A High-Frequency Surface Wave Radar Simulation Using FMCW Technique for Ship Detection

Indonesia is an archipelagic country with a vast sea area. This vast sea area becomes a challenge in conducting regional surveillance to maintain maritime conditions. The use of buoys and satellites still has shortcomings in carrying out surveillance despite its excellent surveillance capabilities. A high-frequency radar technology with 3-30 MHz frequency and surface wave propagation are very suitable because it has a radar range that can cross the horizon or commonly refer to as Over the Horizon (OTH). The Frequency Modulated Continuous Wave (FMCW) technique on this radar obtains distance and velocity information by a continuously transmitted frequency modulation. The use of radar in Indonesia for marine surveillance is still infrequent. Therefore, it is relatively difficult to conduct testing and obtain data. In addition, the direct examination requires extended time, so a simulation program is needed. This paper discusses the design of a High-Frequency Surface Wave Radar (HFSWR) simulation program using FMCW modulation technique. The simulation program detected two objects based on time delays due to the distance and velocity of the object with a maximum range of 350 km. It displayed the results in an informative manner. The object detection was based on the results of the Fast Fourier Transform (FFT) from the mixed signals. The mixed signal is a combination of transmitted signal and reflected signal in which there are time delay components due to the object. The simulation program had been tested with input values of distance and velocity that vary, both for one object and two objects, in the radial direction. It generated output that was close to the input value with a level of accuracy of ± 2 km.

Download Full-text

MIMO High Frequency Surface Wave Radar Using Sparse Frequency FMCW Signals

International Journal of Antennas and Propagation ◽

10.1155/2017/7514916 ◽

2017 ◽

Vol 2017 ◽

pp. 1-16 ◽

Cited By ~ 2

Author(s):

Mengguan Pan ◽

Baixiao Chen

Keyword(s):

Surface Wave ◽

High Frequency ◽

Continuous Wave ◽

Multiple Input Multiple Output ◽

Mimo Radar ◽

Large Bandwidth ◽

Wave Radar ◽

Multiple Input ◽

Input Multiple Output ◽

Processing Framework

The heavily congested radio frequency environment severely limits the signal bandwidth of the high frequency surface wave radar (HFSWR). Based on the concept of multiple-input multiple-output (MIMO) radar, we propose a MIMO sparse frequency HFSWR system to synthesize an equivalent large bandwidth waveform in the congested HF band. The utilized spectrum of the proposed system is discontinuous and irregularly distributed between different transmitting sensors. We investigate the sparse frequency modulated continuous wave (FMCW) signal and the corresponding deramping based receiver and signal processor specially. A general processing framework is presented for the proposed system. The crucial step is the range-azimuth processing and the sparsity of the carrier frequency causes the two-dimensional periodogram to fail when applied here. Therefore, we introduce the iterative adaptive approach (IAA) in the range-azimuth imaging. Based on the initial 1D IAA algorithm, we propose a modified 2D IAA which particularly fits the deramping processing based range-azimuth model. The proposed processing framework for MIMO sparse frequency FMCW HFSWR with the modified 2D IAA applied is shown to have a high resolution and be able to provide an accurate and clear range-azimuth image which benefits the following detection process.

Download Full-text