scholarly journals Monte Carlo-Based Comprehensive Assessment of PV Hosting Capacity and Energy Storage Impact in Realistic Finnish Low-Voltage Networks

Energies ◽  
2018 ◽  
Vol 11 (6) ◽  
pp. 1467 ◽  
Author(s):  
Ammar Arshad ◽  
Verner Püvi ◽  
Matti Lehtonen
Keyword(s):  
Monte Carlo ◽  
Energy Storage ◽  
Low Voltage ◽  
Comprehensive Assessment

Low-voltage EDS of magnesium ferrite Dendrites in a FEG-SEM

1996 ◽  
Vol 54 ◽  
pp. 478-479
Author(s):  
Matthew T. Johnson ◽  
Ian M. Anderson ◽  
Jim Bentley ◽  
C. Barry Carter
Keyword(s):  
Monte Carlo ◽  
Quantitative Analysis ◽  
Monte Carlo Simulations ◽  
Cross Section ◽  
Spatial Resolution ◽  
Low Voltage ◽  
Magnesium Ferrite ◽  
X Ray ◽  
Interaction Volume ◽  
Ferrite Spinel

Energy-dispersive X-ray spectrometry (EDS) performed at low (≤ 5 kV) accelerating voltages in the SEM has the potential for providing quantitative microanalytical information with a spatial resolution of ∼100 nm. In the present work, EDS analyses were performed on magnesium ferrite spinel [(MgxFe1−x)Fe2O4] dendrites embedded in a MgO matrix, as shown in Fig. 1. spatial resolution of X-ray microanalysis at conventional accelerating voltages is insufficient for the quantitative analysis of these dendrites, which have widths of the order of a few hundred nanometers, without deconvolution of contributions from the MgO matrix. However, Monte Carlo simulations indicate that the interaction volume for MgFe2O4 is ∼150 nm at 3 kV accelerating voltage and therefore sufficient to analyze the dendrites without matrix contributions.Single-crystal {001}-oriented MgO was reacted with hematite (Fe2O3) powder for 6 h at 1450°C in air and furnace cooled. The specimen was then cleaved to expose a clean cross-section suitable for microanalysis.

scholarly journals The LVRT Control Scheme for PMSG-Based Wind Turbine Generator Based on the Coordinated Control of Rotor Overspeed and Supercapacitor Energy Storage

Energies ◽  
2021 ◽  
Vol 14 (2) ◽  
pp. 518
Author(s):  
Xiangwu Yan ◽  
Linlin Yang ◽  
Tiecheng Li
Keyword(s):  
Energy Storage ◽  
Wind Turbine ◽  
Low Voltage ◽  
Specific Capacity ◽  
Coordinated Control ◽  
Input Power ◽  
Voltage Sags ◽  
Rotor Speed ◽  
Control Scheme ◽  
Supercapacitor Energy Storage

With the increasing penetration level of wind turbine generators (WTGs) integrated into the power system, the WTGs are enforced to aid network and fulfill the low voltage ride through (LVRT) requirements during faults. To enhance LVRT capability of permanent magnet synchronous generator (PMSG)-based WTG connected to the grid, this paper presents a novel coordinated control scheme named overspeed-while-storing control for PMSG-based WTG. The proposed control scheme purely regulates the rotor speed to reduce the input power of the machine-side converter (MSC) during slight voltage sags. Contrarily, when the severe voltage sag occurs, the coordinated control scheme sets the rotor speed at the upper-limit to decrease the input power of the MSC at the greatest extent, while the surplus power is absorbed by the supercapacitor energy storage (SCES) so as to reduce its maximum capacity. Moreover, the specific capacity configuration scheme of SCES is detailed in this paper. The effectiveness of the overspeed-while-storing control in enhancing the LVRT capability is validated under different levels of voltage sags and different fault types in MATLAB/Simulink.

scholarly journals Using Energy Storage Inverters of Prosumer Installations for Voltage Control in Low-Voltage Distribution Networks

Energies ◽  
2021 ◽  
Vol 14 (4) ◽  
pp. 1121
Author(s):  
Rozmysław Mieński ◽  
Przemysław Urbanek ◽  
Irena Wasiak
Keyword(s):  
Energy Storage ◽  
Control Strategy ◽  
Reactive Power ◽  
Low Voltage ◽  
Storage System ◽  
Distribution Networks ◽  
Energy Storage System ◽  
Voltage Regulation ◽  
Active Power ◽  
Total Power

The paper includes the analysis of the operation of low-voltage prosumer installation consisting of receivers and electricity sources and equipped with a 3-phase energy storage system. The aim of the storage application is the management of active power within the installation to decrease the total power exchanged with the supplying network and thus reduce energy costs borne by the prosumer. A solution for the effective implementation of the storage system is presented. Apart from the active power management performed according to the prosumer’s needs, the storage inverter provides the ancillary service of voltage regulation in the network according to the requirements of the network operator. A control strategy involving algorithms for voltage regulation without prejudice to the prosumer’s interest is described in the paper. Reactive power is used first as a control signal and if the required voltage effect cannot be reached, then the active power in the controlled phase is additionally changed and the Energy Storage System (ESS) loading is redistributed in phases in such a way that the total active power set by the prosumer program remains unchanged. The efficiency of the control strategy was tested by means of a simulation model in the PSCAD/EMTDC program. The results of the simulations are presented.

MULTI UNITS OF SINGLE PHASE DISTRIBUTED GENERATION COMBINED WITH BATTERY ENERGY STORAGE FOR PHASE POWER BALANCING IN DISTRIBUTION NETWORK

2016 ◽  
Vol 78 (10-4) ◽  
Author(s):  
Amirullah Amirullah ◽  
Mochamad Ashari ◽  
Ontoseno Penangsan ◽  
Adi Soeprijanto
Keyword(s):  
Energy Storage ◽  
Single Phase ◽  
Low Voltage ◽  
Distribution Network ◽  
Battery Energy Storage ◽  
Current Harmonics ◽  
Line Current ◽  
Distributed Generators ◽  
Distribution Line ◽  
Battery Energy

Randomly installed distributed generators (DGs) in households may cause unbalanced line current in a distribution network. This research presents a battery energy system for balancing of line current in a distribution network involving multi units of single phase photovoltaic (PV) distributed generators (DGs). In this paper, the PV generators were simulated consisting of a buck-boost DC/DC converter and single phase DC/AC inverter. It was connected to the distribution line through the low voltage 220 volt 50 Hz. The proposed phase balancing system uses battery energy storage and three single phase bidirectional inverters. The inverter is capable of injecting current or absorbing power from the line to the battery. This inverter operation is arranged to balance each distribution line separately, as well as to improve other power quality parameters, such as voltage and current harmonics. Simulation results show that the system was capable of improving the unbalanced line current from 15.59 % to 11, 48 % and unbalanced line voltage from 1.76 % to 0.58 %. The system was able for increasing current harmonics from 0.98 % to 1.03% and voltage harmonics from 38.96% to 39.08%.

The Study of Energy Storage Technology Application in Wind Power Integration

2013 ◽  
Vol 391 ◽  
pp. 261-264
Author(s):  
Xiao Ning Xu ◽  
Xue Song Zhou
Keyword(s):  
Energy Storage ◽  
Wind Power ◽  
Large Scale ◽  
Low Voltage ◽  
System Stability ◽  
Technology Application ◽  
Wind Power Integration ◽  
Advantages And Disadvantages ◽  
Storage Technology ◽  
Energy Storage Technology

The classification and application range of energy storage technology are briefly introduced. Challenges for large-scale wind power integration are summarized. With regard to the problems in system stability, low voltage ride-through ability of wind the turbine generator, and power quality, the paper elaborated some solutions based on energy storage technology, and analyzed their advantages and disadvantages. With the character of energy storage technology combined, the paper put forward some advice of energy storage technology applying in wind power integration.

scholarly journals An Overview of Bidirectional AC-DC Grid Connected Converter Topologies for Low Voltage Battery Integration

2018 ◽  
Vol 9 (3) ◽  
pp. 1223 ◽  
Author(s):  
Kaspars Kroics ◽  
Oleksandr Husev ◽  
Kostiantyn Tytelmaier ◽  
Janis Zakis ◽  
Oleksandr Veligorskyi
Keyword(s):  
Energy Storage ◽  
High Efficiency ◽  
Low Voltage ◽  
Renewable Energy Sources ◽  
Storage System ◽  
Distribution Grid ◽  
Battery Energy Storage ◽  
Battery Energy Storage Systems ◽  
Converter Topologies ◽  
Battery Energy

<p>Battery energy storage systems are becoming more and more popular solution in the household applications, especially, in combination with renewable energy sources. The bidirectional AC-DC power electronic converter have great impact to the overall efficiency, size, mass and reliability of the storage system. This paper reviews the literature that deals with high efficiency converter technologies for connecting low voltage battery energy storage to an AC distribution grid. Due to low voltage of the battery isolated bidirectional AC-DC converter or a dedicated topology of the non isolated converter is required. Review on single stage, two stage power converters and integrated solutions are done in the paper.</p>

Sign in / Sign up

Export Citation Format

Share Document