Effect of thermomechanical treatment on the microstructures and mechanical properties of an ultrafine grained steel using bainite starting microstructure

2019 ◽  
Vol 110 (6) ◽  
pp. 517-523
Author(s):  
Reza Gostariani ◽  
Ahmad Kermanpur ◽  
Abbas Najafizadeh
Keyword(s):  
Mechanical Properties ◽  
Thermomechanical Treatment ◽  
Ultrafine Grained ◽  
Microstructures And Mechanical Properties ◽  
Ultrafine Grained Steel

Mechanical Nanocrystallization Surface Treatment on the Reheated 400MPa Ultrafine Grained Steel

2009 ◽  
Vol 79-82 ◽  
pp. 377-380
Author(s):  
Hong Yun Zhao ◽  
Guo Dong Wang ◽  
Chun Hua Xu ◽  
Feng Yuan Shu
Keyword(s):  
Mechanical Properties ◽  
Surface Treatment ◽  
Room Temperature ◽  
Performance Testing ◽  
Surface Form ◽  
Test Results ◽  
Ultrafine Grained ◽  
Before And After ◽  
Different Temperatures ◽  
Ultrafine Grained Steel

After reheated at different temperatures for 5 minutes, the 400MPa Ultrafine Grained Steel specimens were air-cooled to room temperature, and then carried out the mechanical nanocrystallization surface treatment and structure performance testing. On the basis of comparing the test results on the specimens before and after the mechanical nanocrystallization surface treatment, the process of mechanical nanocrystallization was analyzed briefly. The results show that: as the reheating temperature rising, the trend of grain size growing increases markedly, and the mechanical properties also drop down to different degrees; when the reheating temperature is around 800°C, because of the pearlite spheroidized significantly, its mechanical properties drop the most seriously; after the mechanical nanocrystallization surface treatment, not only its surface form a layer of fine nano-layer (about 100 nm) structure, but also its mechanical properties rise obviously, and the yield strength is over 450MPa.

Microstructure and Properties of Ti Rods Produced by Multi-Step SPD

2006 ◽  
Vol 503-504 ◽  
pp. 763-768 ◽  
Author(s):  
V.V. Latysh ◽  
Irina P. Semenova ◽  
G.H. Salimgareeva ◽  
I.V. Kandarov ◽  
Yuntian T. Zhu ◽  
...  
Keyword(s):  
Mechanical Properties ◽  
Grain Size ◽  
Yield Stress ◽  
Equal Channel Angular Pressing ◽  
Thermomechanical Treatment ◽  
Ultrafine Grained Structure ◽  
Annealed State ◽  
Angular Pressing ◽  
Ultrafine Grained ◽  
Cp Ti

This paper studies the effect of combined SPD treatment on microstructure and mechanical properties of semi-products out of CP Ti. The combined processing, consisting of equal-channel angular pressing and further thermomechanical treatment, produced ultrafine-grained rods out of Grade 2 CP Ti with a diameter of 6.5 mm and a length of up to 1 m. It was established that the formation of homogeneous ultrafine-grained structure in Ti rod with α-grain size of about 100 nm allowed to enhance yield stress by 200% in comparison with initial annealed state.

Sign in / Sign up

Export Citation Format

Share Document