Abstract
It is well known that the properties of rubbery materials depend upon the speed or rate at which they are tested or used. A considerable body of work has shown that the dynamic properties of rubber change with the time scale of the test and, in particular, at very short times or at very fast rates, the properties approach those of plastics, i.e., high modulus and low elongation. These dynamic properties are measured by oscillation methods, usually at small strains. In contrast to this class of information, where the material is rarely strained to failure, one can also strain rubbers unidirectionally to failure at strain rates that correspond to the high frequencies of dynamic measurements. In linear extension experiments, as the rate of stretching increases tensile strength rises, elongation drops, apparent modulus increases, and relaxation losses may go up or down depending upon the particular rubber and the time scale of the phenomenon that is being investigated. Extrapolating the change in tensile strength with rate of testing suggests that tensile strength as we know it should change drastically when measured at very high rates of speed. That is, since the viscoelastic properties of rubber are time dependent, and also dependent upon the speed at which they are tested, the tensile properties of rubbers measured at room conditions with the ordinary Scott or Instron machines probably do not have the same values as at the speeds and frequencies that might be encountered in such situations as tire wear. Hence, we should like to measure the properties of rubbers at very high rates of speed, presumably comparable to those encountered in tire tread wear, in order to find out how much properties do change as the speed of test is increased. In order to measure stress-strain properties at rates of elongation comparable to those we believe exist in tire tread usage, we had to develop a small high speed tensile machine. The purpose of this paper is to describe that machine and some results obtained with it.
Analysis of automotive fixing plate drawing process
