EFFECT OF INTERFACE RHEOLOGY ON DROP COALESCENCE IN WATER-OIL EMULSION

2020 ◽  
Author(s):  
talita botti ◽  
Marcio CARVALHO ◽  
Erick Quintella
Keyword(s):  
Oil Emulsion ◽  
Drop Coalescence

Modeling of Phenomena of Drop Coalescence in oil Emulsion Breaking Processes

2018 ◽  
Vol 54 (2) ◽  
pp. 158-165 ◽  
Author(s):  
G. I. Kelbaliev ◽  
S. R. Rasulov ◽  
G. R. Mustafaeva
Keyword(s):  
Oil Emulsion ◽  
Drop Coalescence

Effectiveness of Cod Liver Oil Emulsion as An Anti-Hyperuricemic Agent in Mice

2019 ◽  
Author(s):  
Stefiani Emasurya Indrajaya ◽  
◽  
Andreanus A. Soemardji ◽  
Siti Fara Rahmawati ◽  
◽  
...  
Keyword(s):  
Cod Liver Oil ◽  
Oil Emulsion

Separation of Water-Oil Emulsion Using Polyethersulfone Membranes Treated With High-Frequency Low-Temperature Plasma

2019 ◽  
Vol 23 (3) ◽  
pp. 746-754
Author(s):  
Dinar Dilshatovich Fazullin ◽  
Gennady Vitalievich Mavrin ◽  
Vladislav Olegovich Dryakhlov ◽  
Ildar Gilmanovich Shaikhiev ◽  
Irek Rashatovich Nizameyev
Keyword(s):  
Low Temperature ◽  
High Frequency ◽  
Low Temperature Plasma ◽  
Temperature Plasma ◽  
Oil Emulsion

Deemulsification of Water-in-Oil Emulsion with Sludges

1987 ◽  
Vol 22 (3) ◽  
pp. 437-443 ◽  
Author(s):  
N. Kosaric ◽  
Z. Duvnjak
Keyword(s):  
Activated Sludge ◽  
Room Temperature ◽  
Petroleum Refinery ◽  
Treatment Plant ◽  
Granular Sludge ◽  
Activated Sludge Process ◽  
Sludge Treatment ◽  
Oil Emulsion ◽  
Water In Oil Emulsion ◽  
Aerobic Sludge

Abstract Aerobic sludge from a municipal activated sludge treatment plant, sludge from a conventional municipal anaerobic digester, aerobic sludge from an activated sludge process of a petroleum refinery, and granular sludge from an upflow sludge blanket reactor (USBR) were tested in the deemulsification of a water-in-oil emulsion. All sludges except the last one, showed a good deemulsification capability and could he used for a partial deemulsification of such emulsions. The rate and degree of the deemulsifications increased with an increase in sludge concentrations. The deemulsifications were faster at 85°C and required smaller amounts of sludge than in the case of the deemulsifications at room temperature. An extended stirring (up to a certain limit) in the course of the dispersion of sludge emulsion helped the deemulsification. Too vigorous agitation had an adverse effect. The deemulsification effect of sludge became less visible with an increase in the dilution of emulsion which caused an increase in its spontaneous deemulsification.

Destruction of water-in-oil emulsions in electromagnetic fields in a dynamic mode

2012 ◽  
Vol 9 (1) ◽  
pp. 110-115
Author(s):  
L.A. Kovaleva ◽  
R.R. Zinnatullin ◽  
V.N. Blagochinnov ◽  
A.A. Musin ◽  
Yu.I. Fatkhullina ◽  
...  
Keyword(s):  
Dielectric Properties ◽  
Radio Frequency ◽  
Electromagnetic Fields ◽  
Dynamic Mode ◽  
Droplet Dynamics ◽  
Oil Emulsion ◽  
Numerical Studies ◽  
Em Field ◽  
Oil Emulsions ◽  
Water In Oil Emulsion

Some results of experimental and numerical studies of the influence of radio-frequency (RF) and microwave (MW) electromagnetic (EM) fields on water-in-oil emulsions are presented. A detailed investigation of the dependence of the dielectric properties of emulsions on the frequency of the field makes it possible to establish the most effective frequency range of the EM influence. The results of water-in-oil emulsion stability in the RF EM field depending on their dielectric properties are presented. The effect of the MW EM field on the emulsion in a dynamic mode has been studied experimentally. In an attempt to understand the mechanism of emulsion destruction the mathematical model for a single emulsion droplet dynamics in radio-frequency (RF) and microwave (MW) electromagnetic fields is formulated.

Demulsification of a Water-in-crude Oil Emulsion with a Corn Oil BasedDemulsifier using the Response Surface Methodology: Modelling and Optimization

2021 ◽  
Vol 14 ◽  
Author(s):  
Abed Saad ◽  
Nour Abdurahman ◽  
Rosli Mohd Yunus
Keyword(s):  
Response Surface Methodology ◽  
Crude Oil ◽  
Water Content ◽  
Response Surface ◽  
Separation Efficiency ◽  
Corn Oil ◽  
Oil Emulsion ◽  
Optimal Values ◽  
Input Variables ◽  
Oil Emulsions

: In this study, the Sany-glass test was used to evaluate the performance of a new surfactant prepared from corn oil as a demulsifier for crude oil emulsions. Central composite design (CCD), based on the response surface methodology (RSM), was used to investigate the effect of four variables, including demulsifier dosage, water content, temperature, and pH, on the efficiency of water removal from the emulsion. As well, analysis of variance was applied to examine the precision of the CCD mathematical model. The results indicate that demulsifier dose and emulsion pH are two significant parameters determining demulsification. The maximum separation efficiency of 96% was attained at an alkaline pH and with 3500 ppm demulsifier. According to the RSM analysis, the optimal values for the input variables are 40% water content, 3500 ppm demulsifier, 60 °C, and pH 8.

Selective and ultrafast agglomeration of chalcopyrite by a water in oil emulsion binder

2021 ◽  
Vol 167 ◽  
pp. 106900
Author(s):  
G. Sahasrabudhe ◽  
G. DeIuliis ◽  
J. Davy ◽  
K.P. Galvin
Keyword(s):  
Oil Emulsion ◽  
Water In Oil Emulsion
Sign in / Sign up

Export Citation Format

Share Document