Darstellung und Charakterisierung des Silber(I,II,III)-oxidclathrates Ag7O8HCO3 / Synthesis and Characterization of the Silver(I,II,III) Oxide Clathrate Ag7O8HCO3

2000 ◽  
Vol 55 (9) ◽  
pp. 882-886 ◽  
Author(s):  
Martin Jansen ◽  
Sascha Vensky
Keyword(s):  
Electron Microscopy ◽  
Thermal Analysis ◽  
Scanning Electron Microscopy ◽  
Magnetic Susceptibility ◽  
Solid State Nmr ◽  
Synthesis And Characterization ◽  
X Ray Diffraction ◽  
X Ray ◽  
Scanning Electron

The silver(I,II,III) oxide clathrate Ag7O8HCO3 was synthesized by anodic oxidation of silver(I) in a suspension of Ag2CO3 in an aqueous AgF solution. The title compound was characterized by single crystal X-ray diffraction (cubic, Fm3̄m, a = 9.8085(3) Å, Z = 4), scanning electron microscopy, thermal analysis, IR spectroscopy, 1H-solid state-NMR and measurement of the magnetic susceptibility

Hydrothermal Synthesis and Characterization of BiFeO3 Polyhedral Crystallites

2012 ◽  
Vol 174-177 ◽  
pp. 508-511
Author(s):  
Lin Lin Yang ◽  
Yong Gang Wang ◽  
Yu Jiang Wang ◽  
Xiao Feng Wang
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Synthesis And Characterization ◽  
X Ray Diffraction ◽  
Xrd Pattern ◽  
X Ray ◽  
Transmission Electron ◽  
Scanning Electron

BiFeO3 polyhedrons had been successfully synthesized via a hydrothermal method. The as-prepared products were characterized by power X-ray diffraction (XRD) pattern, scanning electron microscopy (SEM) and transmission electron microscopy (TEM). The possible mechanisms for the formation of BiFeO3 polyhedrons were discussed. Though comparison experiments, it was found that the kind of precursor played a key role on the morphology control of BiFeO3 crystals.

Synthesis and Characterization of NiO Doped SnO2 Nano-Flowers

2013 ◽  
Vol 575-576 ◽  
pp. 58-60
Author(s):  
Wei Ping Tang
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Fourier Transform ◽  
Infrared Spectrum ◽  
Synthesis And Characterization ◽  
X Ray Diffraction ◽  
Hydrothermal Route ◽  
X Ray ◽  
Scanning Electron

In this present work, a new method for preparing NiO doped SnO2 nanoflowers by hydrothermal route is suggested. The composition and microstructure of samples were characterized by field emission scanning electron microscopy (FE-SEM), X-ray diffraction (XRD) and Fourier transform infrared spectrum (FTIR). Moreover, a possible formation mechanism was discussed.

Preparation and Characterization of Fibri-Form Silica from Short Chrysotile Fibers by Mix-Roasting

2014 ◽  
Vol 809-810 ◽  
pp. 313-318
Author(s):  
Peng Cheng Song ◽  
Tong Jiang Peng ◽  
Hong Juan Sun ◽  
Yu Cao Yu
Keyword(s):  
Electron Microscopy ◽  
Thermal Analysis ◽  
Scanning Electron Microscopy ◽  
Fluorescence Analysis ◽  
X Ray Diffraction ◽  
X Ray ◽  
Fibrous Morphology ◽  
Ft Ir ◽  
Scanning Electron

Fibri-form silica was extracted from short chrysotile fibers by mix-roasting with ammonium bisulfate. The fibri-form silica were characterized by X-ray fluorescence analysis (XRF), X-ray diffraction (XRD), thermogravimetry and differential thermal analysis (TG-DTA), scanning electron microscopy (SEM), fourier transform infrared spectroscopy (FT-IR) and N2 adsorption isotherms. The results show that the fibri-form silica with disordered crystalline structure, but also in fibrous morphology. The surface area and pore volume of fibri-form silica are 181.66 m2/ g and 0.44 cc/ g, respectively. The structure of fibri-form silica is stable, no phase transformed from 50 to 1200 oC.

scholarly journals Hydrothermal synthesis and characterization of polycrystalline gadolinium aluminum perovskite (GdAlO3, GAP)

2015 ◽  
Vol 33 (2) ◽  
pp. 301-305 ◽  
Author(s):  
Girish H. N. ◽  
Basavalingu B. ◽  
Shao G.-Q. ◽  
Sajan C. P. ◽  
S. K. Verma
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Infrared Spectroscopy ◽  
High Temperature ◽  
Synthesis And Characterization ◽  
Energy Dispersive Analysis ◽  
X Ray Diffraction ◽  
X Ray ◽  
Scanning Electron

AbstractGadolinium aluminum perovskite (GdAlO3, GAP) is a promising high temperature ceramic material, known for its wide applications in phosphors. Polycrystalline gadolinium aluminum perovskites were synthesized using a precursor of co-precipitate gel of GdAlO3 by employing hydrothermal supercritical fluid technique under pressure and temperature ranging from 150 to 200 MPa and 600 to 700 °C, respectively. The resulted products of GAP were studied using the characterization techniques, such as powder X-ray diffraction analysis (XRD), infrared spectroscopy (IR), scanning electron microscopy (SEM) and energy dispersive analysis of X-ray (EDX). The X-ray diffraction pattern matched well with the reported orthorhombic GAP pattern (JCPDS-46-0395).

scholarly journals Synthesis and Characterization of (Ca,Sr)[C2O4]∙nH2O Solid Solutions: Variations of Phase Composition, Crystal Morphologies and in Ionic Substitutions

Crystals ◽  
2019 ◽  
Vol 9 (12) ◽  
pp. 654 ◽  
Author(s):  
Aleksei V. Rusakov ◽  
Mariya A. Kuzmina ◽  
Alina R. Izatulina ◽  
Olga V. Frank-Kamenetskaya
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Phase Composition ◽  
Solid Solutions ◽  
Synthesis And Characterization ◽  
X Ray Diffraction ◽  
X Ray ◽  
Calcium Oxalates ◽  
Scanning Electron

To study strontium (Sr) incorporation into calcium oxalates (weddellite and whewellite), calcium-strontium oxalate solid solutions (Ca,Sr)[C2O4]∙nH2O (n = 1, 2) are synthesized and studied by a complex of methods: powder X-ray diffraction (PXRD), scanning electron microscopy (SEM) and energy dispersive X-ray (EDX) spectroscopy. Two series of solid solutions, isomorphous (Ca,Sr)[C2O4]·(2.5 − x)H2O) (space group I4/m) and isodimorphous Ca[C2O4]·H2O(sp.gr. P21/c)–Sr[C2O4]·H2O(sp.gr. P 1 - ), are experimentally detected. The morphogenetic regularities of their crystallization are revealed. The factors controlling this process are discussed.

Synthesis and Characterization of Mixed Rare Earths Hydroxide Catalyst

2018 ◽  
Vol 936 ◽  
pp. 53-57
Author(s):  
Bheechanat Duangdee ◽  
Dussadee Rattanaphra ◽  
Anusith Thanapimmetha ◽  
Maythee Saisriyoot ◽  
Penjit Srinophakun
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Rare Earth ◽  
Rare Earths ◽  
Synthesis And Characterization ◽  
X Ray Diffraction ◽  
X Ray ◽  
Co Precipitation ◽  
Scanning Electron

This work presents the synthesis and characterization of mixed rare earths hydroxide heterogeneous catalyst. The catalysts were prepared by co-precipitation of mixed rare earths with NaOH at different pH (6, 7 and 12). The prepared catalysts were characterized by X-ray fluorescence (XRF), X-ray diffraction (XRD) and scanning electron microscopy with energy dispersive X-ray spectroscopy (SEM–EDS). The XRF results showed that the catalyst composed of cerium (Ce), neodymium (Nd), lanthanum (La), praseodymium (Pr) and samarium (Sm) being predominant at pH up to 7. Particularly, cerium (Ce) was favorable precipitation at pH 7. This results were confirm by SEM-EDS. The Ce (OH)3 phase was clearly observed for the mixed rare earth catalyst precipitated at pH 7. The XRF, SEM-EDS and XRD results were consistency.

PENINGKATAN LAJU DISOLUSI ACYCLOVIR DENGAN METODE SISTEM DISPERSI PADAT MENGGUNAKAN POLOXAMER 188

2016 ◽  
Vol 5 (1) ◽  
pp. 6
Author(s):  
Budi Setiawan ◽  
Erizal Zaini ◽  
Salman Umar
Keyword(s):  
Electron Microscopy ◽  
Thermal Analysis ◽  
Scanning Electron Microscopy ◽  
Fourier Transform ◽  
Differential Thermal Analysis ◽  
Fourier Transform Infrared ◽  
X Ray Diffraction ◽  
Poloxamer 188 ◽  
X Ray ◽  
Scanning Electron

Sebuah penelitian tentang sistem dispersi padat dari asiklovir dengan poloxamer 188 telah dilakukan formulasi dengan pencampuran secara fisika dengan rasio 1 : 1, 1 : 3, 1 : 5 dan dispersi padat 1 : 1, 1 : 3, 1 : 5 dan penggilingan 1:1 sebagai pembanding. Dispersi padat dibuat menggunakan metode pencairan (fusi), yang digabung dengan poloxamer 188 pada hotplate kemudian asiklovir dimasukkan ke dalam hasil poloxamer 188 lalu di kocok hingga membentuk masa homogen. Semua formula yang terbentuk termasuk asiklovir poloxamer 188 murni dianalisis karakterisasinya dengan Differential Thermal Analysis (DTA), X-ray Diffraction, Scanning Electron Microscopy (SEM), dan Fourier Transform Infrared (FTIR), kemudian pengambilan dilakukan  (penentuan kadar) mengunakan spektrofotometer UV pada panjang gelombang 257,08 nm dan uji laju disolusi dengan aquadest bebas CO2 menggunakan metode dayung. Hasil pengambilan  (penentuan kadar) menunjukkan bahwa semua formula memenuhi persyaratan farmakope Amerika edisi 30 dan farmakope Indonesia edisi 4 yaitu 95-110%. Sedangkan hasil uji laju disolusi untuk campuran fisik 1: 1, dan dispersi padat 1: 1, dan penggilingan 1: 1 menunjukkan peningkatan yang nyata dibandingkan asiklovir murni. Hal ini juga dapat dilihat dari hasil perhitungan statistik  menggunakan analisis varian satu arah  SPSS 17.

Preliminary Preparation and Characterization Studies of Cellulose from Merbau (Intsia bijuga)

2012 ◽  
Vol 620 ◽  
pp. 314-319
Author(s):  
Nur Amira Mamat Razali ◽  
Fauziah Abdul Aziz ◽  
Saadah Abdul Rahman
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Alkaline Treatment ◽  
Raw Material ◽  
X Ray Diffraction ◽  
X Ray ◽  
Preliminary Preparation ◽  
Characterization Studies ◽  
Scanning Electron

Hardwood is wood from angiosperm trees. The characteristic of hardwood include flowers, endosperm within seeds and the production of fruits that contain the seeds. This paper aims to discuss the preparation and characterization of cellulose obtained from hardwood. The hardwood Merbau (Intsia bijuga) was chosen as raw material in this study. Alkaline treatment and delignification methods were used for the preparation of cellulose. Acid hydrolysis was employed to produce cellulose nanocrystal (CNC). The treated and untreated samples were characterized using x-ray diffraction (XRD) and field emission scanning electron microscopy (FE-SEM). The final product, from both trated and untreated samples were then compared.

Sign in / Sign up

Export Citation Format

Share Document