Modelling of MV and HV Cable Lines

2019 ◽  
Vol 10 (12(36)2019) ◽  
pp. 20-30 ◽  
Author(s):  
Krzysztof DOBRZYNSKI ◽  
◽  
Jacek KLUCZNIK ◽  
Zbigniew LUBOSNY ◽  
◽  
...  
Keyword(s):  
Cable Lines ◽  
Hv Cable

Overvoltage Hazard of the HV Cable Lines

2016 ◽  
Vol 7 (2 (24) 2016) ◽  
pp. 30-42
Author(s):  
Henryk BORYN
Keyword(s):  
Cable Lines ◽  
Hv Cable

Dependence of Current Harmonics of Greenhouse Irradiators on Supply Voltage

2020 ◽  
pp. 85-88 ◽  
Author(s):  
Nadezhda P. Kondratieva
Keyword(s):  
Mathematical Models ◽  
Supply Voltage ◽  
Harmonic Distortion ◽  
Feasibility Studies ◽  
Power Losses ◽  
Voltage Level ◽  
Supply Networks ◽  
Current Harmonics ◽  
Cable Lines ◽  
Harmonic Composition

The article describes the results of the study concerning the effect of the voltage level on current harmonic composition in greenhouses irradiators. It is found that its change affects the level of current harmonics of all types of the studied greenhouse irradiators. With decrease of nominal supply voltage by 10 %, the total harmonic distortion THDi decreases by 9 % for emitters equipped with high pressure sodium lamps (HPSL), by 10 % for emitters with electrode-less lamps and by 3 % for LED based emitters. With increase of nominal supply voltage by 10 %, THDi increases by 23 % for lighting devices equipped with HPSL, by 10 % for irradiators with electrode-less lamps and by 3 % for LED based emitters. Therefore, changes of supply voltage cause the least effect on the level of current harmonics of LED based emitters and then the emitters with electrode-less lamps. Change of the level of supply voltage causes the greatest effect on the level of current harmonics of HPSL based irradiators. Mathematical models of dependence of THDi on the level of supply voltage for greenhouse emitters equipped with LED, electrode-less lamps and HPSL lamps were formulated. These mathematical models may be used for calculations of total current when selecting transformers and supply cable lines for greenhouse lighting devices, for design of new or reconstruction of existing irradiation systems of greenhouse facilities, and for calculation of power losses in power supply networks of greenhouse facilities during feasibility studies for energy saving and energy efficiency increasing projects.

INCREASING THE EFFICIENCY OF CONTOUR SHIELDING OF THE MAGNETIC FIELD OF HIGH-VOLTAGE CABLE LINES

2016 ◽  
Vol 2016 (4) ◽  
pp. 5-7
Author(s):  
V.Yu. Rozov ◽  
◽  
P.N. Dobrodeyev ◽  
A.V. Erisov ◽  
A.O. Tkachenko ◽  
...  
Keyword(s):  
Magnetic Field ◽  
High Voltage ◽  
Cable Lines ◽  
The Magnetic Field

scholarly journals The Power Losses in Cable Lines Supplying Nonlinear Loads

Energies ◽  
2021 ◽  
Vol 14 (5) ◽  
pp. 1374
Author(s):  
Bartosz Rozegnał ◽  
Paweł Albrechtowicz ◽  
Dominik Mamcarz ◽  
Monika Rerak ◽  
Maciej Skaza
Keyword(s):  
Bessel Function ◽  
Cross Section ◽  
Power Loss ◽  
Sine Wave ◽  
Active Power ◽  
New Method ◽  
Power Losses ◽  
Nonlinear Loads ◽  
Current Harmonics ◽  
Cable Lines

This paper presents the skin effect impact on the active power losses in the sheathless single-core cables/wires supplying nonlinear loads. There are significant conductor losses when the current has a distorted waveform (e.g., the current supplying diode rectifiers). The authors present a new method for active power loss calculation. The obtained results have been compared to the IEC-60287-1-1:2006 + A1:2014 standard method and the method based on the Bessel function. For all methods, the active power loss results were convergent for small-cable cross-section areas. The proposed method gives smaller power loss values for these cable sizes than the IEC and Bessel function methods. For cable cross-section areas greater than 185 mm2, the obtained results were better than those for the other methods. There were also analyses of extra power losses for distorted currents compared to an ideal 50 Hz sine wave for all methods. The new method is based on the current penetration depth factor calculated for every considered current harmonics, which allows us to calculate the precise equivalent resistance for any cable size. This research is part of our work on a cable thermal analysis method that has been developed.

scholarly journals The Proposal of a New Tool for Condition Assessment of Medium Voltage Power Cable Lines

Energies ◽  
2021 ◽  
Vol 14 (14) ◽  
pp. 4116
Author(s):  
Krzysztof Siodla ◽  
Aleksandra Rakowska ◽  
Slawomir Noske
Keyword(s):  
Research Work ◽  
Technical Condition ◽  
Power Cable ◽  
Investment Planning ◽  
Medium Voltage ◽  
Cable Network ◽  
Rate Analysis ◽  
Cable Lines ◽  
The Individual ◽  
Service Data

A medium voltage (MV) cable network is a substantial component of the distribution network. Present management of this grid segment is mainly based on the failure rate analysis, i.e., a rise in the number and kind of faults on the actual line means that its technical condition is getting worse. The efficiency of the power system is low and additional costs of repair works, supply interruption, difficulties in the investment planning and operation and maintenance works are necessary. The aim of the R&D works done in the realised project is to implement the management of the MV cable network based on the estimated condition of the individual cable line, obtained from diagnostic measurements. The diagnostic investigations of the cable lines are the reference. Many years of research work have led to the development of the Health Index based on diagnostic, technical and service data.

Sign in / Sign up

Export Citation Format

Share Document