Software simulation enables design engineers to have a better picture of possible structural failure behaviour and determine the accuracy of a design before the actual structural component is fabricated. Finite element analysis is used to simulate the behaviour of the reinforced concrete beam under the flexural test. During the flexural test, results are recorded for both simulation and experimental tests. By comparing the results, beam displacement, crack patterns, and failure modes can be studied with better accuracy. The accuracy percentage for yield load and ultimate load between the two tests results were 94.12 % and 95.79 %, respectively, whereas the accuracy percentage for elastic gradient before the yielding stage was 81.08 %. The behaviour between simulation and laboratory models described is based on crack pattern and failure mode. The progression of von Mises (VM) stresses highlighted the critical areas of the reinforced concrete beam and correlation between the experimental specimen, in terms of flexural cracks, shear cracks, yielding of tension reinforcement, and the crushing of concrete due to compressive stress. This paper concludes that simulation can achieve a significant accuracy in terms of loads and failure behaviour compared to the experimental model.
Finite element analysis of bending performance of basalt fiber reinforced concrete beam
