362-2365