Innovative Application on Dual Oil Producer Completion: Gas Lift for Lower Zone and Natural Flow for Upper Zone Extends Oil Production in Giant Middle Eastern Oil Field

2019 ◽  
Author(s):  
Ernesto Barragan ◽  
Abdul Naser Al Mulla ◽  
Mohamed Bazuhair ◽  
Alaa Alshalabi ◽  
Rachelle Cornwall
2021 ◽  
Author(s):  
Mohammed Ahmed Al-Janabi ◽  
Omar F. Al-Fatlawi ◽  
Dhifaf J. Sadiq ◽  
Haider Abdulmuhsin Mahmood ◽  
Mustafa Alaulddin Al-Juboori

Abstract Artificial lift techniques are a highly effective solution to aid the deterioration of the production especially for mature oil fields, gas lift is one of the oldest and most applied artificial lift methods especially for large oil fields, the gas that is required for injection is quite scarce and expensive resource, optimally allocating the injection rate in each well is a high importance task and not easily applicable. Conventional methods faced some major problems in solving this problem in a network with large number of wells, multi-constrains, multi-objectives, and limited amount of gas. This paper focuses on utilizing the Genetic Algorithm (GA) as a gas lift optimization algorithm to tackle the challenging task of optimally allocating the gas lift injection rate through numerical modeling and simulation studies to maximize the oil production of a Middle Eastern oil field with 20 production wells with limited amount of gas to be injected. The key objective of this study is to assess the performance of the wells of the field after applying gas lift as an artificial lift method and applying the genetic algorithm as an optimization algorithm while comparing the results of the network to the case of artificially lifted wells by utilizing ESP pumps to the network and to have a more accurate view on the practicability of applying the gas lift optimization technique. The comparison is based on different measures and sensitivity studies, reservoir pressure, and water cut sensitivity analysis are applied to allow the assessment of the performance of the wells in the network throughout the life of the field. To have a full and insight view an economic study and comparison was applied in this study to estimate the benefits of applying the gas lift method and the GA optimization technique while comparing the results to the case of the ESP pumps and the case of naturally flowing wells. The gas lift technique proved to have the ability to enhance the production of the oil field and the optimization process showed quite an enhancement in the task of maximizing the oil production rate while using the same amount of gas to be injected in the each well, the sensitivity analysis showed that the gas lift method is comparable to the other artificial lift method and it have an upper hand in handling the reservoir pressure reduction, and economically CAPEX of the gas lift were calculated to be able to assess the time to reach a profitable income by comparing the results of OPEX of gas lift the technique showed a profitable income higher than the cases of naturally flowing wells and the ESP pumps lifted wells. Additionally, the paper illustrated the genetic algorithm (GA) optimization model in a way that allowed it to be followed as a guide for the task of optimizing the gas injection rate for a network with a large number of wells and limited amount of gas to be injected.


2015 ◽  
Author(s):  
O. F. Al-Fatlawi ◽  
M. Al-Jawad ◽  
K. A. Alwan ◽  
A. A. Essa ◽  
D. Sadeq ◽  
...  
Keyword(s):  

2020 ◽  
pp. 120-127
Author(s):  
E. N. Skvortsova ◽  
O. P. Deryugina

The article discusses the results of a study on the selection of wax inhibitors that can be used at the Kondinskoye oil field during transportation and dehydration of the emulsion.Asphaltene precipitation is one of the most serious issues in oil production. The experiment was conducted in order to select the most effective wax inhibitors. We have carried out laboratory tests to choose the most effective wax inhibitor in the conditions of oil production, collection, preparation and external transport systems at the Kondinskoye oil field. Based on the data obtained, wax inhibitor-2, wax inhibitor-4, and wax inhibitor-6 have shown the best results in ensuring the efficiency of inhibition, which should be at least 70 %, and, therefore, they can be allowed to pilot tests. The recommended initial dosage of inhibitors according to the results obtained during pilot tests should be at least 500 g/t of oil.


2016 ◽  
Vol 55 (38) ◽  
pp. 10114-10120 ◽  
Author(s):  
Mariana Carvalho ◽  
Argimiro R. Secchi ◽  
Miguel Bagajewicz

2013 ◽  
Vol 701 ◽  
pp. 440-444
Author(s):  
Gang Liu ◽  
Peng Tao Liu ◽  
Bao Sheng He

Sand production is a serious problem during the exploitation of oil wells, and people put forward the concept of limited sand to alleviate this problem. Oil production with limited sanding is an efficient mod of production. In order to complete limited sand exploitation, improve the productivity of oil wells, a real-time sand monitoring system is needed to monitor the status of wells production. Besides acoustic sand monitoring and erosion-based sand monitoring, a vibration-based sand monitoring system with two installing styles is proposed recently. The paper points out the relationships between sand monitoring signals collected under intrusive and non-intrusive installing styles and sanding parameters, which lays a good foundation for further study and actual sand monitoring in oil field.


2021 ◽  
Author(s):  
A. S. Ramadhan

In the Jambi oil field, sand production can create unattainable production targets and short-lived well lifetime. One function of the Jambi Engineering and Planning Field is to look for solutions to these problems, such as the installation of progressive cavity pumps (PCP) into wells. Although successful, a problem that often arises in PCP wells is sand settling when the PCP is off, for example during electric trips, engine maintenance and repair of flowlines. This settling can lead to a stuck PCP. A recent solution has been to install a Pressure Actuated Relief (PAR) valve, where the tool directs sand deposits out of the tubing to the annulus so that it does not enter the pump. Installation of this tool has increased the average lifetime of sandy wells from 2 months to 6 months, and has increased oil production in these wells by up to 47%.This paper will discuss the successful installation of a PAR Valve into well KTT-08 in the Jambi Field.


2021 ◽  
Author(s):  
Pawan Agrawal ◽  
Sharifa Yousif ◽  
Ahmed Shokry ◽  
Talha Saqib ◽  
Osama Keshtta ◽  
...  

Abstract In a giant offshore UAE carbonate oil field, challenges related to advanced maturity, presence of a huge gas-cap and reservoir heterogeneities have impacted production performance. More than 30% of oil producers are closed due to gas front advance and this percentage is increasing with time. The viability of future developments is highly impacted by lower completion design and ways to limit gas breakthrough. Autonomous inflow-control devices (AICD's) are seen as a viable lower completion method to mitigate gas production while allowing oil production, but their effect on pressure drawdown must be carefully accounted for, in a context of particularly high export pressure. A first AICD completion was tested in 2020, after a careful selection amongst high-GOR wells and a diagnosis of underlying gas production mechanisms. The selected pilot is an open-hole horizontal drain closed due to high GOR. Its production profile was investigated through a baseline production log. Several AICD designs were simulated using a nodal analysis model to account for the export pressure. Reservoir simulation was used to evaluate the long-term performance of short-listed scenarios. The integrated process involved all disciplines, from geology, reservoir engineering, petrophysics, to petroleum and completion engineering. In the finally selected design, only the high-permeability heel part of the horizontal drain was covered by AICDs, whereas the rest was completed with pre-perforated liner intervals, separated with swell packers. It was considered that a balance between gas isolation and pressure draw-down reduction had to be found to ensure production viability for such pilot evaluation. Subsequent to the re-completion, the well could be produced at low GOR, and a second production log confirmed the effectiveness of AICDs in isolating free gas production, while enhancing healthy oil production from the deeper part of the drain. Continuous production monitoring, and other flow profile surveys, will complete the evaluation of AICD effectiveness and its adaptability to evolving pressure and fluid distribution within the reservoir. Several lessons will be learnt from this first AICD pilot, particularly related to the criticality of fully integrated subsurface understanding, evaluation, and completion design studies. The use of AICD technology appears promising for retrofit solutions in high-GOR inactive strings, prolonging well life and increasing reserves. Regarding newly drilled wells, dedicated efforts are underway to associate this technology with enhanced reservoir evaluation methods, allowing to directly design the lower completion based on diagnosed reservoir heterogeneities. Reduced export pressure and artificial lift will feature in future field development phases, and offer the flexibility to extend the use of AICD's. The current technology evaluation phases are however crucial in the definition of such technology deployments and the confirmation of their long-term viability.


Sign in / Sign up

Export Citation Format

Share Document