scholarly journals Experimental Tests and Aeroacoustic Simulations of the Control of Cavity Tone by Plasma Actuators

2017 ◽  
Vol 7 (8) ◽  
pp. 790 ◽  
Author(s):  
◽  
◽  
2016 ◽  
Vol 2016.26 (0) ◽  
pp. 109
Author(s):  
Makoto KUSUMOTO ◽  
Hideo MORISHIMA ◽  
Hiroshi YOKOYAMA ◽  
Akiyoshi IIDA
Keyword(s):  

2014 ◽  
Vol 2014 (0) ◽  
pp. _S0550306--_S0550306-
Author(s):  
Hideo MORISHIMA ◽  
Hiroshi YOKOYAMA ◽  
Akiyoshi IIDA
Keyword(s):  

2011 ◽  
Author(s):  
Charles E. Lance ◽  
Richard P. DeShon ◽  
Eugene Stone-Romero

2000 ◽  
Vol 627 ◽  
Author(s):  
M. E. Swanson ◽  
M. Landreman ◽  
J. Michel ◽  
J. Kakalios

ABSTRACTWhen an initially homogeneous binary mixture of granular media such as fine and coarse sand is poured near the closed edge of a “quasi-two-dimensional” Hele-Shaw cell consisting of two vertical transparent plates held a narrow distance apart, the mixture spontaneously forms alternating segregated layers. Experimental measurements of this stratification effect are reported in order to determine which model, one which suggests that segregation only occurs when the granular material contained within a metastable heap between the critical and maximum angle of repose avalanches down the free surface, or one for which the segregation results from smaller particles becoming trapped in the top surface and being removed from the moving layer during continuous flow. The result reported here indicate that the Metastable Wedge model provides a natural explanation for the initial mixed zone which precedes the formation of the layers, while the Continuous Flow model explains the observed upward moving kink of segregated material for higher granular flux rates, and that both mechansims are necessary in order to understand the observed pairing of segregated layersfor intermediate flow rates and cell separations.


1979 ◽  
Vol 7 (1) ◽  
pp. 31-39
Author(s):  
G. S. Ludwig ◽  
F. C. Brenner

Abstract An automatic tread gaging machine has been developed. It consists of three component systems: (1) a laser gaging head, (2) a tire handling device, and (3) a computer that controls the movement of the tire handling machine, processes the data, and computes the least-squares straight line from which a wear rate may be estimated. Experimental tests show that the machine has good repeatability. In comparisons with measurements obtained by a hand gage, the automatic machine gives smaller average groove depths. The difference before and after a period of wear for both methods of measurement are the same. Wear rates estimated from the slopes of straight lines fitted to both sets of data are not significantly different.


Sign in / Sign up

Export Citation Format

Share Document