CIDNP Effects of Sensitized Photochemical Dediazoniation of Arene Diazonium Salts Manipulating CIDNP Intensities by the Experimental Conditions

1983 ◽  
Vol 38 (12) ◽  
pp. 1591-1597 ◽  
Author(s):  
Heinz G. O. Becker ◽  
Dietmar Pfeifer ◽  
Reiner Radeglia

13C and 15N photo-CIDNP effects were determined for the reversible electron transfer from pyrene to arene diazonium salts on excitation of the charge transfer band at 360 nm. The diazonium salts being the products of back electron transfer (“cage products”) show enhanced absorption for 13 C(1) and the 15N-enriched diazonium group, whereas the escape products, ArH or 15N2, respectively, yield emission signals. It was shown that the intensities of the CIDNP effects depend on the rates of intersystem crossing kisc within the geminate radical pair, i.e. on the magnetic nucleus used as a probe of the CIDNP effect. Using 1H, 13C or 15N the time domain of observation can be manipulated in the ranges of 90-100 ns, 15-20 ns and 3-5 ns, respectively. Furthermore, the CIDNP intensities depend on the proper balance of the rate of electron back transfer, k-e, and the rate kp of formation of the escape product. Since k-e increases with increasing energy of the geminate radical pair, this balance and therefore the CIDNP intensities vary according to the substituent present and the electron donor used

1993 ◽  
Vol 28 (11-12) ◽  
pp. 473-480
Author(s):  
A. Heduit ◽  
B. Martin ◽  
I. Duchamp ◽  
D. R. Thevenot

Gold and platinum were compared to ascertain how they expressed a stabilized potential in activated sludge. The comparison was based on electrochemical determination of the electron transfer rate (i.e. equilibrium exchange current density) and recording of potentials against time. When both metals are treated in the same way, platinum gives equilibrium exchange current densities approx. 10 times higher than gold, both in aerated activated sludge and in treated water. For platinum, the equilibrium exchange current densities range from 0.1 to 0.25 µA/cm2 immediately after polishing and decrease during prolonged contact with activated sludge subjected to alternating aeration/anoxia sequences. The lower kinetics of electron transfer on gold go together with significant differences in response:- In an aerobic medium a gold electrode potential is lower than that of a platinum electrode. In a strongly anaerobic medium, the reverse is true. Consequently, the amplitude of the potential variation between aerobic and anaerobic media is smaller for gold than for platinum. Under our experimental conditions this amplitude was approx 350 mV for gold and 850 mV for platinum.- The slopes of the linear relationships between potential and pH or potential and the logarithm of the dissolved oxygen concentration are two or three times greater for platinum than for gold. Although the values obtained with platinum electrodes cannot represent a veritable equilibrium state, the platinum electrode zero-current potential would seem to be far more sensitive to variations in the medium than that of the gold electrode; it is, therefore, more suitable for use in activated sludge.


2008 ◽  
Vol 120 (7) ◽  
pp. 1248-1251 ◽  
Author(s):  
Marat M. Khusniyarov ◽  
Thomas Weyhermüller ◽  
Eckhard Bill ◽  
Karl Wieghardt

Electrochem ◽  
2020 ◽  
Vol 1 (1) ◽  
pp. 20-31
Author(s):  
Thi Huong Le ◽  
Van Quyen Nguyen ◽  
Gaelle Trippe-Allard ◽  
Jean-Christophe Lacroix ◽  
Pascal Martin

The control of the interface and the adhesion process are key issues for the development of new application based on electrochromic materials. In this work the functionalization of an electrode’s surface through electroreduction of diazonium generated in situ from 4-(2,5-di-thiophen-2-yl-pyrrol-1-yl)-phenylamine (SNS-An) has been proposed. The synthesis of the aniline derivative SNS-An was performed and the electrografting was investigated by cyclic voltammetry on various electrodes. Then the organic thin film was fully characterized by several techniques and XPS analysis confirms the presence of an organic film based on the chemical composition of the starting monomer and allows an estimation of its thickness confirmed by AFM scratching measurements. Depending on the number of electrodeposition cycles, the thickness varies from 2 nm to 10 nm, which corresponds to a few grafted oligomers. In addition, the grafted film showed a good electrochemical stability depending on the scan rates up to 400 V/s and the electrochemical response of the modified electrode towards several redox probes showed that the attached layer acts as a conductive switch. Therefore, the electrode behaves as a barrier to electron transfer when the standard redox potential of the probe is below the layer switching potential, whereas the layer can be considered as transparent towards the electron transfer for redox probes with a redox potential above it.


2018 ◽  
Vol 815 ◽  
pp. 24-29 ◽  
Author(s):  
Hatem M.A. Amin ◽  
Yuki Uchida ◽  
Christopher Batchelor-McAuley ◽  
Enno Kätelhön ◽  
Richard G. Compton

1988 ◽  
Vol 53 (5) ◽  
pp. 903-911 ◽  
Author(s):  
Josef Hanzlík ◽  
Jan Hovorka ◽  
Zdeněk Samec ◽  
Štefan Toma

Kinetics of electron transfer between ferrocene or its derivative (1,1'-diethyl- or 1,1'-distearoylferrocene) in dichloroethane and hexacyanoferrate(III) in water was studied by means of convolution potential sweep voltammetry. Within the accessible range of experimental conditions no effect of either the potential or concentrations of reactants on the rate constant of electron transfer from the organic to the aqueous phase (ko→w = 1 . 10-7 m4 mol-1 s-1) was observed. Electron transfer was shown to occur far from the potential range, in which the ferricenium ion transfer can take place. However, the reaction was complicated by the chemical decomposition of ferricenium in dichloroethane (k = 0·346 s-1).


2002 ◽  
Vol 106 (7) ◽  
pp. 1152-1166 ◽  
Author(s):  
Timothy W. Marin ◽  
Bradley J. Homoelle ◽  
Kenneth G. Spears

Sign in / Sign up

Export Citation Format

Share Document