Electrophysical properties of mixtures of mineral oil and synthetic ester dielectric liquid

2021 ◽  
Vol 14 (2) ◽  
pp. 132-141
Author(s):  
M. N. Lyutikova ◽  
S. M. Korobeynikov ◽  
A. A. Konovalov
Keyword(s):  
Dielectric Loss ◽  
Breakdown Voltage ◽  
Loss Tangent ◽  
Dielectric Loss Tangent ◽  
Kinematic Viscosity ◽  
Mineral Oil ◽  
Flash Point ◽  
Power Transformers ◽  
Synthetic Ester ◽  
Insulating Properties

Power transformers are key equipment in power generation, transmission, and distribution systems. The reliability of power transformers is based on the performance of the insulation system, which includes solid cellulose insulation and a liquid dielectric. Modern power engineering requires liquid insulation to have excellent insulating properties, high fire resistance, and biodegradability. Mineral oil that has been in use for over 100 years does not meet certain requirements. Therefore, various methods of enhancing the insulating properties of the oil are currently being considered, including mixing it with other liquid dielectrics, which have excellent properties. Synthetic and natural esters are considered as alternative fluids.This article discusses the possibility of enhancing the insulating characteristics of mineral oil with a high content of aromatic hydrocarbons (for example, T-750 oil) by mixing it with synthetic ester Midel 7131. Assessment is given of insulating parameters of the resulting mixtures with an ester fraction in mineral oil from 0% to fifty%. The main characteristics of the mixtures are described, such as density, kinematic viscosity, flash point, dielectric loss tangent, relative dielectric permittivity, breakdown voltage, and moisture content. It is shown that with an increase in the proportion of ester, some parameters of the obtained insulating liquid improve (flash point, dielectric constant, breakdown voltage), while values of other parameters (density, kinematic viscosity, dielectric loss tangent) with an ester content of more than 10% in the mixture do not meet the requirements for mineral oils.

Effect of Water on Electrical Properties of Refined, Bleached, and Deodorized Palm Oil (RBDPO) as Electrical Insulating Material

2013 ◽  
Vol 64 (4) ◽  
Author(s):  
Nazera Ismail ◽  
Yanuar Z. Arief ◽  
Zuraimy Adzis ◽  
Shakira A. Azli ◽  
Abdul Azim A. Jamil ◽  
...  
Keyword(s):  
Electrical Properties ◽  
Breakdown Voltage ◽  
Palm Oil ◽  
Pour Point ◽  
Electrical Breakdown ◽  
Dissipation Factor ◽  
Mineral Oil ◽  
Flash Point ◽  
Effect Of Water ◽  
Insulating Liquid

This paper describes the properties of refined, bleached, deodorized palm oil (RBDPO) as having the potential to be used as insulating liquid. There are several important properties such as electrical breakdown, dielectric dissipation factor, specific gravity, flash point, viscosity and pour point of RBDPO that was measured and compared to commercial mineral oil which is largely in current use as insulating liquid in power transformers. Experimental results of the electrical properties revealed that the average breakdown voltage of the RBDPO sample, without the addition of water at room temperature, is 13.368 kV. The result also revealed that due to effect of water, the breakdown voltage is lower than that of commercial mineral oil (Hyrax). However, the flash point and the pour point of RBDPO is very high compared to mineral oil thus giving it advantageous possibility to be used safely as insulating liquid. The results showed that RBDPO is greatly influenced by water, causing the breakdown voltage to decrease and the dissipation factor to increase; this is attributable to the high amounts of dissolved water.

Method of calculating the dielectric loss tangent of binary systems

1987 ◽  
Vol 52 (3) ◽  
pp. 310-312
Author(s):  
G. N. Dul'nev ◽  
D. P. Volkov ◽  
M. V. Dobrochasov
Keyword(s):  
Dielectric Loss ◽  
Loss Tangent ◽  
Dielectric Loss Tangent ◽  
Binary Systems

scholarly journals Dielectric and electrical properties of Cr substituted Mg ferrites

2015 ◽  
Vol 39 (1) ◽  
pp. 1-12 ◽  
Author(s):  
AKM Zakaria ◽  
Faizun Nesa ◽  
MA Saeed Khan ◽  
SM Yunus ◽  
NI Khan ◽  
...  
Keyword(s):  
Dielectric Constant ◽  
Dielectric Loss ◽  
Loss Tangent ◽  
Dielectric Loss Tangent ◽  
Lattice Parameter ◽  
Activation Energies ◽  
X Ray Diffraction ◽  
Constant E ◽  
Cr Concentration ◽  
Academy Of Sciences

The spinel ferrites MgCrxFe2-xO4 (0.0 ? × ?1.0) were prepared through the solid state reaction using conventional ceramic method at 1300°C in air. The homogeneous phase of the ferrite samples was observed from the X-ray diffraction study. Lattice parameter of the samples was found to decrease with increasing Cr concentration in the system obeying Vegard’s law. The ac electrical resistivity, measured as a function of temperature, decreases with the increase of temperature indicating the semiconducting nature of all the samples. The activation energies were calculated and found to decrease with increasing Cr content. The lower activation energies are associated with higher electrical conductivity. With the increase of temperature, dielectric constant (e`) and dielectric loss tangent are observed to be increased; while with the increase of frequency, dielectric constant (e`) and dielectric loss tangent decrease for all the samples.Journal of Bangladesh Academy of Sciences, Vol. 39, No. 1, 1-12, 2015

Multipurpose Nonwoven Viscose/Polypropylene Fabrics: Effect of Fabric Characteristics and Humidity Conditions on the Volume Electrical Resistivity and Dielectric Loss Tangent

2020 ◽  
Vol 21 (10) ◽  
pp. 2407-2416
Author(s):  
Koviljka A. Asanovic ◽  
Dragana D. Cerovic ◽  
Mirjana M. Kostic ◽  
Tatjana V. Mihailovic ◽  
Aleksandra M. Ivanovska
Keyword(s):  
Electrical Resistivity ◽  
Dielectric Loss ◽  
Loss Tangent ◽  
Dielectric Loss Tangent

scholarly journals In-situ measurement of electric current and dielectric loss tangent during vulcanisation of nitrile rubber.

1998 ◽  
Vol 71 (5) ◽  
pp. 281-285 ◽  
Author(s):  
Toyohiko GONDOH ◽  
Yukiko MATSUOKA ◽  
Michiharu TOH ◽  
Daisaburo OKAI ◽  
Tetsuo MORI
Keyword(s):  
Dielectric Loss ◽  
Electric Current ◽  
Loss Tangent ◽  
Dielectric Loss Tangent ◽  
Nitrile Rubber ◽  
In Situ Measurement

Dielectric loss tangent of sapphire single crystal produced by edge-defined film-fed growth method

2002 ◽  
Vol 377 (3) ◽  
pp. 313-318 ◽  
Author(s):  
M. Kusunoki ◽  
M. Inadomaru ◽  
S. Ohshima ◽  
K. Aizawa ◽  
M. Mukaida ◽  
...  
Keyword(s):  
Dielectric Loss ◽  
Single Crystal ◽  
Loss Tangent ◽  
Dielectric Loss Tangent ◽  
Growth Method ◽  
Sapphire Single Crystal

scholarly journals Dielectric Behavior of Dysprosium Substituted Magnesium Ferrite

2018 ◽  
Vol 15 (1) ◽  
pp. 48-54
Author(s):  
Jeevan S. Ghodake
Keyword(s):  
Dielectric Constant ◽  
Dielectric Loss ◽  
Powder Diffraction ◽  
Loss Tangent ◽  
Dielectric Loss Tangent ◽  
Dielectric Behavior ◽  
Complex Dielectric Constant ◽  
Frequency Variation ◽  
Magnesium Ferrite ◽  
X Ray

Dysprosium substituted Magnesium ferrite weresuccessfully prepared by chemical combustion method. The as synthesized powder was presintered in air at 6000C for 1hr and finally sintered at 9500C for 1hr. From X-ray powder diffraction pattern of MgDy0.03Fe1.97O4, confirmed formation of single phase cubic spinel structure. The value of crystallite size obtained from X-ray powder diffraction (311) peak , it is found to be 46.38nm.The frequency and temperature variation of dielectric parameters such as real dielectric constant (ε′), complex dielectric constant (ε") and dielectric loss tangent (tanδ) were determined using Hioki LCR - Q meter. The frequency variation of dielectric constant shows a normal dielectric behavior of spinel ferrites. The dielectric loss tangent with frequency shows similar behavior as dielectric constant. The dielectric constant and dielectric loss tangent increases with increase in temperature

Sign in / Sign up

Export Citation Format

Share Document