scholarly journals In vivo orthodontic retainer survival - a review

2015 ◽  
Vol 88 (3) ◽  
pp. 298-303 ◽  
Author(s):  
Anca Victoria Labunet ◽  
Mîndra Badea

AbstractBackground. Relapse following orthodontic treatment is a constant concern of orthodontists. Fixed retention is preferred especially for the lower arch by most orthodontists.Objectives:. This review focuses on in vivo studies. The main objective is to determine the survival rate of different types of retainer: glass-fiber reinforced composite resin, polyethylene or multistrand stainless steel wire bonded to each tooth from canine to canine in the mandibular arch. A second objective is to assess which of these types is less likely to cause additional problems and the third objective is to evaluate the factors that may influence retainer survival.Results and conclusions. There were 8 studies identified that matched the objectives stated. Curent in vivo studies on survival rate take little notice of the role of the material used for bonding of the fixed retainer. It is not possible to draw a conclusion on reliability of new types of retainers glass fiber reinforced composite resin or polyethylene compared to multistrand stainless steel wire. The multistrand wire remains the gold standard for fixed retention.Although it is a logical outcome that retainer survival is dependent on the application technique, there seems to be no research outcome proving that operator experience, moisture control are essential, nor does patient age or sex have statistically proven effects on survival rates.Adequate studies that involve such aspects should be performed.

2008 ◽  
Vol 32 (3) ◽  
pp. 207-210 ◽  
Author(s):  
Priya Subramaniam ◽  
K. Girish Babu ◽  
Raju Sunny

Restoration of primary incisors, which have been severely damaged by early childhood caries or trauma, is a difficult task for the pediatric dentist. With the introduction of new adhesive systems and restorative materials,alternative approaches for treating these teeth have been proposed. Materials: Ten healthy children aged between 3-4 years who had 28 grossly destructed primary maxillary incisors requiring intra canal retention were selected for the study. Following root canal treatment, either a Glass Fiber Reinforced Composite Resin (GFRCR everStick,, Finland) or an omega shaped stainless steel wire were placed as intracanal posts in these teeth. Flowable composite was used for cementation of posts and also to build up the coronal structure using celluloid strip crowns. Both types of intracanal posts were evaluated for retention and marginal adaptation at 1, 6 and 12 months. The data obtained was subjected to statistical analysis. Conclusion:GFRCR intracanal posts showed better retention and marginal adaptation than omega shaped stainless steel wire posts.


RSBO ◽  
2017 ◽  
Vol 13 (3) ◽  
pp. 217 ◽  
Author(s):  
Carla Kuroki Kawamoto Pereira ◽  
Vanara Florêncio Passos ◽  
Sérgio Luís Da Silva Pereira

2020 ◽  
Vol 64 (3) ◽  
pp. 301-306
Author(s):  
Ana C. Cadore-Rodrigues ◽  
Luís F. Guilardi ◽  
Vinicius F. Wandscher ◽  
Gabriel K.R. Pereira ◽  
Luiz F. Valandro ◽  
...  

2008 ◽  
Vol 9 (1) ◽  
pp. 14-21 ◽  
Author(s):  
Sufyan Garoushi ◽  
Pekka K. Vallittu ◽  
Lippo V. J. Lassila

Abstract Aims The purpose of this study was to investigate the reinforcement effect of short E-glass fiber fillers on some mechanical properties of temporary crown and bridge (TCB) composite resin with a semi-interpenetrating polymer network (semi-IPN). Methods and Materials Experimental temporary fiber reinforced (TFC) composite resin was prepared by mixing 15 wt% of short E-glass fibers (3 mm in length) with a 35 wt% of semi-IPN-resin (dual or chemical cure) with 50 wt% of silane treated particulate silica fillers using a high speed mixing device. Temporary crowns (n=6) and test specimens (2 × 2 × 25 mm3) (n=6) were made from the experimental TFC and conventional TCB composite (control, Protemp Garant, 3M-ESPE, St. Paul, MN, USA). A three-point bending test was done according to ISO standard 10477, and a compression loading test was carried out using a steel ball (Ø 3.0 mm) with a speed of 1.0 mm/min until fracture occurred. The degree of monomer conversion (DC%) of both composites was determined by Fourier transfer infrared (FTIR) spectrometry. Results The analysis of variance (ANOVA) revealed both dual and chemical cure experimental TFC composite resins had statistically significant (p<0.05) higher flexural strengths (117 and 99 MPa, respectively) and compressive load-bearing capacity (730 and 623 N, respectively) compared to the control TCB composite resin (72 MPa, 549 N). Conclusion The use of short fiber fillers with semi-IPN polymer matrix yielded an improved mechanical performance compared to a conventional TCB composite resin. Citation Garoushi S, Vallittu PK, Lassila LVJ. Short Glass Fiber-reinforced Composite with a Semi-interpenetrating Polymer Network Matrix for Temporary Crowns and Bridges. J Contemp Dent Pract 2008 January; (9)1:014-021.


Sign in / Sign up

Export Citation Format

Share Document